新型可控电抗器大幅度限制操作过电压功能的研究

通过数值计算和模拟研究,本文叙述了新型可控电抗器的广泛的无功调节功能,揭示了它所具有的大幅度限压的能力,并在理想数学模型的基础上分析了电抗器的限压机理。     

一种低压低功耗SRAM/SOI单元设计

提出一种改进4管自体偏压结构SRAM/SOI单元.基于TSUPREM4和MEDICI软件的模拟和结构性能的分析,设计单元结构并选取结构参数.该结构采用nMOS栅下的含p+埋沟的衬底体电阻代替传统6管CMOSSRAM单元中的pMOS元件,具有面积小、工艺简单的优点.该结构可以在0.5V的电源电压下正常工作,与6管单元相比,该单元瞬态响应正常,功耗只有6管单元的1/10,满足低压低功耗的要求.     

无功功率的补偿方法

介绍采用同步电动机和并联电容器进行无功补偿等常用的无功功率补偿方法，以提高用电设备的功率因数。     

PIC单片机在激光电源中的应用研究

论述了单片机控制激光电源的原理，提出了产生PWM控制的基本思想及整个控制系统的硬件组成和软件设计方法。     

方波扫描路径确定声源声功率误差特性分析

改进了矩形测量面方波扫描路径测量声功率的误差模型 ,以单极子、偶极子及四极子声源为例 ,给出了扫描方向、测量面离声源的距离及扫描线的密度的选取对理论误差的分布图形。分析结果表明 :对选定的测量面 ,在扫描线密度小的情况下 ,通过调整声源离测量面的距离 ,可以在声源近处找到一个最优点或较优点 ,使理论误差为零或很小 ;在绝大多数情况下 ,沿测量面长边扫描误差比沿短边扫描小。     

Reducing Average and Peak Test Power Through Scan Chain Modification

Parallel test application helps reduce the otherwise considerable test times in SOCs; yet its applicability is limited by average and peak power considerations. The typical test vector loading techniques result in frequent transitions in the scan chain, which in turn reflect into significant levels of circuit switching unnecessarily. Judicious utilization of logic in the scan chain can help reduce transitions while loading the test vector needed. The transitions embedded in both test stimuli and the responses are handled through scan chain modifications consisting of logic gate insertion between scan cells as well as inversion of capture paths. No performance degradation ensues as these modifications have no impact on functional execution. To reduce average and peak power, we herein propose computationally efficient schemes that identify the location and the type of logic to be inserted. The experimental results confirm the significant reductions in test power possible under the proposed scheme.     

Effect of Additives on Magnetic Properties of High Frequency MnZn Power Ferrite

In keeping with the advance of more compact and more power-saving electronic equipment, the demand is increasing for smaller and more efficient switching power supply. Therefore, it is necessary to provide the adequate magnetic power ferrite materials to satisfy the demand. Such ferrite materials have to meet the following main requirement: 1) high initial permeability (μ i ); 2) high saturation magnetic induction (Bs); 3) high Curie temperature (Tc); 4) high electrical resistivity (ρ ); 5)…     

微波功率放大器预失真线性化技术分析

给出了两种基本形式的预失真线性化电路,对其工作原理和技术特点进行了分析。     

三峡工地高压供电线路故障判断方法的探讨

高压供电设备故障特别是输电线路的高压接地故障对工地的影响是相当大的。由于接地故障为隐性故障，没有明显的物理现象，且若是长期接地可能会发展成较为严重的两相或三相短路故障，使系统解列运行直至崩溃；由于工地流动人员较多，还易造成电击事故。利用高压一相接地时在线路中产生零序电压这一特性来迅速判断和切除接地的用电设备，可以保证各项施工的顺利进行。     

Influence of a Jump in the Power of Laser Radiation on Its Measurement

Simulation and investigation of the effect of an isolated jump on realization of the unit of power of laser radiation and dissemination of the size of the unit are considered. Results are obtained by means of a newly developed algorithm that characterizes the behavior of the mean value of a signal and the standard deviation of a system as functions of the parameters of a jump in the power of laser radiation and the length and amplitude of the jump. If information concerning the time when a jump occurs is available, the proposed algorithm makes it possible to take into account how a jump affects the ultimate result of a measurement.