Dynamics of hydrated iron(II) cations in nafion polymer membranes

Mössbauer studies of Fe²⁺ in water-soaked nafion polymer membranes in the temperature range between 90 K and 250 K have been performed. Above a critical temperature (～ 180 K) the spectra exhibit both elastic narrow absorption lines and quasielastic broad lines. These spectra are typical of bounded diffusion phenomena observed by Mössbauer spectroscopy in macromolecular systems like haemoglobin, myoglobin and ferritin. Similar spectral shapes have been observed by quasielastic neutron scattering from water in nafion membranes. Within 50 K above the critical temperature the total Mössbauer absorption area decreases by an order of magnitude whereas the narrow absorption line decreases by two orders of magnitude. The results are interpreted in terms of bounded diffusive motion of the iron. Using a model based on overdamped harmonically bound Brownian motion, the essential parameters of the iron motion can be derived as a function of temperature. The iron motion most probably reflects the motion of a large Fe²⁺ complex, e.g. Fe(H₂O)²⁺₆, which is attached to the polymer side chains via the sulphonic group.     

Electrical Resistance Measurement of Glass Transition and Crystallization Characteristics of Zr—Al—Cu—Ni Metallic Glasses

In this paper,glass transition and thermal stability of the Zr-Al-Cu-Ni metallic glasses were investigated by using electrical resistance measurement(ERM),DSC and X-ray diffraction techniques.The experimental results show that the ERM is capable of detecting the glass transition of the amorphous alloys and can help to distinguish the crystallization products of the Zr-Al-Cu-Ni metallic glasses owing to the difference of the electrical resistivity between the precipitation phases.     

大电流监测信号提取的光收发及信号处理

近年来,大电流的监测成了人们十分关心的问题,这是由于大电流有强磁、高压、电流大等一系列的直接监测所不能克服的问题。这就需要把高压大电流的强电信号,经过提取后变成能在实验室中直接观测的弱电信号。为此,如何从高压大电流的信号中提取出随实时信号变化而实时变化的小信号就变成了一个关键问题。详细介绍了监测信号提取的光收发电路原理和后续信号处理电路,分析了各部分的作用,给出了必要的分析结果。     

Study on ASTM E399 and ASTM E1921 standards

Costs of ASTM E399 and ASTM E1921 tests, which were developed to determine the fracture toughness (K_Ic) and the ductile–brittle transition temperature of ferritic steels, respectively, are considered high and the procedures are also very complicated. In this study, a method, which is more cost‐effective and easier to carry out, is proposed.     

过渡金属元素催化羟自由基反应机理研究

针对显色剂－过渡金属元素－过氧化氢体系，用分光光度法间接测定羟自由基。通过大量试验，确定了三苯甲烷类酸性酚醌吡喃类为有效显色剂，并确定了溴邻苯三酚红－亚铁离子－过氧化氢体系测定羟自由基的最佳条件，首次推测出其最可能的反应机理为：亚铁离子催化过氧化氢产生羟自由基，羟自由基氧化溴邻苯三酚红上的羰基碳氧双键，破坏其显色的共轭结构，使其褪色，此法可作为筛选羟自由基清除剂的有效方法。     

Effect of fiber types on relevant properties of porous asphalt

The research was conducted to evaluate the effects of cellulose and polyester fibers on the properties of porous asphalt mixes, using the tests of draindown, abrasion, volumetric properties, rutting, and moisture damage. Images of scanning electron microscopy and X-ray computerized tomography were adopted to identify the microstructure of the fiber and inner stone skeleton of porous asphalt. The influence of rutting parameter （G＊/sin δ） of asphalt modified by different fibers on the rutting resistance of the mixes was investigated. Based upon MOHR-COULOMB theory, the cohesion and the angle of internal friction of the mixes were derived from both indirect tension and unconfined compression strength. The experimental results indicate that fibers mainly stabilize asphalt binder and thicken asphalt film around aggregates. Furthermore, they result in the improved mechanical strength of porous asphalt mixes at high temperature slightly. From comparison analysis, cellulose fibers appear to perform better than polyester fibers in porous asphalt mixes.     

