Characteristics and classification of high-current fault arcs on distribution systems

When a fault occurs on transmission or distribution systems due to lightning or overvoltage, often an arc discharge occurs at the fault point. The arc discharge, which is caused by a fault current, has a high current, high temperature, strong light emission, etc., thus it sometimes causes heavy damages to electric power equipment. The arc discharge is influenced by the conditions around the arcs, i.e., gas, insulation materials, gap length, weather, etc. Also, the arc voltage along the arc column indicates the characteristics of the arc. If the voltage waveforms of the arcs caused by the fault on transmission or distribution systems are classified, it is possible to find the location and the equipment where the fault occurred. In this paper, the arc voltage data in 6-kV class XLPE cables and 6-kV class overhead lines are analyzed and an artificial neural network method is applied to classify the arc voltage waveforms. The results obtained from the six artificial neural networks developed show that the artificial neural network method is effective for classification of arc voltage waveforms if adequate input parameters are selected.     

百菌清及其三氟衍生物对番茄早疫病菌的室内抑菌活性比较

采用生长速率法测定了不同浓度的百菌清及其三氟衍生物对番茄早疫病菌Alternaria solani(Ell,et Mart.)Jones es Gmut的室内杀菌毒力。试验结果表明，百菌清及其三氟衍生物的ED50值分别为6089．89mg／L和156．43mg/L。，前者是后者的38．93倍。百菌清三氟衍生物的毒力明显高于百菌清。     

Properties of bioriented nylon 6 films related to film production technology

Four production steps, extrusion, blowing, stabilization, and finishing, are involved in the manufacture of biorented nylon 6 films. The films obtained after each step were studied by wide‐angle diffraction X‐rays, IR analysis, and density measurements. Orientation in the amorphous phase was evaluated by thermal retraction. Free volume was investigated by positron annihilation spectroscopy. Mechanical properties were tested by tensile tests, and permeability was tested with isopiestic permeameters. Quenching, after extrusion, generated an unstable γ crystalline phase and an amorphous phase. Blowing transformed the unstable γ phase into the thermodynamically stable α phase and increased the chain orientation; stabilization increased α phase crystals, favored hydrogen bond formation and, therefore, the mechanical properties, leaving unchanged the chain orientation; the final treatment increased the mechanical properties. The film permeabilities to O₂, N₂, and CO₂ were practically unchanged after each production step; this result may be explained by considering that the nanoholes, present in the films and responsible for the diffusion inside the polymer, maintained practically constant their radius, whereas their number concentration decreased slowly after thermomechanical treatments. © 2002 Wiley Periodicals, Inc. J Appl Polym Sci 86: 559–571, 2002     

三箱式纺丝技术生产PET/PA6复合纤维

介绍了采用三箱式纺丝技术生产PET/PA6复合纤维的设备及工艺。重点对纺丝箱体、纺丝温度控制进行了详细的讨论。     

Pt/C活性催化剂催化氢化合成6-氯-2-羟基喹喔啉

以对氯邻硝基乙酰乙酰苯胺为原料，在碱性条件下经环合及催化氢化合成6-氯-2-羟基喹喔啉。采用自制的Pt／C催化剂，考察了反应条件对产品收率的影响，在85℃，1．0～1．3MPa氢气压力下进行加氢还原反应，总收率89．6％(以对氯邻硝基乙酰乙酰苯胺转化为6-氯-2-羟基喹喔啉)。     

2,6-二乙酰基吡啶合成方法的改进

优化了2，6—二乙酰基吡啶的合成工艺。以2，6—吡啶二羧酸为原料，经过醇化及克莱森酯缩合反应，合成了2，6—二乙酰基吡啶，2，6—吡啶二羧酸二乙醇和2，6—二乙酰基吡啶的分离收率分别为94．1％和88．9％，2，6—二乙酰基毗啶的质量分数大于99％。     

6，7-二氢-5H-环戊烷并[b]吡啶

6,7-二氢-5H-环戊烷并[b]吡啶主要用于药物、杀菌剂和抗菌剂的研究,也被广泛应用于制备植物保护剂和合成树脂、防老剂以及塑料制品等。目前因其被作为第四代抗生素头孢匹罗的侧链而成为研究者竞相开发的热点。6,7-二氢-5H-环戊烷并[b]吡啶有实用价值的合成方法主要有N-羟基邻苯二甲酰胺法、丙烯醛法和己二酸二乙酯法。丙烯醛法中6,7-二氢-5H-环戊烷并[b]吡啶的收率为87.4%,具有较好的开发前景。     

FT-IR spectroscopic study of hydrogen bonding in PA6/clay nanocomposites

Fourier transform infrared spectroscopy was used to investigate PA6/clay nanocomposites (PA6CN) with various cooling histories from the melt, including rapid cooling (water-quenched), middle-rate cooling (air-cooling) and slow cooling (mold-cooling). In contrast to pure PA6 dominated by the α-phase, the addition of clay silicate layers favor the formation of the γ-crystalline phase in PA6CN.We focus on the reason why silicate layers favor the formation of γ-phase in PA6. Vaia et al. suggested that the addition of clay layers forces the amide groups of PA6 out of the plane formed by the chains. This results in conformational changes of the chains, which limits the formation of H-bonded sheets so that the γ-phase is favored. If this assumption is correct, PA6CN is expected to show some differences as compared with PA6 with respect to hydrogen bonding.The silicate layers were indeed found to weaken the hydrogen bonding both in the α- and γ-phases. This was also confirmed by X-ray diffraction studies. The γ-phase is most likely concentrated in regions close to the silicate layers, whereas the α-phase is favored in the bulk matrix.