Preparation and Properties of Sintering Additives Coated Si3N4 from Heterogeneous Nucleation Processing

The sintering additives such as Al2O3 and /or Y2O3 were coated on the surfaces of Si3N4 particles via heterogeneous nucleation processing using a buffered pH solution as the precipitation reagent .They nucleated and grew only on the surfaces of Si3N4 and did not form sol particles in solution by TEM observation .The isoelectric point(IEP) of coated Si3N4 was different from that of as-received Si3N4.The IEP of Al(OH)3-coated Si3N4 occurred at pH8.4, which is close to that of alumina .When Al(OH)3-coated Si3N4 particles were coated with Y(OH)3,the IEP of coated Si3N4 powder shifted from pH8.4 to pH9.2 ,similar to that of yttria.In addition ,the rheological data showed that Al2O3 and /or Y2O3 coated Si3N4 suspension is nearly Newtonian and that added Si3N4 suspension shows a shear rate thinning behavior.     

起重机吊钩拖动绕线电动机他励双高调速系统

本文提出励磁电流可自动控制的他励式双高调速系统设计方案。系统在提升特别是在下放重物时，具有较硬的机械性；在负载１０－１００％的变化范围内，可实现最大偏差Δｎｍａｘ／ｎｍｉｎ１００％≤１０％，调速范围Ｄ≥１０；在满载运行条件下，可节约电能８０％以上。     

条形码中距离动态识别技术研究

本文讨论了条形码中距离动态识别技术中扫描景深与扫描光束波长和条宽等要素之间的关系，提出了改善条形码读取距离的３种方法。为扩大条形码在工业过程控制、企业管理等领域的应用范围提供了理论依据。     

Li2O在保护渣中的作用

采用在不同玻璃性的两种基渣中加入Ｌｉ２Ｏ为研究Ｌｉ２Ｏ对保护渣粘度，熔化温度及玻璃性能的影响，并对Ｌｉ２Ｏ改善保护渣玻璃性的机理进行了探讨，提出了寻找高速连铸保护渣中Ｌｉ２Ｏ的代用物的一种方法。     

关于Gibbs函数变关系式引出的探讨

本文推荐陈林根编著的《工程化学》对化学热力学基本公式△G=△H-T△S的引出方法,试探基础教学的改革。     

Calculation of second virial coefficients and gaseous viscosities of the refrigerants HFC-32 (CH2 F2), HFC-23 (CHF3), and HCFC-22 (CHC1F2)

The second virial coefficients of refrigerants HFC-32 (CH₂F₂), HFC-23 (CHF₃), and HCFC-22 (CHC1F₂) have been correlated on the bisis of site site model potential and have been compared with experimental results. The molecular interactions consisted of repulsion dispersion and electrostatic parts. From the site site potentials adjusted to the experimental second virial coefficients, spherically averaged potentials have been determined and a subsequent calculation of gaseous viscosity has been carried out. Agreement between measured and calculated values of second virial coellicients and gaseous viscosity is satisfactory. Calculated values of second virial coefficients and gaseous viscosity beyond available experimental data, therefore. can be assumed as a reliable extrapolation to lower and higher temperatures.     

高效防气防砂一体化管柱的研制与应用

为解决文南油田高气液比井出砂易造成卡泵的问题,研制了高效防气防砂一体化管柱。该管柱主要由闭式气锚、重力式防气装置和激光割缝筛管3部分组成。闭式气锚的分离作用消除了气体对抽油泵的影响,提高了泵效;重力防气装置利用液气分离原理和高烟囱原理进行液气分离,液流回流时间可达10min,排气最高压差可达0.2MPa;经激光割缝筛管过滤后的液体含砂粒外径小于0.05mm。该管柱在文南油田现场应用16井次,累计增液6000t,增油2717t,平均单井泵效提高7%。     

Effects of various post-treatments on carbon nanotube films for reliable field emission

In this report, the FE characteristics of carbon nanotubes (CNTs) treated using both thermal annealing and mechanical coatings on the as-grown CNTs systematically studied. It was found that in the high temperature annealed samples, CNTs were attacked at its root during annealing due to a small amount of oxygen, and were pulled out of the substrate in places after FE measurements because of the contact resistance. However, for the mechanically coated samples both with spin on glass (SOG) and polymethyl methacrylate (PMMA), CNTs were found to be nearly intact after FE measurements and showed reliable FE characteristics over repeatable voltage scan. The reliability of CNTs during FE could be owing to the strong adhesion of CNTs to the substrate both by SOG and PMMA coatings.     

我国天然彩棉的研发现状及发展趋势

对天然彩棉的历史、纤维特点、纤维的形态结构及性能作了简要介绍，重点介绍了我国彩棉的研发现状及研发中亟待解决的瓶颈问题，最后对彩棉在我国的发展前景进行了展望。     

现场总线控制系统中GPS精确校时的实现

针对现场总线控制系统精确校时和时间统一的要求,提出了3种利用GPS授时功能对总线式系统进行校时的方案.以GPSDEC授时型接收机为例,其校时可通过RS-232接口端ASCII码信息和DCF77信号、及输出端自定义脉冲信号实现.开放性要求高的大中型总线网络及通用的智能设备,当总线系统中的通讯协议具有时钟功能时,可采用广播式校时法对设备逐个校时.顺序式校时主要针对下层智能设备种类较多的大型总线系统内的前置通讯,并按通讯机的先后依次校时.对时间精度要求较高且下层智能仪表具有时钟同步信号接口的小型总线系统,宜采用单点式校时.