中国微米纳米 花状Au-SnO2复合材料的制备及其对甲醛气敏性能的研究

利用水热法合成了花状SnO2微米材料,并以它作为基体,对其进行Au纳米颗粒修饰,得到了花状Au-SnO2复合材料.利用X射线衍射(XRD)、扫描电子显微镜(SEM)、X射线光电子能谱(XPS)分析等表征手段对所制备的Au-SnO2复合材料进行了表征分析,结果表明,这种花状结构的材料是由厚度为30 nm～60 nm的SnO2纳米片自组装而成,其尺寸为1 μm～2 μm.同时,我们用花状SnO2和Au修饰的花状SnO2复合材料对1×10-6～500×10-6的甲醛进行了气敏性能测试.结果表明,通过Au修饰,花状SnO2对甲醛的气敏性能有了极大的提高.当甲醛浓度为200×10-6时,其灵敏度(Ra/Rg)约为120,是花状SnO2敏感材料的8倍,表现出很高的响应.另外,由Au修饰的花状SnO2复合材料制成的敏感元件对甲醛表现出良好的选择性.这可能归因于Au纳米颗粒高效的催化活性促进了甲醛气体的扩散和O2的吸附,从而使其表现出更加优异的气敏性能.     

新型Au/TiO_2纳米管的制备及其在化学需氧量测定中的应用研究

该文首次用光电催化的方法,在TiO2纳米管中嵌入金纳米粒子,新材料可以促进界面间电子的传递,有助于电子和空穴对的分离,进而提高光催化效率.对Au/TiO2纳米管进行扫描电子显微镜(SEM),色散型X射线能谱(EDX)和X射线衍射(XRD)表征,结果表明金纳米粒子被成功嵌入TiO2纳米管中,形成蜂窝状结构.将该材料首次用于光电催化法化学需氧量(COD)的测定,发现该传感器的光电流值在1～800mg/L范围内与COD值有良好的线性响应,检测限为0.3 mg/L.利用该传感器测定实际水样的COD值,结果与传统的K2Cr2O7标准方法有较好的一致性.     

Au催化水煤气变换反应的密度泛函理论研究

应用密度泛函理论(DFT)对Au催化水煤气变换反应的3种可能机理(氧化还原机理、羧基机理、甲酸根机理)进行比较。通过对各个基元反应的反应物、反应中间体、过渡态和产物的研究表明:水煤气变换反应在Au(111)面有3种可能机理,并且每种机理各有2种反应途径.对氧化还原机理来说,反应易按照2个OH的歧化反应进行:对羧基机理来说,反应易按照COOH和OH发生歧化反应进行;对甲酸根机理来说,反应易按照HCOO和OH反应进行。纵观整个反应历程,从活化能比较可知,按甲酸根机理进行的可能性最小,按照羧基机理反应的可能性最大。     

Effect of annealing on the characteristics of Au layers grown on the high-temperature deposited Ni50Fe50 layers

80 nm-thick Ni₅₀Fe₅₀ layers were sputter-deposited on glass substrates at 400 °C and then Au layers were sputter-deposited on the Ni₅₀Fe₅₀ layers. The Au/Ni₅₀Fe₅₀ bilayer films were annealed in a vacuum of 5×10⁻⁴ Pa from 250 to 450 °C for 30 min or 90 min. The characteristics of the Au layers were studied by Auger electron spectroscopy, field emission scanning electron microscopy, X-ray diffraction and a four-point probe technique. When the annealing temperature reaches 450 °C, Fe and Ni atoms diffuse markedly into the Au layer and the Fe content is more than the Ni content. When the annealing temperature is lower than 450 °C, the grain size of the Au layers does not change markedly with annealing temperature. However, as the annealing temperature reaches 450 °C, the annealing promotes the grain growth of the Au layer. As the annealing temperature exceeds 300 °C, the resistivity of the bilayer films increases with increasing annealing temperature. The diffusion of Fe and Ni atoms into the Au layer results in an increase in the resistivity of the annealed bilayer film. Large numbers of Fe and Ni atoms diffusing into the Au layer of the annealed Au/Ni₅₀Fe₅₀ bilayer film lead to a significant decrease in the lattice constant of the Au layer.     

Preparation and CO gas-sensing behavior of Au-doped SnO2 sensors

A study on the low-temperature CO gas sensors based on Au/SnO₂ thick film was reported. Au/SnO₂ powders, with different Au loading from 0.36 to 3.57 wt%, were prepared by a deposition-precipitation method. Thick films were fabricated from Au/SnO₂ powders. The Au/SnO₂ thick-film sensors exhibited high sensitivity to CO gas at relatively low operating temperature (83-210 °C). We also reported the effect of the Au loading in Au/SnO₂ on the CO gas sensing behavior. The optimal Au loading in as-prepared Au/SnO₂ was 2.86 wt%.     

