互联网对中国企业未来的影响及对策

以可靠翔实的数据、案例分析了互联网技术的发展对中国企业未来的影响 ,揭示了中国企业互联网的应用现状 ,并针对目前存在的问题提出了我们自己应该采取的对策     

Experimental and analytical study on the spray characteristics of dimethyl ether (DME) and diesel fuels within a common-rail injection system in a diesel engine

This paper investigates the effect of injection parameters on the characteristics of dimethyl ether (DME) as an alternative fuel in a diesel engine with experimental and analytical models based on empirical equations. In order to study macroscopic and microscopic characteristics of DME fuel, this work focuses on the atomization characteristics of DME and compares experimental and predicted results for spray development obtained by empirical models for diesel and DME fuel. Detailed comparisons of spray tip penetration from three different empirical correlations and from visualization experiments of diesel and DME fuels were conducted under various fuel injection conditions. In comparison with the results of different empirical equations for measured spray tip penetration, the experimental results of this study provide good agreement with the calculation results based on empirical equations, except during the earliest stage of the injected spray sequence. The results of atomization characteristics indicate that DME showed better spray characteristics than conventional diesel fuel. Also, the fuel injection delay and maximum injection rate of DME fuel are shorter and lower than those of diesel fuel at the same injection conditions, respectively.     

Synthesis and characterization of polyaniline films using Fenton reagent

The chemical oxidation of aniline to form polyaniline (PANI) films and powder samples was made using Fenton reagent as an oxidizing agent in aqueous sulfuric acid medium. The PANI films were monitored by using the quartz crystal microbalance and the electronic absorption techniques. The optimum concentration was determined and the results were justified by measuring the UV–vis absorption spectra for the in situ PANI films. The conductivity for the PANI films and powder samples, prepared in different conditions, was measured. Also, the IR spectra, X‐ray and the thermogravimetric analysis for the PANI powder formed in the bulk were measured and compared with the polymer prepared using ammonium peroxydisulfate. A preliminary investigation to the dielectric properties of the polymer powder was measured and discussed. © 2008 Wiley Periodicals, Inc. J Appl Polym Sci, 2008     

管线油电损耗的灰色模型及预测

对于管道运输来说，影响输油成本变化的因素有很多，但是对总成本影响最大的是油电损耗费用。由于来自现场的输量和相关参数样本数据不足，只知道连续几年的流量、油电损耗，要预测将来每年的油电损耗，经典经济数学不能满足这样的研究。然而灰色系统理论要求的研究样本较少，只要知道连续几年的流量、油电损耗，就能预测将来每年的油电损耗，估算其输油成本，且模型精度较高。利用灰色系统理论，以输油管线每年的输量、相应的电耗和油耗为时间序列，建立了三元素非等间距GM(1，1)模型，该模型为预测管线年输油成本提供了可靠的依据。     

磨矿分级自动控制系统在选矿厂的运用

介绍了磨矿分级自动控制系统的控制原理、功能，以及在实际生产中的应用效果，以期推动磨矿自动系统在矿山中的应用。     

构建科学的企业文化体系

提出在企业文化建设中注意防止两种倾向;明确构建科学企业文化体系的内涵,物质文化、精神文化、制度文化和行为文化。     

PbS-Sb2S3-FeS三元系在水蒸气气氛下的铅锑分离

在1073K下通过测定三硫化锑和硫化铅的挥发速度,研究了PbS-Sb_2S_3-FeS三元系在水蒸气气氛下的铅锑分离规律。X-射线衍射结果表明,焙砂由PbS、Fe_3O_4、FePb_4Sb_6S_(14)、Pb_5Sb_4S_(11)和FeSb_2O_4组成。当试样中FeS含量在5％～7％时,铅锑分离效果最好。当试样中FeS的含量≥10％时,铅锑分离效果较差,这时过量的FeS会与Sb_2S_3和PbS形成复杂的硫化物(FePb_4Sb_6S_(14)、Pb_5Sb_4S_(11))或被氧化成F4Sb_2O_4,使锑的挥发变得困难,导致残留在焙砂中的锑含量升高。     

浅谈会计准则与会计制度

介绍了会计准则与会计制度的联系 ,分析了二者的差别 ,认为会计准则取代会计制度是可能的 ,也是必然的。     

泌阳凹陷层序地层样式和油气评价

在建立泌阳凹陷层序序列的基础上，系统研究了核桃园组的旋回结构。考虑箕状盆地结构、构造活动特征以及沉积物供源方式。分别论述了盆地陡坡、深凹和缓坡的层序地层样式，指出不同地形区的层序地层叠置样式主控因素是有差异的。综合层序地层学和石油地质分析结果，提出了岩性油气藏勘探的有利区带。     

武钢第二炼钢厂连铸坯喷号机自动控制系统

对武钢第二炼钢厂连铸坯喷号机自动化控制景统配置、网络通讯、伺服控制系统进行了阐述；经运行考验证明系统性能提高、稳定可靠。