光电对抗仿真试验系统综述

论述了研制光电对抗仿真试验系统建设的目的和意义,光电武器系统的现状和发展趋势,介绍了光电对抗仿真试验系统的一般组成,给出了光电武器系统的常规试验内容和试验流程,并论述了可能采用的试验方法。     

基于粗糙集信息观的决策表属性约简方法

粗糙集理论是近年来发展起来的一种有效的处理不精确、不确定、含糊信息的数学理论方法，它被广泛应用于相容和不相容决策表的属性约简和核属性计算。利用反例指出目前基于粗糙集信息观[2、6]的决策表属性约简和核属性计算方法的局限性。对决策表的性质作了深入的研究，研究发现文献[2、6]方法的不足原因是：它们没有考虑U／ind（C）中等价类的相客性。给出了基于U／ind（C）中等价类相客性的属性约简定义和核属性定义，并给出了一种新的基于粗糙集信息观的决策表属性约简和核属性计算方法。讨论了该方法同文献[2、6]方法的区别。最后用相同实例验证了该方法的有效性。     

采用自动双探边器降低芯片漏测率

半导体芯片的检测是芯片生产企业生产过程中的重要环节，芯片在检测过程中，由于圆形硅片的结构特点而造成的漏测又是困扰芯片生产企业不可小视的实际问题。本文介绍了利用双探边器解决由于硅圆片结构所造成的漏测的有效办法及具体操作方法。     

水量还原方法及合理性检查

文中详细地阐述了取河水、井水、水库水、跨流城引(排)水等不同情况进行还原的具体方法步骤。并对水量还原成果提出合理性检查措施。     

一种基于混沌同步的噪音衰减算法

论文提出了一种混沌通信系统的噪音衰减算法,该算法利用混沌同步现象在接收端获得正确的噪音估计值,从而从接收信号中滤除噪音恢复出正确的信号。通过数值仿真试验表明该方法是可行的。     

Synthesis of Rice Processing Plants. I. Development of Simplified Models

This article, the first of three articles on the synthesis of rice processing plants, focuses on the development of simplified mathematical models necessary for use in optimizing rice processing plants. The second concentrates on the optimal synthesis of a rice plant and the third on the sensitivity of the optimization to uncertainty in model parameters. Existing models for rice processing unit operations are not suitable for flowsheet optimization and new models need to be developed to overcome numerical difficulties that occur in optimization applications, specifically in mixed integer nonlinear programming (MINLP) applications. Simplified models of the drying, cooling, and tempering units are developed. In addition head rice yield models, used as a quality indicator, energy consumption, and economic models were also developed. Naturally, the new models exhibit some mismatch with respect to the existing models from which they were developed. However, a sensitivity analysis, presented in Part III, has shown that the optimal flowsheet structure was not sensitive to a lack of fit between the simplified and complex models. The simplified models were found adequate to be appropriate for use at the synthesis stage.     

井下乳化/水热催化裂解复合降黏开采稠油技术研究

实验考察了胜利孤东稠油井下催化水热裂解和乳化/催化水热裂解降黏效果。所用催化剂为水溶性铁镍钒体系,Fe3+∶Ni2+∶VO4+=5∶1∶1,100 g稠油与30 g 0.5%催化剂水溶液在240℃反应24小时。原始黏度(50℃)11.0和8.36 Pa.s的两种稠油裂解并静置除水后,黏度降低76.2%和75.6%,室温放置60天后降黏率下降小于3个百分点,气相色谱显示裂解后轻组分明显增加,红外光谱显示稠油组分发生脱羧反应且芳环数减少。讨论了稠油催化水热裂解反应机理。所用化学助剂JN-A在油水中均可溶,耐温达250℃,耐矿化度达50 g/L,其水溶液以30∶100的质量比与稠油混合时形成低黏度的O/W乳状液。当水相含1.0%JN-A和0.5%催化剂时,两种稠油水热裂解后的反应混合物为O/W乳状液,黏度仅为319和309 mPa.s,静置除水后的稠油降黏率增加到86.5%和87.3%,其中的轻组分含量进一步增加。该井下乳化/催化水热裂解复合降黏法成功地用于孤东两口蒸汽吞吐井,稠油井作业后初期采出的原油黏度由~9 Pa.s降低到1 Pa.s左右,随采油时间延长而逐渐升高,约50天后超过4Pa.s。图2表6参5。     

Use of X-ray computed microtomography to understand why gels reduce relative permeability to water more than that to oil

X-ray computed microtomography (XMT) was used to investigate why gels reduce relative permeability to water more than that to oil in strongly water-wet Berea sandstone. XMT allows saturation differences to be monitored for individual pores during various stages of oil, water, and gelant flooding. The method also characterizes distributions of pore size, aspect ratio, and coordination number for the porous media. We studied a Cr(III) acetate–HPAM gel that reduced permeability to water (at S_or) by a factor 80–90 times more than that to oil (at S_wr). In Berea, the gel caused disproportionate permeability reduction by trapping substantial volumes of oil that remained immobile during water flooding (i.e., 43.5% S_or before gel placement versus 78.7% S_or after gel placement). With this high trapped oil saturation, water was forced to flow through narrow films, through the smallest pores, and through the gel itself. In contrast, during oil flooding, oil pathways remained relatively free from constriction by the gel.     

基于系统矩阵有序实Schur分解的模型降阶

对复杂高阶系统进行模型简化，为研究与设计系统提供了方便的条件。对系统模型的降阶是控制系统设计与仿真工作者的一个重要研究课题，对高阶复杂系统的分析、设计、仿真等具有重要的理论意义和工程实用价值。针对目前比较成熟的基于系统矩阵的有序实Schur分解方法，提出了采用时矩输出拟合来改善降阶系统输出响应逼近程度的改进方法，从而使简化模型具有输出误差更小、计算简便等优点，通过给出的实例仿真证实了这一点。     

Role of Perceived Importance in Intergroup Contact.

Furthering G. W. Allport's (1954) contentions for optimal contact, the authors introduce a new construct: the perceived importance of contact. They propose that perceived importance is the best proximal predictor of contact's reduction of prejudice. If individuals have opportunities for contact at work or in the neighborhood, their chances to have intergroup acquaintances and friends increase. Intergroup contact among acquaintances and friends can be perceived as more or less important, which in turn determines intergroup evaluations. A 1st study shows that the new measure of perceived importance is indeed distinct from established quantity and quality indicators. The results are cross-validated in a 2nd study that also sheds light on the meaning of importance. In 3rd and 4th studies, structural equation analyses and a meta-analysis support the hypotheses. (PsycINFO Database Record (c) 2010 APA, all rights reserved)