分流液压转向牵引计算的展开图及其应用

本文论及分流液压转向牵引计算的概念,方法及其展开图,并且提供了计算机绘制的展开图和应用实例。     

An analytical expression for the power coefficient of an ideal horizontal-axis wind turbine

The paper shows that an analytical evaluation of the power coefficient C_p for an ideal horizontal-axis wind turbine can be made via an expression giving the direct relationship of C_p and the axial induction factor a. The results obtained agree closely with those obtained numerically from the usual integral expression involving several variables.     

核医学成像技术中计算机的应用

由于计算机和核医学的结合,各种成像方法的计算机化医学图像层析技术正在迅速发展,并开始广泛应用。本文介绍各类成像技术中计算机的应用,特别评述其最近进展,并提出了今后的展望。     

Lifetime control in silicon power P-i-N diode by ion irradiation: Suppression of undesired leakage

The irradiation with high-energy (7.35 MeV) protons through a set of energy degraders was used to suppress leakage of the silicon power diodes subjected to local lifetime control. The aim was to modify the profile of recombination centers and to reduce production of vacancy complexes. The high-energy proton irradiation was compared with standard local lifetime killing by high-energy alphas. Recombination centers arising from irradiation were characterized after irradiation and subsequent annealing at 220 and 350 °C by deep level transient spectroscopy and I-V profiling. Static and dynamic parameters of irradiated diodes were also measured and compared. Results show that the applied irradiation with protons provides 3-10 times lower leakage compared to standard alphas for equivalent reduction of the reverse recovery current maximum. On the other hand, the excessive formation of hydrogen donors at high proton fluences and their diffusion during annealing at 350° decreases diode blocking capability.     

Magnetic Resonance Visualisation of Flow and Pore Structure in Packed Beds with Low Aspect Ratio

Different NMR techniques were combined to obtain the structure and velocity information for a systematic investigation of fixed beds with low aspect ratio (tube diameter to particle diamter, d_t/d_p) in the range 1.4 to 32. The structure of the void space was determined for a variety of packed beds of glass beads or regular and irregular porous pellets by magnetic resonance imaging (MRI). Based on the images the radial distribution of the voids within the bed was obtained. Ordering effects were found even for non‐spherical and polydisperse particles, and a maximum of the fluid density near the tube wall was confirmed for all pellet geometries and sizes. By combining MRI with velocity encoding, velocity profiles and distributions of flow velocity components of a single fluid phase through packed beds have been acquired. The radial velocity distribution follows an oscillatory pattern which largely reflects the ordering of the particles, which can be accessed from the density distribution of the interparticle fluid. Maximum velocities of up to four times the average value were found to occur near the tube wall. This wall effect was observed for all but the smallest particles, where the aspect ratio was d_t/d_p = 32. Moreover, a visualisation of flow pattern in the presence of packed particles was achieved by using a tagging technique, and the stationary flow field could be identified for an experimental time of several hours.     

A new voltage control equipment using fuzzy inference

Power system control equipment needs higher sensitivity and operational reliability. Advanced voltage control equipment is needed for reducing the frequency of tap changes and improving the characteristics (the relationship between the actual voltage and reference voltage) of the voltage to meet today's power system requirements. However, these objectives are in a trade-off relationship. Studies of voltage control derived from a knowledge base suitable for electric power systems can satisfy these objectives using fuzzy inference. Compared with corresponding conventional equipment, the new equipment improved the deviation of 30 min average voltage of 30 percent. This paper describes the design concept of new voltage control equipment using fuzzy inference. In addition, field test results are described along with rules of fuzzy inference, membership functions, and the deviation of 30 min average voltage through detailed simulation.     

回转窑供电装置改造

本阐述了回转窑供电装置存在的缺陷，亦即改造过程和改造后的效果。     

Laboratory simulated slipstream testing of novel sulfur removal processes for gasification application

The Wabash River Integrated Methanol and Power Production from Clean Coal Technologies (IMPPCCT) project is investigating an Early Entrance Coproduction Plant (EECP) concept to evaluate integrated electrical power generation and methanol production from coal and other carbonaceous feedstocks. Research, development and testing (RD&T) that is currently being conducted under the project is evaluating cost effective process systems for removing contaminants, particularly sulfur species, from the generated gas which contains mainly synthesis gas (syngas), CO₂ and steam at concentrations acceptable for the methanol synthesis catalyst. The RD&T includes laboratory testing followed by bench-scale and field testing at the SG Solutions Gasification Plant located in West Terre Haute, Indiana. Actual synthesis gas produced by the plant was utilized at system pressure and temperature for bench-scale field testing.