变频器在龙门铣床上的应用

介绍龙门铣床的直流调速控制系统的改造方案，根据龙门铣床工作台运动过程及原直流电机的容量来选择交流电机和变频器并对变频器的功能进行设定。     

PV module dynamic impedance and its voltage and frequency dependencies

The paper presents a derivation of the dynamic impedance of a PV module. At each bias voltage, the general form of the impedance describes a semicircular locus in the complex impedance plane. Intercepts of each impedance locus yield series, shunt and dynamic resistance of a module. Determinations of the dynamic impedance of a x-Si PV module in the dark with five reverse bias voltages and over a frequency range of 1 Hz to 60 kHz are made. The experimental results validate the derived general form of dynamic impedance.     

日本移动通信频率选择技术动向

本文介绍日本在移动通信中频率选择的技术动向以及开展移动通信频率资源的几项措施。     

FD—TD在分析FSS中的应用

本文讨论了用FD TD分析FSS的有关问题,提出了一种适合于在任意入射角情况下分析FSS的有效吸收边界条件,分别以单层、双层FSS为例进行了计算.数值结果和矢量模式法、谱域法的结果非常一致.     

低噪声晶振16次倍频源

本文介绍了低噪声高次倍频器的设计原理及低相位噪声晶振１６次倍频信号源。     

一种新颖的跳频振荡器

摘要本文综合考虑到频率合成技术及单端口体波谐振器HBAR的特点提出了一种基于一阶非线性PLL的锁相频率合成方案。文中对这种跳频方案的原理、性能特点作了详细论述、并通过实验、从不同角度对本方案进行了说明、同时对整机的各项指标作了详尽测试:在HBAR无载Q_N值为4000的情况下,该多模跳频振荡源的捷变范围为770MHz—840MHz、捷变时间小于20μS。杂散分量低于—60dB、二次谐波分量低于—34dB。离散捷变频率点为16点,构成闭环跳频系统后,对开环VCO的短稳改善了三个量级:从1.3×10~(-5)/ms到1.6×10~(-8)/ms及9.56×~(-7)/s到1.69×!0~(-9)/s,尤为重要的是该多模跳频振荡源达到此性能所需的硬件量很小,因此在对体积要求苛刻的场合、此种跳频方案具有极强的竞争力。     

A Novel Method Of Transport Barrier Formation

A novel technique is proposed for creating transport barriers by the rf waves. This is that the transport barriers can be created by the rf induced ponderomotive force itself and no rf induced flow shear generation is necessary. It is demonstrated that the ponderomotive force of the rf waves can stabilize the ion temperature gradient (ITG) mode, considered nowadays as the dominant source of anomalous energy losses in the low confinement (L) mode. It is also shown that this stabilization can be achieved for rather modest values of the rf power and hence should be easily obtained in actual experiments.      

实用型5GHz带宽InGaAs／InP PIN光电探测器

设计并研制成功了实用型５ＧＨｚ带宽ＩｎＧａＡｓ／ＩｎＰ ＰＩＮ光电探测器，介绍了限制探测器响应速度的主要因素，微波封装的理论依据，以及所研制器件频率响应的测试结果。     

Generalized adaptive notch filters with frequency debiasing for tracking of polynomial phase systems

Generalized adaptive notch filters are used for identification/tracking of quasi-periodically varying dynamic systems and can be considered an extension, to the system case, of classical adaptive notch filters. For general patterns of frequency variation the generalized adaptive notch filtering algorithms yield biased frequency estimates. We show that when system frequencies change slowly in a smooth way, the estimation bias can be substantially reduced by means of post-filtering of the frequency estimates. The modified (debiased) algorithm has better tracking capabilities than the original algorithm.     

Time jitter analysis of 1-bit sigma-delta synthesizer

This letter presents a general analysis of time jitter in sigma-delta synthesizer. One of the practical applications of 1-bit sigma-delta systems is a generation of high-resolution local oscillator (LO) signals. In order to generate LO signals, one may use a single-bit sigma-delta technique to encode sine waves. Today, direct generation of high-frequency sine wave using a clock with higher frequency, is possible. In this letter, we will analyze different LO signal generators and develop a practical way of computation to decide how to choose the best configuration under minimum degradation of signal-to-noise ratio (SNR) at the output.