Relaxation phenomena caused by equilibration of point defects

Relaxation phenomena due to equilibration of point defects in metals are reviewed. The relaxation effect in specific heat observed in tungsten and platinum confirms that in both cases the nonlinear increase in the high-temperature specific heat has to be attributed to point-defect formation. Relaxation phenomena observed by measurements of electrical resistivity and positron annihilation are also considered. The comparison of the data seems to be favorable for the conclusion that all the phenomena are of one origin.     

新型缆用热熔胶的研制

分析了通信线缆用 YH- 4热熔胶组成原料的性能和作用 ,找出影响耐环境高温性能的主要原因 ,并对新研制出的耐环境高温性能 YH- 5热熔胶作了一些分析和探讨 .     

Stereological estimation of the total volume of MR visible brain lesions in patients with multiple sclerosis

Point counting represents a convenient and efficient technique for estimating the area of transects through multiple sclerosis (MS) lesions on magnetic resonance (MR) images obtained for sections through the brain. When sectioning has been performed according to the Cavalieri method, unbiased estimates of the total volume of MR-visible MS plaques can be obtained with a precision of 3–5% in 5–10 min.     

低功率激光治疗血管性头痛24例

低功率激光穴位照射治疗血管性头痛24例,总治愈率54.2%,好转率29.2%,无效率16.6%,但头痛部位、治疗经穴的不同,疗效差别很大。     

ZXJ10机IN业务功能扩展及实现

本文从智能网的基本概念入手,论述了利用 ZXJ10程控交换系统为发展智能网业务提供支持功能的技术策略以及分阶段实现的过程,并对各个阶段能够实现的业务作了简要介绍。     

降凝剂对高蜡稠油的改性效果及机理研究

实验研究了工业品原油降凝剂WHP改善含蜡56.9%、其中96.6%为正构烷烃的胜利郑王庄稠油流动性的效果。WHP含乙烯/醋酸乙烯/乙烯醇嵌段聚醚三元共聚物30%-35%。在60℃将WHP加入稠油中,测定其凝点和32℃、0-42.6 s^-1范围5个剪切速率下的黏度,均随WHP加量的增加（50-300 mg/L）而降低,200 mg/L为最佳加量,在该加量下0.32 s^-1黏度由34.16 Pa·s降至79.2 mPa·s,凝点（℃）、屈服值（Pa）、稠度系数（Pa·s^n）分别由49.0、32.42、31.57降至39.5、0.1297、0.02142,流型指数由0.1176升至0.9790。由黏温曲线求出,加入200mg/L WHP使该稠油析蜡点由65℃降至58℃,反常点由70℃降至50℃。根据空白和加剂原油扫描电镜照片显示的蜡晶形态,利用共晶机理分析讨论了WHP这种高分子表面活性剂的降凝、降黏、改善流动性的作用。图3表3参5。     

Activity measurement of the constituents in molten Fe–B and Fe–B–C alloys

The distribution ratios of Fe and B between molten Fe–B alloy and molten Ag were measured at temperatures between 1573 and 1923 K. Also, distribution ratios of Fe and B between molten Fe–B–C_satd. alloys and molten Ag were measured at 1873 K. It was found that the excess Gibbs free energy of mixing in molten Fe–B and Fe–B–C alloys can be expressed by utilizing the Redlich–Kister polynomial. The activity curves of the elements in molten Fe–B alloy and Fe–B–C alloy were estimated.     

矿用圆环链弯曲点的角度分布

矿用圆环链弯曲点是应力集中点 ,肩部断裂发生于该点附近 .以 2 6× 92矿用圆环链为研究对象 ,应用方向数据统计导出该点的角度分布 ,并给出了批量检验矿用圆环链尺寸匹配状况的一种方法     

Effects of shear flow on long-ranged correlations,spinodal demixing kinetics,and the location of the critical point and cloud point

A derivation of an expression for the shear rate-dependent Ornstein Zernike structure factor is discussed, together with the resulting anomalous behavior of the turbidity. The predicted scaling behavior of the turbidity, comprising the effect of both temperature and shear rate, is in good agreement with experiments on binary fluids. Then initial spinodal decomposition is discussed, and an explicit expression for the time- and shear rate-dependent effective diffusion coefficient is derived, which shows all the typical characteristics of anisotropic light scattering patterns that are observed experimentally for binary fluids. Next it is shown that the spinodal is shifted linearly with the (bare) Peclet number for not too large Peclet numbers, whereas the cloud point is singularly displaced into the unstable region due to a shear now. This is in agreement with an experiment on a two-polymer/solvent mixture and binary fluid mixtures. It is argued that light scattering is useless to determine the location of the spinodal of a sheared system.Paper presented at the Twelfth Symposium on Thermophysical Properties, June 19–24, 1994, Boulder, Colorado, U.S.A.