水库淤积初步平衡问题

水库淤积平衡问题对于确定淤积危害程度、可持续利用标准等都非常重要。本文通过分析大量已建、在建和规划水库淤积情况,对水库淤积初步平衡后淤积变化趋势与设计淤积标准等问题进行了讨论和商榷。研究表明,水库淤积初步平衡后,兴利库容淤积发展仍然很快,库尾河床与水位抬升仍在继续,并未最终稳定。水库淤积平衡应该更加注重兴利库容淤积情况和库尾河床与水位抬升趋势,仅仅关注总淤积量变化情况是不够的。从区域长远利益考虑,大江大河上的水库设计淤积年限还应大大加长。     

单膛石灰竖窑的改造

我厂竖窑容积为250m^3，设计利用系数为0．85t/(m^3．d)。随烧结产量的不断增加，石灰产量已不能满足烧结生产的需要。为了提高石灰产量，进行了扩容改造，容积由原来250m^3增加到298m^3，并针对目前生产实际提出下一步改造设想。     

加油站油品用体积交接存在的问题及建议

叙述了目前加油站在实行按任意温度下的体积交接，由于未考虑油品体积随温度、压力、密度的变化，出现了零售损耗很大的问题。建议加油站在现阶段采用“准标准体积”交接；在由体积转换为质量计算加油站损溢时，使用油库当月发出的平均密度；当财会核销损溢时，不使用盘存的体积和固定密度进行计算的方法，而使用实际盘点的质量数，以真实反映加油站的当期损溢。     

开流形的曲率与拓扑

应用比较几何的方法研究了完备非紧且具有特定曲率条件的黎曼流形，证明了在一定Pinching条件限制下，流形具有有限拓扑型或者微分同胚于R^n。     

Density Measurement of Liquid Ni-Ta Alloys by a Modified Sessile Drop Method

The density of liquid Ni- Ta alloys was measured by using a modified sessile drop method. It is found that the density of the liquid Ni- Ta alloys decreases with the increasing temperature, but increases with the increase of tantalum concentration in the alloys. The molar volume of liquid Ni- Ta binary alloys increases with the increase of temperature ancl tantalum concentration.     

Volumetric properties of mixtures of 1,4-dioxane and water at high pressures

Densities of aqueous of 1,4-dioxane have been measured at temperatures from 298 to 348 K and at pressures up to 40 MPa by a vibrating-tube method. Molar volumes obtained with an estimated uncertainty of ±0.2°,% are correlated with pressure by the Tait equation within the experimental uncertainty. Pressure and composition dependences of the excess molar volume, partial molar volume, and isothermal compressibility are determined and they are compared with those of other aqueous solutions.     

Edge detection,three-dimensional cell boundary reconstruction and volume and surface area estimation from differential interference contrast images

Three-dimensional (3-D) cell morphology is important for the understanding of cell function and can by quantified in terms of volume and surface area. Differential interference contrast (DIC, or Nomarski) imaging can enable cell edges to be clearly visualized in unstained tissue due to the slight difference in refractive index between aqueous media and cytoplasm. DIC is affected in only one direction - the direction of the optical shear. A 1-D edge detector was used in that direction with a scale length equal to that of an in-focus edge to highlight cell boundaries. By comparison with the signal from the edge detector on an out-of-focus slice, the in-focus slices could be segmented and, after noise suppression, cell outlines obtained. A voxel paradigm was used to calculate cell volume and differential geometry was used for surface area estimation. We applied this approach to obtain 3-D dimensional information by optical sectioning of motile Amoeba proteus.     

Entropy,Free Volume,and Cooperative Relaxation

The high frequency end of the relaxation spectrum for polymer molecules involves the rotation of the segmental bonds. This fast relaxation process, however, cannot take place easily in the condensed state crowded by the densely packed conformers, necessitating the slower cooperatively synchronous relaxation. As the temperature is lowered, the domain of cooperativity grows towards the infinite size at the Kauzmann zero entropy temperature, though actually the system deviates from the equilibrium as the glass transition intervenes typically at 50 K above that temperature. The excess enthalpy and entropy drop faster than predicted by the rotational isomeric states which would reach zero only at 0 K. The real ΔC_P is greater than that of the RIS value. The actual volume in excess of the crystalline lattice volume, however, points towards zero at 0 K. Thus, a polymer with higher T_g typically exhibits a lower density and modulus in the glassy state. Since the configurational entropy associated with the free volume is proportional to the logarithm of the latter, the Kauzmann temperature can be scaled by ln M, where M is the algebraic average of the conformer molecular weight. The temperature dependence of the most dominant, i.e., the largest equilibrium domain size will result in the Adam-Gibbs and Vogel equations for the characteristic relaxation time. The cooperative domain distribution leads to the relaxation spectrum that follows a power law. The relationship between the characteristic relaxation time and the rate of physical aging is derived.     

铝－锂合金中δ’（Al＿3Li）沉淀相时效粗化行为及体积分数的测定

对经固溶处理的二种Ａｌ－Ｌｉ合金（１．９４ｗｔ．％Ｌｉ和２．７５ｗｔ．％Ｌｉ）的时效过程进行了研究。结果表明：δ’的生长速率遵从Ｏｓｔｗａｒｄ粗化动力学。１．９４ｗｔ．％Ｌｉ合金δ’产生于时效过程中，而２．７５ｗｔ．％Ｌｉ合金的δ’产生于时效的前期阶段。前者的表现体积分数明显大于根据相图估算的数伍，真实体积分数则与此值接近；后者的体积分数低于根据相图估算的数值，这可能归咎于δ’固相线的位置、统计学误差及Ｌｉ更易在时效过程中贫化。     

河道溃堤与溃堤波的一、二维耦合计算数值模拟

建立了一维河道溃堤与二维溃堤波耦合计算的水力模型、其中，河道的计算采用一维明渠非恒定流Saint—Venant方程组，求解的过程与溃口的数值模拟耦合；溃堤按渐溃计算，将溃口模拟为梯形，随时间线性增大；溃堤波的计算采用在有限体积无结构网格上建立的TVD—MUSCL格式．模拟算例表明，建立的河道溃堤与溃堤波的一、二维耦合计算水力模型模拟结果比较接近真实溃堤过程．