双程放大技术在光纤放大器中的应用

双程放大技术是一种高效率、低成本的实用化放大技术。本文介绍了双程放大技术的优点及在各种放大器中的应用。     

Development of a fast neutron radiography converter using wavelength-shifting fibers

A fluorescent converter for fast neutron radiography (FNR) comprising a scintillator and hydrogen-rich resin has been developed and applied to electronic imaging. The rate of the reaction between fast neutrons and the converter is increased by thickening the converter, but its opaqueness attenuates emitted light photons before they reach its surface. To improve the luminosity of a fluorescent converter for FNR, a novel type of converter was designed in which wavelength-shifting fibers were adopted to transport radiated light to the observation end face. The performance of the converter was compared with that of a polypropylene-based fluorescent converter in an experiment conducted at the fast-neutron-source reactor YAYOI in the University of Tokyo.     

PPT光纤波片耦合模方程的解析解

理论分析了PPT光纤波片耦合模方程，得出了一定条件下的解析解，将该解析解和渐进近似结果进行了比较，它们在实际应用的PPT光纤波片中具有很好的一致性。     

碳纤维增强混凝土构件正截面计算的双界限系数法

以材料的力学性能分析为基础，利用双界限系数将碳纤维增强混凝土受弯构件划分成三种正截面的破坏形态，对每一种破坏形态，建立了单、双筋矩形截面极限承载力的计算式，使碳纤维增强混凝土构件正截面计算与现行的规范相一致。     

NPCDP／PET复合仿毛纤维纺丝工艺研究

应用复合纺丝方法并通过加弹、空气变形等措施使ＮＰＣＤＰ／ＰＥＴ异染异收缩纤维获得优良的毛性感。简要介绍了复合纺丝的工艺路线，讨论了纺丝温度、压力、干燥工艺、拉伸条件对可纺性的影响，并明确了变形工艺对复合纤维的影响作用。制得的ＮＰＣＤＰ／ＰＥＴ复合纤维物理力学性能符合后加工要求，织物的缓弹回复角达３０５度。     

Development of cable fault location method using fiber optic distributed temperature sensor

When ground-fault problems occur on a cable line, immediate fault location and restoration are required. Therefore, various new methods to locate the fault point instantaneously have been investigated to replace such conventional methods as the Murray loop method and the pulse radar method [1]. These methods require a long time to locate the fault point. One possible fault location method is to sense the temperature rise following a ground fault using a fiber optic distributed temperature sensor. Application of this method was found feasible through sensing the temperature rise at a ground-fault test using a thermocouple as a temperature sensor with test cables [4]. A power/optical composite cable was prepared experimentally and after verifying its thermal mechanical performance, the temperature rise at an incidence of a fault was determined and the anticipated performance was demonstrated in a ground-fault test. This article describes the outline of the test.     

可变波长光纤光栅滤波器用微驱动器的研制

为了研制可调谐光纤光栅滤波器而采用拉伸装置和光纤光栅一体化的微小器件结构。实现方法是由微细加工技术加工制造一种新的波长可变光纤光栅滤波器用驱动器，该微型驱动器采用电磁式驱动，由上下两层线圈构成，每个线圈有21匝平面线圈，产生约0．2μNm的扭矩，对应光纤光栅的反射波长变化约5nm。它可应用于可谓谐光纤光栅滤波器的驱动。     

水工钢闸门聚酯玻璃钢复合防腐处理方法

水环境的恶化，使水工钢闸门腐蚀加重，传统的防腐工艺保护效果下降。聚酯玻璃钢复合防腐层的水工钢闸门防腐工艺具有使用设备少，工艺简单、防腐效果好、成本低等优点，适用于在各种水环境中作各种形式的水工钢闸门防腐，效果良好。该文结合江苏省淮海农场工程施工经验，提出了水工钢闸门聚酯玻璃钢复合防腐层结构设计、施工工艺及质量标难，为今后的推广应用提供了一定的参考依据。     

新型光电混合式电流互感器设计

设计了一种光电混合式电流互感器,它由传感头、光纤传输和光电转换器、信号处理电路和工作电源4部分组成。这种结构具有绝缘性能高、可靠性强、质量小等特点,并对误差情况进行了分析。     

PE/PP共混物卷绕丝微观结构的研究

用透射和扫描电子显微镜研究PP/PE共混物在熔融纺丝时 ,PE掺入对PP结构的影响。研究结果表明 :PE与PP存在一定程度的相互作用 ,PP中加入PE能改变卷绕丝中PP结晶结构 ;PP中加入质量分数低于 10 %的PE时可以顺利纺丝 ,所得的卷绕丝断裂伸长率较大 ,具有良好的可拉伸性