110kV变电站35kV高压系统边运行边改造实践

对宣钢供电系统110kV变电站35kV高压系统边运行边施工改造经验进行了分析探讨。指出选用优良的设备、制定周密的安全措施，能够确保施工、运行安全。     

变压器绝缘电阻低于允许值的处理

本文就一台主变压器绝缘电阻低于“规程”允许值的问题，进行了原因分析，提出了简易的处理方法，取得了较好效果，同时提出了几个值得探讨的问题，对提高变压器的安全运行水平有一定的现实意义。     

超高、大跨度混凝土结构模板施工

本文通过工程实例,详细介绍了超高、大跨度混凝土结构模板及支撑施工工艺。     

安全高效矿井监控关键技术研究

提出安全高效矿井应采用先进可靠的监控技术,实现供电、排水、通风、压风、运输、提升、瓦斯抽采等固定岗位无人值守和地面远程控制,综采、综放等采煤工作面少人作业和地面远程控制;提出供电、排水、通风、压风、运输、提升、瓦斯抽采等监控系统应具有地面远程控制功能;提出具有远程控制、报警联动、调度指挥等功能的煤矿调度指挥控制中心;提出整合计算机网络机房、程控交换机机房、调度交换机机房、监控系统机房等的数据中心;提出基于煤层瓦斯压力和瓦斯含量、综合指标、钻屑瓦斯解吸指标、复合指标、R值指标、瓦斯涌出量(根据瓦斯体积分数和风量计算)、巷道位置、微震、地音、温度等及其变化的煤与瓦斯突出预警方法;提出基于WiFi的矿用无线传输接口,以便于互通互联;提出通过分布式光纤测温预警煤炭自然发火,较通过监测CO等煤炭自然发火标志气体更直接、更及时、更可靠;提出根据运煤量实时调整输送带速度:当煤量较小时降低输送带运行速度,当煤量较大时提高输送带运行速度,以提高运输效率,减少设备磨损;提出基于光纤综合保护的供电监控系统具有防越级跳闸、地面远程整定和地面远程控制功能,提高了煤矿供电的可靠性,可实现煤矿井下机电硐室无人值守;提出具有煤岩识别与滚筒自动调高,采煤机、刮板机、液压支架3机联动,记忆割煤,地面远程、顺槽近程、手动控制和紧急停机,放顶煤量和煤矸控制,采煤机和刮板机等大型机电设备故障诊断等功能的采煤工作面监控系统。     

煤矿井下采掘设备隔爆兼本安型电气控制箱的本安设计

针对煤矿井下采掘设备防爆兼本安型电气控制箱内本安电路与非本安电路并存、非本安电路的能量可能会窜入本安电路而影响本安电路防爆及本安性能的问题,从结构设计和电气隔离两方面介绍了煤矿井下采掘设备隔爆兼本安型电气控制箱的本安设计方法,给出了电气间隙、爬电距离、绝缘及耐压、接线端子、本安布线、电源变压器、本安隔离栅印制板等结构布置方法以及RS485通信隔离电路、模拟量隔离电路、压频变换电路、电阻信号隔离电路、开关量隔离电路、继电器隔离电路等电气隔离措施。应用表明,采用该方法设计的煤矿井下采掘设备隔爆兼本安型电气控制箱安全可靠,维护简便,能够满足煤矿井下的防爆要求。     

Parametric study of the electrical to thermal power conversion in an inductively coupledrf plasma torch

An inductively coupled (ic) radio-frequency (rf) stabilized argon plasma was generated in a quartz tube using a 7 MHzrf generator. The electrical and thermal powers were measured and the efficiency of energy conversion was computed. The results indicate that for a constant power input, there is an optimum argon flow rate for which maximum energy conversion efficiency occurs.     

Transistors made in laser recrystallized polysilicon on insulator films

lpcvd polycrystalline silicon films were deposited on thermally oxidized silicon as well as onlpcvd silicon nitride deposited on silicon. Acw argon ion laser was used to recrystallize the polysilicon film into large grains (grain size from 5μm to 40μm). Boron was then implanted and standard N-channel silicon gate process and N-channel metal gate process were carried out to realisemosfets on this material. Channel mobilities upto 450 cm²/V-sec for electrons have been measured. This thin filmmosfet has a four-terminal structure with a top and a bottom gate and the influence of one gate on the drain current due to the other gate has been investigated. Comparison of theI _D v-V _D curves of the devices with physical models was found in good agreement.     

Radiation-induced modification of polyurethane with hydroxyethyl methacrylate: blood compatibility

An attempt is made to develop the hydrophilic grafting of polyether urethane urea with hydroxyethyl methacrylate (hema) using⁶⁰Coγ-irradiation for achieving optimum hydrophilic/hydrophobic property needed towards blood compatibility. Contact angle method and platelet adhesion from calf’s blood are used to determine the suitability of these modified surfaces.     

X-ray spectroscopy and local structures in glasses

X-ray spectroscopy which is a combination of two techniques, namely x-ray absorption near edge structure (xanes) and extended x-ray absorption fine structure (EXAFS) analyses, is a unique technique for the study of local structures in glasses. Availability of synchrotron radiation sources has made the technique quite attractive and useful because the photon flux from synchrotrons is very intense and polarized. In this article, a brief summary ofxanes andEXAFS techniques is given along with a few applications to the study of local structures in glasses. Communication No. 323 from Solid State and Structural Chemistry Unit.     

Planning for the Subernarekha river system in eastern India

The study describes the systems studies carried out to plan a river basin in order to determine the nature and size of water storage facilities and releases for irrigation and industrial uses, and the associated cropping pattern. The model has been formulated in the framework of a linear programming model for a specific target year. This model is developed in the context of planning the Subernarekha river basin. The results are discussed and these provide information and insight suggesting the need for more disaggregated analysis of interaction between irrigation and related agroeconomic parameters.