油田放射性作业人员外周血淋巴细胞染色体畸变的观察

本文调查了油田212例受γ射线和中子混合辐射照射的作业人员和30例正常人的外周血淋巴细胞染色体畸变。作业人员受γ射线照射的人均年受照剂量为1.28mGy。调查结果表明,放射性测井人员与正常人相比染色体畸变率有显著差异。     

MODELING LIQUID MASS TRANSFER IN HIGEE SEPARATION PROCESS

Correspondence concerning this paper should be addressed to Professor Richard S.H. Mah. Hsien-Hsin Tung is now affiliated with Department of Chemical Engineering, California Institute of Technology

Penetration theory is used to describe the liquid mass transfer in Higee separation process. Within a possible range of effective areas, it is shown that the predicted mass transfer coefficients are in reasonable agreement with the estimated mass transfer coefficients. The estimated coefficients were calculated from the experimental data and the possible effective areas. Hence it is concluded the penetration theory is generally applicable to describe liquid mass transfer in Higee separation process. The comparison also suggests that liquid mixing at the junctions of packing materials may be more complete in Higee process than in traditional process.     

纳米ZnO薄膜制备及液态源掺杂

用真空蒸发法在玻璃和单晶硅片 (10 0 )上制备Zn薄膜 ,然后对Zn薄膜进行氧化、热处理获得纳米ZnO薄膜。对在硅片上制备的Zn薄膜一次性进行高温掺杂、氧化获得纳米ZnO∶P和ZnO∶B薄膜。研究不同氧化、掺杂温度和时间对薄膜结构、电学性能的影响。结果表明 :氧化温度和时间对ZnO薄膜结构影响较大 ,液态源掺P可明显改善纳米ZnO薄膜的导电性能、结构特性和化学组分     

Synthesis and Spectral Properties of Mixed-Ligand Complexes of Lanthanide Perchlorate with Bis-(phenylsulfinyl)ethane and Organic Lewis Bases

ＳｙｎｔｈｅｓｉｓａｎｄＳｐｅｃｔｒａｌＰｒｏｐｅｒｔｉｅｓｏｆＭｉｘｅｄＬｉｇａｎｄＣｏｍｐｌｅｘｅｓｏｆＬａｎｔｈａｎｉｄｅＰｅｒｃｈｌｏｒａｔｅｗｉｔｈＢｉｓ（ｐｈｅｎｙｌｓｕｌｆｉｎｙｌ）ｅｔｈａｎｅａｎｄＯｒｇａｎｉｃＬｅｗｉｓＢａｓｅ...     

Bright Blue Light—emitting Diodes Based on a Novel Fluorescent Dye Containing Heterocyclic Groups

Novel molecular material ,1-benzothiazoly-3-pheny1-pyrazoline (BTPP) was found to function as bright blue light emitting dye in organic electroluminescent device, and its optical and electric characteristics were investigated. This heterovyclic compound exhibited good characteristics of blue photoluminescence and electroluminescence,which had the emission peak at 450nm .The single layer light-emitting devices using BTPP as light -emitting material dispersed in poly(N-vinylcarbazole)(PVK) and double layer ones using PBD as hole block layer above the light-emitting layer were fabricated using conventional spin-casting and vaccum vapour deposition methods. The introduction of PBD has enhanced electron injection and luminance efficiency, compared with the single layer LEDs.     

