注入剖面五参数组合测井仪的改进

文章介绍了注入剖面五参数组合测井仪及对该仪器的改进与完善，特别是对流量计的结构进行了改进。流量计下端采用水阻尼和机械弹簧两种保护措施，有效地保护了涡轮；过芯加重改成通用加重下挂到涡轮流量计上，有效地减少了涡轮粘污，提高了组合测井仪的测井成功率。改进后测井成功率从60％提高到90％。同时。对数据处理与传输电路也进行了改进，新开发研制了PPM码数据传输体系，使组合仪耐温指标提高到175℃。     

长庆油田陕北区原油破乳剂的筛选和复配

实验考察了8种市售水溶性破乳荆对长庆油田陕北区有代表性的宝塔区、安塞和子长原油(均为低硫中间基-石蜡基原油)的脱水效果(加量100mg／L，脱水温度55℃，时间3h)。目前长庆采油一厂使用的YT-100和延炼集团使用的GT-940对这3种原油的脱水效果均较好，但对子长原油的脱水率不高，分别为69．7％和58．9％。在由所选性能较好的破乳刺组成的4种二元复配物中，GT-940 HQ96-1对3种原油的脱水效果均高于单剂，最佳配比分别为4：1，4：1，3：2；其余3种复配物则对原油有选择性，其中GT-940 YT-100相近(97．5％)；YT-100 HQ96-1仅能改善子长原油的脱水效果，配比为4：1时脱水率最高(76．4％)；SP-169 HQ96-1仅能改善宝塔区原油的脱水效果．配比3：2和2：3时脱水率最高(92．9％)。表5参6。     

A fast evolutionary pursuit algorithm based on linearly combining vectors

In this paper, we propose a fast Evolutionary pursuit algorithm. It searches for optimal discriminant vectors through linearly combining standard bases. Experiments on the Yale and ORL databases verify its effectiveness and enhanced efficiency.     

Familiarity and plausibility in conceptual combination: Reply to Gagné and Spalding (2006).

E. J. Wisniewski and G. L. Murphy (see record 2004-22496-015) suggested that the apparent effects of relation frequency in C. L. Gagné and E. J. Shoben's (1997; see record 1997-02349-004) conceptual combination experiments could be explained by differences between the familiarity and plausibility of their stimuli (noun-noun phrases). However, C. L. Gagné and T. L. Spalding (see record 2006-20573-017) argued that Wisniewski and Murphy's measures of plausibility and frequency are both sensitive to relation frequency. They also suggested that the stimuli were mostly novel, such that differences in familiarity could not explain Gagné and Shoben's findings. The current authors focus on the theoretical rationale for the plausibility and familiarity variables, arguing that the original interpretation of their findings is correct. (PsycINFO Database Record (c) 2010 APA, all rights reserved)     

ALGORITHMIC SYNTHESIS OF GENERAL NON-SHARP SIMPLE DISTILLATION COLUMN SEQUENCES

An algorithmic approach was used to select recoveries for non-sharp sequence designs. Simple distillation columns were employed. The non-key component distribution was modeled using the Fenske equation. The combination of producing impure products and allowing non-key component distribution, results in a large search space. With this large search space size and software limitations, five problems were solved (see summary table in the Design Examples sub-section). The optimal non-key component distribution was found to be significant but not necessarily maximal. Parallel processing was selected as optimal in contrast to the more traditional sequential processing.     

Simultaneous mass and heat transfer under mixed convection along a vertical cone

Steady laminar binary mixed convection flow along a vertical circular cone under the combined buoyancy effects of thermal and species diffusion is studied analytically. The analysis is confined to mass diffusion processes with low concentration levels. In the analysis the surface of the cone is assumed to be at a uniform temperature and uniform concentration. Numerical results for the local Sherwood number, local Nusselt number and local friction factor are presented. Representative temperature, concentration and velocity profiles are also shown. The analysis covers the diffusion of common gases and vapours into air. Considerations are given to the situations where the buoyancy forces assist and oppose the forced convection flow for various possible combinations of the thermal and species diffusion processes.     

A new DSmT combination rule in open frame of discernment and its application

A new combination rule based on Dezert-Smarandache theory (DSmT) is proposed to deal with the conflict evidence resulting from the non-exhaustivity of the discernment frame. A two-dimensional measure factor in Dempster-Shafer theory (DST) is extended to DSmT to judge the conflict degree between evidence. The original DSmT combination rule or new DSmT combination rule can be selected for fusion according to this degree. Finally, some examples in simultaneous fault diagnosis of motor rotor are given to illustrate the effectiveness of the proposed combination rule.     

基于RTLinux和AD2S80A的角位置测量系统设计与实现

基于RTlinux和AD2S80A的角位置测量系统,选用旋转变压器和感应同步器作为测量系统的传感器,利用AD2S80A轴角变换器将两种测量传感器输出的模拟信号转换为相应的数字信号。根据双通道测角系统粗精耦合的原理,在RTLinux嵌入式系统中对两种数字信号进行耦合处理,并对耦合后信号的进行补偿处理,实现角位置的高精度测量。检测数据表明,这种测量系统可以实现以内的测量精度。     

有限元分析后处理中Surfer与Word的互接

为提高有限元分析后处理中等值线图的处理效率,利用VB Scripter编程实现Surfer等值线图的拼合,实现向Word中批量插入等值线图并为其设置格式、添加标题等功能.溪洛渡拱坝实例表明该程序可以减少有限元后处理的文件整理工作量.     

组合隔板式鱼道水力特性数值模拟研究

鱼道是为鱼类提供洄游通道的一种重要的工程措施。基于Flow-3D采用标准RNG k-ε紊流模型和Tru-VOF追踪自由液面方法,对鱼道池室内流场进行三维紊流数值模拟,研究池室内水流流速、流态空间分布,分析鱼道的水力特性对目标鱼类洄游上溯的影响。结果表明:溢流堰与竖缝组合隔板式鱼道在设计流速v=0.75 m/s条件下,竖缝处平均流速为0.83 m/s,竖缝处流速分布范围为0.76~0.89 m/s;堰上流速为0.90~1.12 m/s,回流区流速分布范围为0.09~0.25 m/s,流速大小在鱼类的克流能力范围之内,但靠竖缝隔板处存在明显的主流贴壁现象。为此开展了池室优化方案设计,使鱼道池室流态满足鱼类上溯要求。