HCl氧化物MOS结构质子辐照诱导的界面陷阱效应

用微分电容法研究质子辐照HCl氧化物铝栅MOS结构诱导的界面陷阱,栅氧化层在1 160℃很干燥的、含0～10％HCl的气氛中热生长而成,质子辐照能量为120～300keV,注入总剂量范围为8×10~(13)～1×10~(16)p/cm~2。结果表明,辐照诱导的界面陷阱能级密度随质子能量、剂量增加而增加。然而,氧化层中掺入6％HCl时,辐照诱导的界面陷阱明显减少。这样,已能有效地改变MOS器件的抗辐照性能。实验结果可用H~+二级过程解释。     

Low surface energy films based on partially fluorinated isocyanates: the effects of curing temperature

Self-stratification strategy can be used to prepare films in which both bulk and surface properties can be optimized. By using this approach, only a very small quantity of fluorinated species is needed to generate a surface with low surface energy. When cross-linking is involved during film formation, we are dealing with a competition behavior between the diffusion of fluorinated species and the formation of cross-linked network. In this study low surface energy polymeric films were prepared on the basis of partially fluorinated polyisocyanates, in combination with hydroxyl-end-capped three-armed solventless liquid oligoesters and modified hyperbranched polyesters. At a fluorine concentration of only 0.5 wt.%, contact angles of water and hexadecane can reach 120° and 80°, respectively. A surface energy as low as 10–15 mN/m can be obtained upon the addition of less than 1 wt.% of fluorine in the films. It was shown, from real time ATR-FTIR and contact angle measurements, that the curing temperatures demonstrated significant effects on the cross-linking rate as well as on the wettability of the films.     

剂量率对聚四氟乙烯辐射裂解的影响

本文研究了在以电子加速器的电子射线为辐射源时,剂量率对PTFE辐射裂解的影响。在剂量相同的条件下,剂量率从1.44×10~4 rad/s增至5.75×10~4 rad/s,裂解效率提高3.3倍。剂量率和各断裂参数(单位剂量裂解度a_0,G(s)值等)均成线性关系。当裂解度一定时,剂量率与剂量成反变关系。     

Computer modeling of the continuous annealing furnace

A computer program to calculate the strip temperature heated in the continuous annealing furnace was developed, using the zone method for radiative heat transfer analysis with the measured gas temperature in the furnace. Using theF _E Operator, the present study considered the effects of soot and transient species, in addition to the H₂O−CO₂ gas mixture on the gas radiative heat transfer. The predicted strip temperature distribution forF _E=1.05 represented well the measured data. The maximum difference in the heat flux transfered to the strip from the combustion gas forF _E=1.0 (without soot and transient species gas radiation) and 1.05 (with soot and transient species gas radiation) was about 15%. The present study also investigated the effects of line speed and thickness variations on the strip temperature, establishing the bases for the on-line computer model.     

Effect of 8 MeV electron irradiation on electrical properties of CuInSe2 thin films

Radiation damages due to 8 MeV electron irradiation in electrical properties of CuInSe₂ thin films have been investigated. The n-type CuInSe₂ films in which the carrier concentration was about 3×10¹⁶ cm⁻³, were epitaxially grown on a GaAs(0 0 1) substrate by RF diode sputtering. No significant change in the electrical properties was observed under the electron fluence <3×10¹⁶ e cm⁻². As the electron fluence exceeded 10¹⁷ e cm⁻², both the carrier concentration and Hall mobility slightly decreased. The carrier removal rate was estimated to be about 0.8 cm⁻¹, which is slightly lower than that of III–V compound materials.     

Multiwalled Nanotubes: Their Formation by Irradiating Graphite with High Doses of Electrons

We report the production of carbon nanotubes by high dose of electron irradiation. The irradiation was performed with a 2 MeV Van de Graaff accelerator, while the irradiation conditions were the following: voltage 1.3 MeV, current 5 µA, dose rate 25 kGy/min, and total dosage 1000 kGy. The samples were analyzed in a high-resolution transmission electron microscope. The main features observed on the samples, were huge nanotubes of several nanometer long and few nanometer wide, which are capped at one end. It is good to point out, that at this level of irradiation, we were not able to find either onion-like or particle structures throughout the material, as it is usual in similar hexagonal structures. This behavior could be attributed to the level of irradiation used to create the nanotubes under investigation.     

旋转式伽玛刀的辐射剂量学

旋转式伽玛刀的辐射剂量学指标的物理测试在放射性医疗设备投放医院正式临床使用前是必不可少的，是对设备及其附件的设计、加工制造、安装以及电气控制系统等的全面综合性检定。用电离室作辐射剂量学的绝对测量，用胶片法进行相对测量，给出了测量结果并进行了讨论。     

环境放射化学研究中几个问题的讨论

本文从辐射环境保护和公众辐射防护的角度，讨论了放射性核素在环境中的迁移行为，放射性核素与环境介质的相互作用和放射性核素在环境中的形态等涉及到环境放射化学研究方向的问题，并讨论了它们之间相互依存的关系。     

一种8毫米波变张角,半径突变多模圆锥馈源

我们研制了一种8毫米波变张角、半径突变的多模圆锥馈源。计算出其模比并推导出其辐射方向图公式;给出其在两个主平面——E平面与H平面上的辐射方向图和波束场分布特性的测试结果以及电压驻波比VSWR的测量结果;同时给出频带和旁瓣特性。分析与测试共同表明,在34.5GHz～37GHz频带里,该多模馈源的辐射图在大于24dB范围内获得幅度等化且不出现旁瓣,因此具有一定的应用价值。     

大爆炸宇宙学模型一些主要观测事实及其讨论

本文用近代物理学有关理论讨论了大爆炸宇宙学模型的一些主要观测事实，如哈勃定律，宇宙微波背景辐射、氦的丰度等问题，尝试对大爆炸宇宙学模型双观测事实到理论作一个初步地描述。