共沉淀富集分离矿石中微量金、铂、钯

研究了硒、铜、银、砷作为共沉淀剂。富集分离地质样品中金、铂、钯的最佳条件。在3mol/L HCl介质中，以4mg硒和5mg铜、银、砷对金、铂、钯进行共沉淀富集，采用孔雀绿分光光度法测定金．DDO分光光度法测定铂、钯，回收率均在95％-102％之间。通过对含金矿样加入铂、钯标准样品的回收实验，结果令人满意。     

Indium oxide thin film based ammonia gas and ethanol vapour sensor

A sensor for ammonia gas and ethanol vapour has been fabricated using indium oxide thin film as sensing layer and indium tin oxide thin film encapsulated in poly(methyl methacrylate) (PMMA) as a miniature heater. For the fabrication of miniature heater indium tin oxide thin film was grown on special high temperature corning glass substrate by flash evaporation method. Gold was deposited on the film using thermal evaporation technique under high vacuum. The film was then annealed at 700 K for an hour. The thermocouple attached on sensing surface measures the appropriate operating temperature. The thin film gas sensor for ammonia was operated at different concentrations in the temperature range 323–493 K. At 473 K the sensitivity of the sensor was found to be saturate. The detrimental effect of humidity on ammonia sensing is removed by intermittent periodic heating of the sensor at the two temperatures 323K and 448 K, respectively. The indium oxide ethanol vapour sensor operated at fixed concentration of 400 ppm in the temperature range 293–393 K. Above 373 K, the sensor conductance was found to be saturate. With various thicknesses from 150–300 nm of indium oxide sensor there was no variation in the sensitivity measurements of ethanol vapour. The block diagram of circuits for detecting the ammonia gas and ethanol vapour has been included in this paper.     

Surface Plasmon Resonance Enhanced Scattering of Au Colloidal Nanoparticles

Abstract Suspended gold nanoparticles have been synthesized via electrochemical method.The strongest resonance scattering peak is at 485 nm, which results from the surface plasmonresonance. When the excited wavelength is at 242 nm (12.4×10~(14) Hz), there have been a 1/2fraction frequency scattering peak at 485 nm (1/2×12.4×10~(14) Hz) and a 1/3 fraction frequencyscattering peak at 726 nm (1/3×12.4×10~(14) Hz) displayed. Emission spectra with different particlediameters were compared, the intensity of scattering light increases with the particle size. Thefrequency-dependent scattering average cross section of small particle was calculated from Mietheory. The model calculation is in agreement with the experimental results.     

花岗斑岩类岩石中Au、Pd溶解性状的实验研究

研究花岗斑岩类岩石中Au、Pd的溶解性状 ,对于研究其溶解、迁移、沉淀条件有着重要的理论价值。研究结果表明 ,花岗斑岩中Au、Pd地球化学性状明显不同 ,Au活性显著 ,Pd惰性特征明显。在T =2 5 0℃、P =2 0× 10 5～ 30× 10 5Pa、pH =7.5 6的条件下 ,Au浸出率最低 ,易于沉淀成矿 ;在T =10 0℃、P =10 0× 10 5Pa、pH =8.2时 ,Au浸出率高 ,最易被活化溶解 ;当T =5 0 0℃ ,P =5 0 0× 10 5Pa ,pH =8.5时 ,Au浸出率中等 ,易被搬运、迁移。Pd易于沉淀成矿的条件是T =10 0℃ ,P =5 0 0× 10 5Pa ,pH =8.2 ;Pd易于活化溶解的条件是T =2 5 0℃ ,P =10× 10 5Pa ,pH =8.5 ;在T =30 0℃、P =(2 0～ 30 )× 10 5Pa、pH =6条件下发生搬运迁移。     

Step-Directed Deposition of Au Nanostructures By Electron Beam Evaporation

Au atoms were vaporized by electron beam evaporation, and their subsequent growths on Si (111 ) and highly ordered pyrolytic graphite (HOPG) substrates were studied using atomic force microscopy. Results show that Au nanoparticles tend to nucleate and grow regularly along the step edges of HOPG, however, nanoparticles are distributed homogeneously over the whole Si substrate. The possibility of controlled growth of Au in ultrahigh vacuum with peculiar surface structures was preseuted.