液态烃球罐安全应用探讨

液态烃常温球罐储存技术相当成熟,但在实际应用方面仍然存在许多问题,影响安全储存。针对使用过程中所了解的一些具体做法进行了分析和探讨,对球罐的改造和设计提供了必要的参考。     

间苯二酚溶剂萃取液液相平衡研究

测定了“醋酸正丁酯-间苯二酚(溶质)-盐水(含0.2质量分率NaCl)”三元系在24℃、101.33kPa下的液液相平衡数据并给出了三角相图,用Hand公式对相平衡数据进行了关联,获得了可供工业连续萃取过程设计使用的关联式。本研究将醋酸正丁酯和正丁醇作为溶剂萃取间苯二酚进行了对比,并指出:醋酸正丁酯优于正丁醇。     

Photoswitching of Ferroelectric Liquid Crystals Using Unsymmetrical Chiral Thioindigo Dopants: Photoinduced Inversion of the Sign of Spontaneous Polarization

A new unsymmetrical chiral thioindigo dopant 6‐[(R,R)‐2,3‐difluorooct‐1‐yloxy]‐5′‐nitro‐6′‐[(R)‐2‐octyloxy]thioindigo ( 4 ) designed to photoinvert the sign of spontaneous polarization (P_S) in a ferroelectric chiral smectic C (SmC*) liquid crystal was prepared using a synthetic approach previously developed in our laboratory. In this new “ambidextrous” design, the (R)‐2‐octyloxy side‐chain is sterically coupled to the thioindigo core and induces a positive P_S, whereas the (R,R)‐2,3‐difluorooctyloxy side‐chain is decoupled from the core and induces a larger negative P_S. In the trans form, this dopant induces a negative polarization in the SmC host (+)‐4‐(4‐methylhexyloxy)phenyl 4‐decyloxybenzoate ( PhB ). Irradiation of a 1 mol‐% mixture of 4 in PhB at λ = 510 nm caused a sign inversion of P_S, from –0.88 to +0.42 nC cm^–2 at T – T_C = –5 °C, which is consistent with an increase in the polarization power of the coupled 2‐octyloxy/thioindigo unit over that of the 2,3‐difluorooctyloxy unit, due to the increase in transverse dipole moment of the thioindigo core upon trans–cis photoisomerization. The P_S sign inversion was confirmed by a surface‐stabilized ferroelectric liquid crystal photoswitching experiment. Spectroscopic measurements on films of the doped liquid crystal mixtures showed that trans–cis photoisomerization is gradually suppressed with increasing dopant mole fraction, possibly as a result of increased dopant aggregation.     

Electrotunable Non‐reciprocal Laser Emission from a Liquid‐Crystal Photonic Device

A liquid crystal (LC) photonic device with an anisotropic optical heterojunction structure has been fabricated. The device has a phase‐retarding nematic LC (NLC) layer sandwiched between two polymer cholesteric LC films with right‐handed helices of different pitches. Electrotunable non‐reciprocal light transmittance and unidirectional circularly polarized (CP) lasing emission have been successfully demonstrated for this device structure. Two left CP (LCP) lasing emission peaks are observed at the edges of the overlapping region between the two photonic bands in the structure and are shifted upon the application of a voltage. In contrast, a non‐reciprocal right CP (RCP) lasing emission peak emerges at one of the band edges and diminishes upon the application of a voltage. These phenomena are interpreted based on the selective reflection of RCP light and the reorientation of the NLC molecules by the application of a voltage.     

Synthesis,Properties, and Photopolymerization of Liquid‐Crystalline Oxetanes: Application in Transflective Liquid‐Crystal Displays

Mixtures of liquid‐crystalline di‐oxetanes and mono‐oxetanes are made for the purpose of making birefringent films by photopolymerization. The composition of a di‐oxetane mixture that forms spin‐coated films of planarly aligned nematic monomers is reported. These films are photopolymerized in air. The molecular order of the monomers can be changed on the microscale to form thin films with alternating birefringent and isotropic parts by using a combination of photopolymerization and heating. The interface observed between the birefringent and isotropic 10 μm × 10 μm domains is very sharp and the films show hardly any surface corrugation. In addition, the polymerized films are thermally stable, making them very suitable for use as patterned thin‐film retarders in high‐performance transflective liquid‐crystal displays (LCDs) which satisfy customer demand for displays that are brighter and thinner and that deliver better optical performance than conventional LCDs with an external non‐patterned retarder.