高防腐铝合金电缆桥架生产工艺

介绍了高防腐铝合金电缆线桥架的生产工艺,通过控制用料的质量、冲压、焊接和阳极氧化等因素,用６０６３合金型材和１０６０铝合金板材可以生产出性能优良的铝合金电缆桥架。     

Copper substituted nickel ferrite nanoparticles anchored onto the graphene sheets as electrode materials for supercapacitors fabrication

Nickel ferrites with high theoretical capacitance value as compared to the other metal oxides have been applied as electrode material for energy storage devices i.e. batteries and supercapacitors. High tendency towards aggregation and less specific surface area make the metal oxides poor candidate for electrochemical applications. Therefore, the improvements in the electrochemical properties of nickel ferrites (NiFe₂O₄) are required. Here, we report the synthesis of graphene nano-sheets decorated with spherical copper substituted nickel ferrite nanoparticles for supercapacitors electrode fabrication. The copper substituted and unsubstituted NiFe₂O₄ nanoparticles were prepared via wet chemical co-precipitation route. Reduced graphene oxide (rGO) was prepared via well-known Hummer's method. After structural characterization of both ferrite (Ni_1-xCu_xFe₂O₄) nanoparticles and rGO, the ferrite particles were decorated onto the graphene sheets to obtain Ni_1-xCu_xFe₂O₄@rGO nanocomposites. The confirmation of preparation of these nanocomposites was confirmed by scanning electron microscopy (SEM). The electrochemical measurements of nanoparticles and their nanocomposites (Ni_0.9Cu_0.1Fe₂O₄@rGO) confirmed that the nanocomposites due to highly conductive nature and relatively high surface area showed better capacitive behavior as compared to bare nanoparticles. This enhanced electrochemical energy storage properties of nanocomposites were attributed to the graphene and also supported by electrical (I-V) measurements. The cyclic stability experiments results showed ~65% capacitance retention after 1000 cycles. However this retention was enhanced from 65% to 75% for the copper substituted nanoparticles (Ni_0.9Cu_0.1Fe₂O₄) and 65–85% for graphene based composites. All this data suggest that these nanoparticles and their composites can be utilized for supercapacitors electrodes fabrication.     

镁合金的表面氧化膜及其耐蚀性

介绍了国外镁合金用阳极氧化和化学氧化成熟工艺及近年的新发展，阐述了有关镁合金表面阳极氧化膜和化学转化膜构成的研究成果，比较了不同工艺得到的表面膜的耐蚀性。     

Experimental study of CO2 absorption/stripping via PVDF hollow fiber membrane contactor

Gas–liquid hollow fiber membrane contactor can be a promising alternative for the CO₂ absorption/stripping due to the advantages over traditional contacting devices. In this study, the structurally developed hydrophobic polyvinylidene fluoride (PVDF) hollow fiber membranes were prepared via a wet spinning method. The membranes were characterized in terms of morphology, permeability, wetting resistance, overall porosity and mass transfer resistance. From the morphology analysis, the membranes demonstrated a thin outer finger-like layer with ultra thin skin and a thick inner sponge-like layer without skin. The characterization results indicated that the membranes possess a mean pore size of 9.6 nm with high permeability and wetting resistance and low mass transfer resistance (1.2 × 10⁴ s/m). Physical CO₂ absorption/stripping were conducted through the fabricated gas–liquid membrane contactor modules, where distilled water was used as the liquid absorbent. The liquid phase resistance was dominant due to significant change in the absorption/stripping flux with the liquid velocity. The CO₂ absorption flux was approximately 10 times higher than the CO₂ stripping flux at the same operating condition due to high solubility of CO₂ in water as confirmed with the effect of liquid phase pressure and temperature on the absorption/stripping flux.     

