Fabrication of SiO2-ZrO2 composite fiber mats via electrospinning

(1 − x)SiO₂-(x)ZrO₂ (x = 0.1, 0.2) composite fiber mats were prepared by electrospinning their sol-gel precursors of zirconium acetate and tetraethyl orthosilicate (TEOS) without using a polymer binder. The electrospun composite fibers were characterized by powder X-ray diffraction (XRD), scanning electron microscopy (SEM), fourier transform infrared spectroscopy (FT-IR) and mercury porosimetry. The composite fibers having a tetragonal crystalline ZrO₂ were obtained by calcining the electrospun composite fibers at high temperatures. The results show that the structure and crystallization of ZrO₂ in the composite fibers can be controlled by sintering temperature, while the porosity and morphology of the fiber mats did not depend on the sintering temperature.     

Homogeneous versus heterogeneous catalytic reactions to eliminate organics from waste water using H2O2

Homogeneous (Cu²⁺ ions) and heterogeneous (Cu²⁺-pillared clay) Fenton-like catalysts have been compared in the conversion of p-coumaric acid. The performances of the two classes of catalysts are similar for an analogous amount of copper, but there are some relevant differences in terms of (i) the presence of an induction time, (ii) the turnover frequency, (iii) the efficiency in the use of H₂O₂, (iv) the initial attack of p-coumaric acid (hydroxylation on the aromatic ring or oxidative attack on the double bond of the lateral chain), and (v) the effect of dissolved oxygen on the removal of total organic carbon (TOC). These differences were interpreted in terms of reaction network of generation of radical oxygen species and of organics conversion. The possible formation of a surface peroxo adduct coordinated to a copper binulcear site was also evidenced for the solid heterogeneous catalyst.     

一类含查尔酮结构的光敏性二胺的合成研究

以醛、酮为原料经羟醛缩合反应合成了具有一类含查尔酮结构的光敏性二胺:1-(3-氨基苯基)-3-(4-氨基苯基)-2-丙烯-1-酮与对-二(间氨基肉桂酰)苯.通过优化实验得到最佳的合成工艺为:醛、酮在温度为0℃下,以乙醇为溶剂,氢氧化钠为催化剂,进行羟醛缩合反应3h.收率可达到86%,经液相色谱分析其纯度分别为99.92%,99.91%,紫外可见最大吸收波长分别为349nm、361nm.所得方法操作简便,收率较高,原料易得.并用元素分析、核磁共振、红外光谱等手段对产物的结构进行了表征.     

Adsorption and desorption characteristics of 2-methyl-4-chlorophenoxyacetic acid onto activated carbon

Adsorption and desorption characteristics of the 2-methyl-4-chlorophenoxyacetic acid (MCPA) from aqueous solution onto the activated carbon (GAC, F-400) were studied. Adsorption equilibrium capacities of the MCPA increased with decreasing pH and temperature of the solution. Adsorption equilibrium of the MCPA could be represented by the Sips equation. The internal diffusion coefficients were determined by comparing the experimental concentration decay curves with those predicted from surface diffusion model and pore diffusion model. The adsorption model based on the linear driving force approximation (LDFA) was used for simulating the adsorption behavior of the MCPA in a fixed bed. Over ninety five percent desorption of the MCPA could be obtained using distilled water.     

2-苯基-4-对氯苯基-1,5-苯并硫氮杂-α-(丁二酰亚胺基)-β-内酰胺的高效液相色谱法分析

采用Hypersil-ODS2(4.6mm×250mm,5μm)色谱柱,乙腈-水(70∶30)流动相,242nm检测波长,建立了测定2-苯基-4-对氯苯基-1,5-苯并硫氮杂-α-(丁二酰亚胺基)-β-内酰胺的高效液相色谱法。该法线性范为0～0.1mg/mL,回归方程为A=1.63×108c-2.86×105,相关系数r=0.9994,相对标准偏差为0.33%(c=0.06mg/mL,n=5),检出限为0.08μg/mL。平均回收率在97.2%～102.4%之间。该法重现性好,灵敏度高,简单,快速,准确。     

固体超强酸催化合成水杨酸正丁酯

用固体超强酸SO4^2-/Fe2O3-TiO2为催化剂，实现了水杨酸和正丁醇反应合成水杨酸正丁酯。最佳合成条件为n(醇)：n(酸)＝2．0：1，催化剂用量为酸质量的5％，反应时间为4．5h，酯化率可达96％。催化剂具有容易回收并可循环使用、不污染环境等优点。     

ZrO2载体催化剂的制作及特性探讨

选择有应用价值的CuO/ZrO2体系，通过大量试验寻找到了一种以ZrO2为载体的高比表面催化剂的制备方法。     

N，O，O′─三（对甲苯磺酰基）双（2─羟乙基）胺的合成

二乙醇胺和对甲苯磺酰氯在三乙胺存在下，反应生成Ｎ，０，Ｏ′－三（对甲苯磺酰基）双（２－羟乙基）胺，产率９３％。从反应混合物中分离得副产物Ｎ，Ｏ－二（对甲苯磺酰基）双（２－羟乙基）胺。     

二(2-氨基乙基)-(3-氨基丙基)胺的合成新方法

以二(氰基甲基)胺及丙烯腈为原料，通过亲核加成、氢化反应合成了不等臂有机多胺化合物二(2-氨基乙基)-(3-氨基丙基)胺，标题化合物及其中间产物经多种谱学手段表征确证。在优化条件下，产物的总收率为67％，含量99.5％(HPLC)。     

NBR/Zn(MAA)2/蒙脱土纳米复合材料的研究

研究NBR／基丙烯酸锌[Zn(MAA)2]／蒙脱土纳米复合材料的性能。结果表明，Zn(MAA)2可以通过原位聚合反应在与NBR发生接枝交联的同时，实现对蒙脱土的插层，用该方法制备的NBR／Zn(MAA)2／蒙脱土纳米复合材料的物理性能优异，含有有机改性蒙脱土HMMT和USM的复合材料性能更为突出，且具有一定的透明性。