质子和中子的单粒子效应等效性实验研究

通过实验方法确定了高能质子和中子引起的单粒子效应等效关系，实验中采用金箔散射法降低了质子束流强度，并利用热释光剂量计（TLD）进行质子注量的监测，采用新研制的存储器长线实时监测系统，进行了64K位至4M位的SRAM器件单粒子效应实验，确定了两种粒子引起单粒子效应等效关系。     

一种用于卫星电视接收的FZP天线

本文用物理光学法对ＦＺＰ反射器的聚焦场、聚焦效率及偏轴扫描特性等进行初步分析，并由此提出一种使用ＦＺＰ天线实现多颗卫星信号同时接收的技术方案。原理性样机实际接收结果证实了其可行性     

Observation of atomic steps on CaCO3 crystal surface

By using scanning polarization force microscopy,the deliquescence process and the atomic steps on the cleavage surface of CaCO3 in air were studied in situ.Under an exposure to medium umidity(-57%),the sloiw step movement has been observed.     

Optical dot gain on newsprint determined with the Lund nuclear microprobe

A technique for measuring optical dot gain, i.e. the relative difference between the actual screen dot and the optically perceived one, is presented. By combining measurements from the non-optical nuclear microprobe with data from image analyzing technique the optical dot gain can be determined. The procedure to reach pixel by pixel correlation on a micrometer scale is discussed. In the newsprint sample studied in this investigation a typical optical dot gain between 15 and 20% was deduced. The variation in the optical dot gain was correlated with other characteristic parameters of the print and newsprint and especially a positive correlation to the mass density of the newsprint was observed.     

用扫描电镜判断火工药剂与金属桥丝长期接触的相容性

火工药剂与金属桥丝接触，在高温、高湿条件下贮存一定时间后两者是否相容，用电镜观察其金属表面的腐蚀形态（面积、深浅），以此来判断金属桥丝与火工药剂的相容性。     

木犀科植物花粉的扫描电镜研究

植物花粉的形态特征具有种属特异性。本文用扫描电子显微镜观察了木犀科(Oleaceae)的六属八种植物花粉的形态特征。结果表明,除迎春有个别四萌发沟外,其它花粉都是三沟型,外壁纹饰均为网状。但各种植物花粉的细微形态仍有明显差异。因此,用扫描电镜观察研究植物花粉的亚微形态特征,可为植物分类提供一些必要的形态依据。     

Evaluation of Morphology—Stable Critical Size of KNbO3 Crystals

Skeletal form of KnbO3 crystals growing in Li2B4O7 solvent was in-situ observed at 900℃ and it was found that shallow depression started to develop on the surface of KnbO3 crystals when the crystal size exceeded several micron,typically 7 micron.Based on the quantitative criterion derived by Chernov,the estimated critical size of KNbO3 crystals was 1 micron,which was consistent with the experimental measurement.The kinetic coefficients,Kcorner and Kcr,in the criterion were experimentally obtained in the diffusive-convective and diffusive-advective flow states respectively.     

Ionoluminescence decay measured with single ions

A new ion beam analysis-based, single ion technique called the time to first photon has been developed to measure the decay of the luminescence signal of phosphors. Such measurements are currently needed to study luminescence decay mechanisms following high-density excitations and to identify strongly luminescent phosphor coatings with short lifetimes for ion photon emission microscopy (IPEM). The samples for this technique consist of thin phosphor layers placed or coated on the surface of PIN diodes. Single ions from an accelerator strike this sample and simultaneously create ion beam induced luminescence (IBIL) from the phosphor that is measured by a single-photon-detector, and an ion beam induced charge collection (IBICC) signal in the PIN diode. In this case, the IBICC signal provides the start pulse and the IBIL signal the stop pulse to a time to amplitude converter. It is straightforward to show that this approach also measures a signal proportional to activity versus time with an accuracy of 5% as long as the number of detected photons per ion is less than 0.1, which usually requires the use of absorbers for the IBIL detector or electronic discrimination for the IBIL signals. Details of the new analysis are given together with examples of luminescence decay measurements of several ceramic phosphors being considered to coat IPEM samples. IPEM is currently being developed at Sandia National Laboratory (SNL), the University of North Texas in Denton, and the Universities and INFN of Padova and Torino.     

步进电机在红外系统扫描机构中的应用

介绍了在红外系统中，采用步进电机作为扫描机构驱动元件，以Ｄ／Ａ数模转换器作细分方式的定频脉宽调制驱动方式，实现微机控制下的扫描机的构步距均匀稳定，满足红外系统分辨率的要求。     

A force modulation study on crystallization process in ferroelectric vinylidene fluoride and trifluoroethylene copolymer films

This paper introduces the Force Modulation technique to the study of crystallization process in ferroelectric vinylidene fluoride and trifluoroethylene copolymer films. Using this technique we have successfully visualized ferroelectric crystalline domains and observed that these ferroelectric domains grow out from amorphous phase, unite into strip-like structures, and finally congregate into a union. Force Modulation can weaken the influence of topography on imaging of ferroelectric domains, and reveal more details, which are difficult to be observed in topographical image.