柠檬酸盐对阳极箔形成速度与比电容的影响

为了提高铝电解电容器用高压阳极箔形成速度与比电容,将水合处理后的腐蚀箔在95℃、2 g/L柠檬酸钠去离子水溶液中浸泡5 min,在530 V电压化成时,形成时间缩短约2 min,化成箔比电容由0.556×10–6 F.cm–2提高至0.584×10–6 F.cm–2,阳极氧化铝膜的结构与性能得到改善。     

阳极氧化钽酸锂薄膜在NaOH溶液中的腐蚀行为研究

通过阳极氧化法在高纯钽片表面制备了钽酸锂复合薄膜,采用浸泡失重法和电化学测试法考察了镀膜前后样品在10% (质量分数) NaOH溶液中的腐蚀行为。利用X射线衍射仪、扫描电子显微镜及能谱仪分别对薄膜的物相组成、表面及截面形貌、膜层厚度进行了测试分析。结果表明,阳极氧化后得到的复合薄膜由钽酸锂和氧化钽组成;该薄膜与基体之间结合良好,厚度约3 μm;镀膜后样品的质量腐蚀速率至少减少了6倍,腐蚀电流密度下降了2个数量级,腐蚀96 h后样品表面没有明显变化。而对比的纯钽样品却发生了严重的腐蚀反应,生成了很多长条状和多棱柱状的腐蚀产物Na₃TaO₄、Na₂Ta₂O₆和Na₈Ta₆O₁₉。     

Comparative studies of adsorbed CO and methanol electrooxidation on carbon supported Pt and PtRu catalysts in acid solution

1. Introduction Direct methanol fuel cells (DMFCs) have con-siderable advantages compared to gas feed (H2/air) polymer electrolyte membrane (PEM) fuel cells [1-2]. The hydrogen PEM fuel cells use gaseous hy-drogen as fuel. But there is no source and infra-structure established yet for hydrogen distribution and storage, neither as a liquid nor as a gas. How-ever, the DMFC, similar to a proton exchange membrane fuel cell (PEMFC), uses methanol fuel directly for electric power generation …     

Investigation of polyelectrolyte for electrochemical detection of uric acid in presence of ascorbic acid

Uric acid (UA) was detected in the presence of ascorbic acid (AA) at GC electrode by cyclic voltametry (CV) and differential pulse voltametry (DPV) in aqueous media of cationic polyelectrolyte (poly(diallyldimethylammonium chloride) (PDDA)). Both, UA and AA are anionic nature and electro-static attraction with cationic solution. This lowered their oxidation potentials and increased anodic current. In CV studies, the UA oxidation potential was decreased by 400 mV in the presence of PDDA along with increase in peak current. Effect of PDDA and pH on E_pa and I_pa were also studied. About 360 mV difference in oxidation peak potentials was observed for AA and UA in PDDA media, which established a quick method for their simultaneous determination. The detection limit of UA in the presence of 200 folds AA was found as 1 μM with correlation coefficient of 0.994 and sensitivity of 0.05 μA μM⁻¹. The proposed method has been also applied for determining the UA in human urine without any pretreatment, and found to be satisfactory.     

对气提法尿素生产技术的看法——与“氨气提法和二氧化碳气提法尿素生产技术的新进展、比较及评价”一文作者商榷

根据近１０年来参加国内尿素工程国际招标、评标、设计、建设的经验和调查研究结果,认为目前氨气提法和ＣＯ２气提法２种尿素工艺虽从技术、经济数据比较大体相当,但从实际结果看氨气提法有其独特之处,因此近１０多年来在全世界尤其在我国深受用户青睐。     

菲酐-纳米金修饰电极同时检测抗坏血酸、多巴胺和尿酸的研究

多孔结构的3,4,9,10-茈四甲酸二酐（PTCDA）作为骨架,用抗坏血酸做还原剂制备纳米金（GNPs）,制备了高催化活性的PrC—GNPs复合纳米材料。将该材料用于玻碳电极的修饰（GCE）,制得PTC—GNPs复合材料修饰的电极（PTC—GNPs／GCE）。该修饰电极能够同时对尿酸（UA）、多巴胺（DA）和抗坏血酸（AA）进行检测。分别使用循环伏安法（CV）和差分脉冲伏安法（DPV）对UA、DA和AA和在修饰电极上的电化学行为进行研究。实验结果表明,在pH=5．0的PBS缓冲体系中,该修饰电极对UA、DA和AA的线性响应范围分别为0．002～0．462mol／L、0．002～0．352mol／L和0．04～1．54mol／L。该传感在临床医学检测领域具有一定的应用前景。