Active set truncated-Newton algorithm for simultaneous optimization of distillation column

An active set truncated-Newton algorithm (ASTNA) is proposed to solve the large-scale bound constrained sub-problems. The global convergence of the algorithm is obtained and two groups of numerical experiments are made for the various large-scale problems of varying size. The comparison results between ASTNA and the subspace limited memory quasi-Newton algorithm and between the modified augmented Lagrange multiplier methods combined with ASTNA and the modified barrier function method show the stability and effectiveness of ASTNA for simultaneous optimization of distillation column.     

变形温度和变形程度对Ti－31合金性能和组织的影响

通过高温和室温拉伸试验，研究了变形温度和变形程度对Ｔｉ－３１合金板材性能和组织的影响。结果表明，合金在７５０～８５０℃的温度下变形５％～２０％空冷后，其室温机械性能均能达到材料的技术指标要求。并发现了材料在９００℃的临界变形区。     

电磁胀形磁场力的有限元分析

研究电磁胀形过程中工件受到的磁压力沿长度方向和厚度方向的分布是工件变形分析的基础。采用有限元方法对电磁胀形过程中作用工件上的磁场力进行了数值模拟。在磁场特性理论分析的基础上确立了模型的边界条件，得到了磁场力沿工件长度和厚度方向的分布规律。模拟结果与测量值基本吻和。     

冷成型模具低温锌系磷化

研制出适用于冷成型模具高硬度表面的低温锌系磷化工艺。其中磷化液含Zn(H2 PO4 ) 2 ·2H2 O 6 0g/L ,Zn(NO3) 2 ·6H2 O 90g/L ,NaNO2 1.5g/L ,稀土促进剂 0～ 1.0g/L ,游离酸度 4～ 6点 ,总酸度 70～ 75点。该磷化液在 4 0℃下 ,处理 30～ 4 0min后可获得厚约 10 μm的磷化膜。性能测试表明 ,其减摩、润滑性能良好 ,摩擦系数约降 0 .1,与未处理试样相比磨损量下降 96 % ,附着力 1级。     

短模型上的明渠非恒定流试验

水工整体模型试验中,明渠非恒定流至今大多被简化为恒定流,而效果有时并不理想。本文指出,只要设置固定式曲线尾门,并有必要的动态量测设备,便可模拟原型非恒定流;即使模型偏短,也能得出比恒定流试验更接近原型的成果。在同一模型上,既做恒定流试验,又进行必要的非恒定流试验,二者相辅相成,必将有助于试验水平的提高。作为例证,本文介绍了泄洪调度导致航道水面波动的一项试验成果,并以岩基冲刷、通航水流条件、围堰过水、河床冲淤等研究课题为例,讨论了采用“短模型非恒定流试验方式”的必要性与可行性。     

Recrystallization/precipitation behaviour in microalloyed steels

Microalloyed high-strength low-alloy (HSLA) steels contain additions of Nb, V, Ti, or in combination, in amounts of 0.01 to 0.1 weight percent to improve mechanical properties, which are strongly dependent on the thermomechanical interaction taking place in the course of rolling mill processes. The recrystallizatian of hat-twisted austenite has been investigated in a cylindrical specimen (f 6×50 mm) machined from hat rolled plates of 0,052 wt % Niobium microalloyed steel. Continuous and interrupted torsion test were carried out in the temperature range 1123 K to 1173 K after a solution treatment of 1.5 minutes at 1423 K and torque-twist data were analysed. The various methods were discussed for obtaining results from torsion tests. The effect of precipitation kinetics was appreciated by way of connection t_p/t_p(red), where t_p is the experimental measured time for the peak stress and t_p(red) is the newly defined reduced time. The softening ratio X and time t_0.05R for start of static recrystallization were established.

The correlation between precipitation and recrystallization is presented as a graphs for chosen requirements (temperature of austenitization, carbon and niobium content and strain rate). If temperature goes below 850°C, the restoration processes are hardly suppressed, both are limited by diffusion and Nb(CN) precipitation, which are extended dynamically in the range of strains rates 10⁻² to 1 s⁻¹.

In the present paper, an attempt is made to derive the PRTT diagram and to define all mathematical equations for describing recrystallization times t_0.05R, t_0.5R, t_0.95R and t_0.05P for the start of precipitation. In real metal forming processes such as the hot rolling of plates or strips the knowledge of these parameters and results is extremely important for the the correct microstructure and sheet quality to be obtained.     

在教学中推行微型化学实验势在必行

微型化学实验是当今化学教学中的重要变革之一。本文简单介绍了微型化学实验的特点和当前国内外发展的概况，倡议在我省的化学中尽快推行微型化学实验     

阵列天线在OFDM系统下行链路中的应用

正交频分多址(OFDM:orthogonal frequency division multiplexing)技术由于其在多径环境下克服码间干扰的固有特点,在移动通信中已得到广泛地应用。利用阵列天线上行链路信号到达角估计实时信息,计算OFDM系统下行链路阵列天线权重,将阵列天线应用于下行链路中,最后给出系统误码率性能的计算机仿真结果。     

内外齿复合冷挤压成型实验研究

通过对轿车转向盘毂件内外齿进行的复合挤压实验研究 ,得到了新式复动式复合挤压模具结构 ,并确定了一种合理的成型工艺方案     

Electro‐optical transfer function preferences for LCD TVs: The effect of display brightness and surround illumination on preferred gamma

Abstract— Recent commercial liquid‐crystal‐display (LCD) televisions are larger and brighter than traditional televisions, thus impacting the viewing conditions in which they are viewed. These changes in viewing conditions may require different electro‐optical transfer functions (EOTFs) for LCD TVs than those for conventional TVs. Here, the way various EOTFs affect the preferred image quality of test images with changes in brightness and surround illumination conditions are examined. The first method used a gain, offset, and gamma (GOG) function with a range of gamma values, and the second method altered the intrinsic EOTFs. Image preference for the simulated EOTFs was determined using a paired‐comparison experiment for ten images. The first experiment took place in a darkened room at two display luminance levels. The results indicated that a gamma of 1.6 was most preferred overall although more so at a lower screen luminance level. In a second experiment, the procedure was repeated with a dim surround of 10% of the display's white point. With this surround, preference for a gamma value of around 1.6 at both screen luminance levels was more enhanced. These results indicated that image preference for different EOTFs is dependent on display luminance and that this dependence is maintained with a dim surround.