明渠湍流床面附近跃移层面颗粒浓度垂线分布

本文以动理学理论的Boltzmann方程为基础，考虑明渠湍流床面附近猝发喷射和清扫运动对跃移层内运动颗粒的不同作用，分析了明渠中泥沙颗粒浓度垂线分布问题，得到了适用于包括跃移层、悬移层在内的统一浓度垂线分布公式。文中着重研究了跃移层内运动颗粒的浓度垂线分布，并将本文结果与实测跃移层内浓度垂线分布及实测跃移层顶部浓度进行了对比，结果表明理论与实验两者符合较好。     

应用计算机实现选矿自动化

本文就太钢尖山铁矿计算机控制系统的硬件构成，顺控系统的软件编制、模拟调试以及现场调试等方面展开论述。     

电解法烟道气二氧化硫在线监测系统的设计

介绍了一种烟道气中SO2在线检测系统，该系统可以实现24h不间断地监测烟道气中SO2的体积分数和质量浓度，同时将信息经网络传送给环保有关部门，具有一定的新颖性、可靠性、准确性。     

Rhizobium trifolii capsular polysaccharide: a novel biopolymer with striking physical properties

The physical properties of the capsular polysaccharide of Rhizobium Trifolii (CPS) were investigated. Viscosity measurements provided information about the hydrodynamic volume of single coils, the perturbation of solvent flow and the shear-thinning behaviour of concentrated solutions. Changes in chain geometry and the development of an intermolecular network as a function of temperature were monitored using the techniques of optical rotation and dynamic oscillation. Finally, analysis of calorimetric thermograms elucidated the type of interactions between CPS and the bacterial levan. Overall, the Rhizobium polysaccharide was found to form thermally-reversible gels at an extremely low 'minimum critical gelling concentration' (c_o∼ 0.35gl^-1). At temperatures above the gel melting point (∼ 48°C), however, the compact polymer coils entangled at comparatively high concentrations (about 60 times higher than c_o). In the presence of a highly branched levan, the thermal stability of ordered CPS structures increased as a consequence of thermodynamic incompatibility between the two polymers.     

转向柱管承载能力的试验研究

在分析转向柱管花键部位应力集中情况的基础上,通过对某厂生产的转向柱管扭转破坏的试验研究,得到如下结论:①转向柱管的承载能力与其外花键齿与方向盘中心内花键齿之间的非接触区长度有关,以花键端部过渡圆弧的直径大小为宜;②安装方向盘总成时所施加在安装螺母上的拧紧力矩在70N.m左右时,转向柱管的承载能力最大。     

Influence of Coherent Flow Structures on the Dynamics of Suspended Sediment Transport in Open-Channel Flow

The influence of suspended sediments on coherent flow structures has been studied by simultaneously measuring the longitudinal and vertical components of the instantaneous velocity vector and the instantaneous suspended particle concentration with an acoustic particle flux profiler. The measurements were carried out in clear water and in particle-laden open-channel flows. In both cases, they clearly show the predominance of ejection and sweep phases that are part of a burst cycle. The analysis further demonstrates the importance of the ejection and sweep phases in sediment resuspension and transport. Ejections pick up the sediment at the bed and carry it up through the water column close to the surface. It is shown that ejections and sweeps are in near equality in the near-bottom layer, whereas ejections clearly dominate in the remaining water column. The implications of these results for sediment transport dynamics are discussed.     

Procedure for Measuring Low Concentrations of H2 and H2S Above a Water Surface

A simple measuring procedure for low concentrations of H₂ and H₂S (at the level of ppm fractions) above the surface of water by using sensitive gas analyzers is suggested. The procedure is easily accomplished in conditions outside the laboratory (under field conditions).     

Increasing the corrosion resistance of equipment due to the use of film-forming amines

Results of a study of tube specimens cut from hot-water boilers show that film-forming octadecyl amine (ODA) used in the process of preservation removes deposition from the surface of the metal. An ODA film is preserved on the surface after repeated washing of the latter with hot water. The concentration of chlorides at the surface of the metal after treatment with ODA is lower than before the treatment. __________ Translated from élektricheskie Stantsii, No. 11, November 2005, pp. 15–18.     

Stress Concentration Factors for a Circular Hole in Curved Beams Under Bending Loads

Abstract: As a contribution to the field of stress concentration studies, the case of circular hole in curved bar elements under bending is hereby studied. Trend values of stress concentration factors (SCF) are presented based on selected variables of the problem for two critical hole locations. The results will help to identify an SCF law for practical use by applying the statistical method of regression analysis. Two approximations obtained by means of computational methods are compared with those obtained by photoelastic experimental method.     

The rate of corrosion of concrete reinforcement and possibilities of its mathematical modelling

The paper describes a method for the mathematical modelling of steel reinforcement corrosion rate. This method is based exclusively on experimental results and expression of the influence of significant corrosion factors in the form of functional relations. The method takes into account the reality of the effects of corrosion factors, their contigency and complexity, and various circumstances occurring in practice. It represents one way towards the development of methods for the prediction of service life of reinforced concrete and structures.