Fe-Si droplets associated with graphite on blast furnace coke

Fe-Si droplets on the surface of blast furnace (BF) coke from 25 to 50 cm at the tuyere level are mostly composed of Fe3Si, which has various shapes (round, elongated, and irregular) and penetration degrees into the BF coke matrix. The shapes and penetration degrees may depend on the saturation of molten iron by silicon during interaction with the coke matrix. The droplets are covered by a tiny shell of carbon. Graphite observed inside the droplets can be divided into two categories: well-formed tabular crystals with relatively large size and flakes with structures similar as those in cast iron. The textures of the droplets reflect composition, interaction with the coke matrix, and cooling conditions.     

Pressure-impulse diagram with multiple failure modes of one-way reinforced concrete slab under blast loading using SDOF method

Two loosely coupled single degree of freedom (SDOF) systems were used to model the flexural and direct shear responses of one-way reinforced concrete slabs subjected to explosive loading. Blast test results show that the SDOF systems are accurate in predicting the failure mode of the slab under blast loads by incorporating the effects of the strain rate effect caused by rapid load application. Based on different damage criteria, pressure-impulse (P-I) diagrams of the two failure modes were analyzed with the SDOF systems. The effects of span length, concrete strength, and reinforcement ratio of the slab on the P-I diagram were also investigated. Results indicate that a slab tends to fail in direct shear mode when it is of a smaller span length and tends to fail in flexure mode when it is of a larger span length. With the increase of the concrete strength or reinforced ratio, both the flexure and shear capacity increase. Based on numerical results, a simplified method and a semi analytical equation for deriving the P-I diagram are proposed for different failure modes and damage levels.     

足球视频镜头分类方法

根据视频语义分析和视频摘要等应用对于视频数据结构化的需求,提出了一种针对足球视频的镜头分类方法.通过logo模板匹配检测并定位出视频中的慢镜头,对其余的正常比赛部分做镜头边界检测完成视频切分.基于分块的思想,对正常比赛镜头帧计算其各块的场地像素比率值作为特征,利用SVM分类器将正常比赛镜头分为远镜头、中镜头、球员特写或场外镜头3类.至此,整个视频流可以表示为结构化的四类镜头类型标示序列.实验结果表明,该方法在视频切分和镜头类型识别的准确性方面具有良好的效果.     

武器爆炸条件下冲击波与弹片共同作用数值模拟分析

研究武器爆炸条件下弹片与冲击波共同作用的规律。给出数值分析的计算假定,分别对爆炸产物弹片及冲击波的运动规律进行分析。对现行计算公式进行了简化推导,所得计算公式与防护工程计算中的现行公式相比,简洁且反映实际情况。分析结论能够方便地确定武器爆炸后空气冲击波和弹片作用到结构物上的前后次序及相应的时间差,为研究冲击波和弹片对结构物的复合作用提供了依据。数值算例表明所给算法是有效的。     

Influence of cement type on transport properties and chemical degradation: Application to nuclear waste storage

The geological repository of nuclear waste in concrete containers is a possible storage method explored by ANDRA (Agence Nationale pour la gestion des Déchets RadioActifs). The concrete must display a high confinement capacity for long periods, characterized by low transport properties and by the acido-basic buffer of hydrated cement. During service life, these properties can be endangered by chemical attack of underground water. The cement type has an important influence on the concrete's performances. Then, it is essential to establish appropriate mixtures with accurate components. In this work an ordinary Portland cement and a fly ash and blast furnace slag blended cement are compared. To determine confinement capacities, transfer properties and mortars microstructure were investigated. To predict the long term behaviour, an ammonium nitrate test has been developed to enhance decalcification and to accelerate hydrolysis of cementitious materials. Measurement of degraded depth with time regarding calcium content was carried out. Impact of decalcification on transport properties was evaluated. Fly ash and blast furnace slag provide better properties for native mortars, and more particularly diffusion properties, but not as much as necessary to limit leaching in degraded material by chemical attack.     

Influence of surface condition on the fatigue behaviour of specimens made of a SAE 5115 case-hardened steel

The effect of different surface conditions on the fatigue properties of cyclically loaded bending specimens of the case‐hardened steel SAE 5115 (Material Number 1.7131) was investigated. The aim of the investigations was to achieve further knowledge of the processes that finally lead to the failure of case‐hardened and cyclically loaded bending specimens. Surface roughness, microstructure and residual stress distribution were regarded as parameters that govern the fatigue process. On the basis of a well‐defined adjustment of different surface conditions the effect of internal oxidation, surface roughness and residual stresses on fatigue crack initiation and growth were assessed. The effect of different parameters on the endurance limit has been quantified by the application of a fracture mechanics and a weakest‐link approach. The calculations contributed to a deeper insight into the complex interaction between the parameters governing the fatigue process.     

爆炸冲击的激光多普勒远距离测量技术的研究

利用激光多普勒效应和数字信号处理方法,获取爆炸冲击过程中的高速变形参数,以此作为对爆炸强度分析的依据。根据爆炸变形的特点,设计了外差式纵向激光多普勒测量系统,提出了相应的数字滤波和频谱分析的信号处理方法,实现了爆炸变形的动态测量。系统测量的位移量程为±30mm,速度量程为-10~+20m/s,测量距离为4.5m。与振动台的试验对比,位移测量相对误差小于1%。给出了圆筒钢制爆炸容器在300gTNT当量炸药爆炸过程中弹性变形的测量结果。     

Characteristics of Metal Droplets in Slag Tapped from the Blast Furnace

Slag samples, hot‐metal samples and hot‐metal temperatures were obtained during tapping of two blast furnaces. Sampling was carried out at different time points during tapping of three separate heats. The size distribution and composition of metal droplets found in the slag were determined using scanning electron microscopy. Only metal droplets above 0.75 μm could be counted and analysed. All droplets were below 8 μm in diameter and the great majority of these droplets were found to be between 0.75 and 2 μm. The size distribution did not differ significantly for different slag samples. Iron was the main droplet component. Electron probe microanalysis showed that the droplets contained small amounts of carbon. The percentage of the area in a studied cross‐section that was covered with metal droplets varied between 0.01 and 0.07%. Calculations based on Stoke's law showed that the distance droplets travel in the slag is in the micron range. Slag samples taken in the beginning of slag tapping contained more droplets than those taken in the middle of slag tapping, an indication that most droplets can be found in the area near the furnace wall. Some droplets were determined to have magnesium enrichment at the external surface.     

提高高炉清循环冷却水系统浓缩倍数的对策研究

通过对宝钢1号高炉清循环冷却水系统的质能平衡测试和理论分析计算,找出了清循环水系统浓缩倍数偏低的真正原因,并提出了相应的技术措施,所做工作对同类系统有重要的指导意义。