Influence of third monomer on the crystal phase transition behavior of ethylene-tetrafluoroethylene copolymer

Crystal phase transition between the low- and high-temperature phases has been investigated for ethylene (E)-tetrafluoroethylene (TFE) alternating copolymer (ETFE) containing the third monomeric species by the temperature dependent measurements of wide-angle X-ray diffraction (WAXD) and small-angle X-ray scattering (SAXS) and differential scanning calorimetry. Nonafluoro-1-hexene (NFH) and hexafluoropropylene (HFP) were chosen as the third monomers, where they are different in the side-branch length, -(CF₂)₃CF₃ and -CF₃, respectively. In the case of E/TFE/NFH copolymer (ET-C4F9), the crystal phase transition temperature of the original ETFE two-components copolymer was not very much affected by the existence of NFH in the range of NFH content from 0.7 to 3 mol%. Contrarily, the crystal phase transition temperature of E/TFE/HFP copolymer (ET-CF3) was found to decrease drastically with increasing HFP content. The melting temperature and the higher-order structure were also affected sensitively depending on the HFP content. This difference in phase transition behavior between ET-C4F9 and ET-CF3 copolymers is reasonably interpreted as follows: the short side groups (-CF₃) of HFP monomeric unit are included in the crystal lattice of E/TFE chains and the unit cell is expanded gradually with an increment of the HFP content, resulting in the decrease in phase transition point because of easier thermal motion of the chains. On the other hand, the long side groups [-(CF₂)₃CF₃] of NFH monomeric units are excluded out of the crystal lattice and located on the lamellar surfaces or in the amorphous region and do not affect very much the phase transition temperature even when the NFH content is increased. In association with such a change in crystal structure, the long period of stacked lamellar structure was found to decrease remarkably in the case of NFH, whereas it does not change very much for HFP, consistent with the interpretation of the above-mentioned WAXD data.     

Functional copolymer of geraniol and acrylonitrile: Synthesis and characterization

The radical copolymerization of acyclic terpene namely geraniol [GER] with acrylonitrile [AN] in DMF at (70 ± 0.1)°C for 1 h, using benzoylperoxide (BPO) as an initiator has been carried out under inert atmosphere of nitrogen. The kinetic expression for reaction is R_p ∝ [BPO]^0.5 [AN]^1.0 [GER]^1.0. The IR spectrum of the copolymer shows bands at 3432 and at 2244 cm^?1 due to ? OH group of GER and ? CN group of AN, respectively. The ¹³C‐NMR spectrum shows peaks at 73–75 δ ppm and 116–120 δ ppm due to ? OH group of GER and ? CN group of AN, respectively. The thermogravimetric analysis and differential scanning calorimetry study shows that copolymer is thermally stable up to 407°C and has glass transition temperatures (T_g) 56°C. The reactivity ratios r₁ (AN) and r₂ (GER) have been calculated as 0.05 and 0.005, respectively. The Alfrey‐Price Q‐e parameter for GER has been calculated as 0.094 and ?2.0, respectively. The molecular weights of the copolymers have been evaluated by gel‐permeation chromatography. © 2008 Wiley Periodicals, Inc. J Appl Polym Sci, 2008     

Time and temperature effect on the linear–nonlinear viscoelastic transition threshold of a polymeric system

In the present study, the transition of a polymeric material from the linear to the nonlinear viscoelastic behavior and the determination of the nonlinearity stress threshold variation with time and temperature are investigated. For this purpose a systematic experimental program consisted of thermal and mechanical characterization of certain polymeric material followed by isothermal creep tests at different stress levels and temperatures was conducted. Through isochronal curves that occurred from creep tests, the nonlinearity threshold dependence on both time and temperature is presented. The reported results provide information that is critical for the design and development of polymer structures and components. © 2008 Wiley Periodicals, Inc. J Appl Polym Sci, 2008