负压条件下氧化法的煤气脱硫工艺

针对HPF法及PDS法煤气脱硫流程温度梯度存在的问题,中冶焦耐工程技术有限公司在济南信赢煤焦化有限公司的焦化项目中,首次采用了负压条件下以氨为碱源的氧化法煤气脱硫工艺。通过对脱硫生产装置的测试表明,控制脱硫液中的氨含量在6.0～9.0g/L、悬浮硫小于4g/L、催化剂浓度为15～20ppm、盐类总量不超过300g/L、溶液pH值8.0～9.0、液气比为35～38L/m3等指标后,脱硫塔后煤气含H2S小于300mg/m3,脱硫效率大于95%。     

负摩阻力计算及对桩承载力的影响

探讨了负摩阻力的计算方法及考虑负摩阻力时对桩承载力的验算，对软土层超过１５米，上部堆载大或地下水位大幅度下降地区的桩，尤其是端承桩而言，具有较大的工程实际意义。     

On the preparation and properties of CuZSM-5 catalysts for NO decomposition

Equilibrium exchange isotherms were determined for the exchange of Cu²⁺ with NaZSM-5 at varying Cu(Ac)₂ concentrations in solutions of constant volume and zeolite weight. At low Cu²⁺ levels the solid scavenged all the copper ions. When copper could be detected in the equilibrated solutions, overexchange was observed. The extent of overexchange was higher at pH 6 than at pH 4. These results were analyzed in relation to catalytic activity.On leave from the Central Institute for Chemistry, Hungarian Academy of Sciences, H1525 Budapest, Hungary.     

WALL AND PARTICLE-SHAPE EFFECTS ON HEAT TRANSFER IN PACKED BEDS

The effective radial thermal conductivity and apparent heat transfer coefficient for a packed bed were experimentally determined for beds of spheres, full cylinders and hollow cylinders, for flow rates giving particle Reynolds numbers in the range 100-1000, and for tube to particle diameter ratios of 5-12. Over these ranges the radial Peclet number Pe_r showed significant dependence on solid conductivity, gas flow rate and particle shape, while the wall Biot number Bi showed significant dependence on tube to particle diameter ratio, gas flow rate and particle shape. These dependencies were predicted well by equations incorporating the effects of these variables into individual gas and solid phase parameters, which were then combined to give the effective or lumped parameters     

Peel Adhesion of Poly(Vinyl Chloride) to Nitrile Rubbers

In addition to molecular interaction and physical entanglement of the molecular chains across the interface in poly (vinyl chloride)-nitrile rubber joints, at high temperatures and long contact times interfacial chemical bonds may be formed which seem to couple the two adherends thereby resulting in cohesive failure of the rubber matrix on peeling. This is verified by performing the peel tests at high temperatures, low peel rates and under swollen conditions. Infrared spectroscopic studies of the PVC/NBR blend reveal the formation of chemical bonds at the contact temperatures studied. The peel fracture energy is found to depend on the acrylonitrile content and presence of carboxylic content in the NBR, and the presence of stabilizer and plasticizer in the PVC phase, in addition to the molding and testing conditions.     

Synthesis and characterization of polyurea microcapsules containing essential oils with antigerminative activity

In this paper we report on the preparation and characterization of polyurea‐based microencapsulated systems, containing essential oils as core materials, for potential applications in controlled‐release formulations of agrochemicals. Microcapsules were synthesized by interfacial polymerization in o/w emulsion between polyfunctional isocyanates and diamines, to investigate the effect of the monomer kind on the morphology and properties of the produced samples. The synthetic conditions that gave the best results were used to microencapsulate four essential oils, able to interfere with the seed germination and radicle elongation of some test plants. The produced samples were characterized, with the aim to analyze their morphology and to verify the effectiveness of essential oil microencapsulation. Moreover, preliminary bioassay based on seed germination and subsequent radical growth were carried out to study the effects of the microencapsulated essential oils. © 2007 Wiley Periodicals, Inc. J Appl Polym Sci 2007     

Study of siloxane additives migration to the surface of polyester-(melamine)-polyurethane coatings: Aging effects after ethanol cleaning

This study determines the influences of siloxane flow agents’ migration on the outermost surface composition of clearcoats, before and after ethanol cleaning. This evaluation is undertaken to improve adhesion of pressure-sensitive adhesives (PSAs) on automotive paint systems. Most of the siloxane flow agents segregate from the bulk to the clearcoat outermost surface during curing. These additives can cover until 50% of the surface area but X-ray photoelectron spectroscopy (XPS) and time of flight-secondary ion mass spectrometry (ToF-SIMS) analyses indicate that they can be removed by ethanol cleaning. Composition of the cleaned clearcoats surfaces are similar as the composition of clearcoat formulated without siloxane additives: the polyester-(melamine)-polyurethane network is more detected than before cleaning. However, outermost surface analyses show that several aging weeks increase the siloxane additives segregation. This post-cleaning migration modifies the clearcoat surface composition and cancels the chemical modifications due to the ethanol cleaning. XPS analyses show that silicon concentrations after cleaning and aging are inversely proportional to the initial silicon concentrations measured after curing. It highlights that aging has to be controlled to improve adhesion of PSAs on clearcoats. A second ethanol cleaning on aged clearcoats is not effective to remove these new siloxane additives. Their formulation should be different from the flow agents and it could modify their solubility in ethanol. This result could also indicate that these new siloxane additives are not located on the last molecular layer of surface and they would not be soluble in ethanol.     

Synergistic effects of doped Fe3+ and deposited Au on improving the photocatalytic activity of TiO2

Fe³⁺ doped together with Au deposited TiO₂ (Au/Fe³⁺–TiO₂) was successfully prepared, which shows excellent photocatalytic activity for degradation of methyl orange (MO) under both UV and visible light (λ > 420 nm) illumination. Fe³⁺ has been confirmed by EPR to substitute for Ti⁴⁺ in the TiO₂ lattice, and Au exists as Au⁰ on the surface of the photocatalyst indicated by the results of XRD. Fe³⁺ and Au have synergistic effects on improving the photocatalytic activity of TiO₂. A proposed mechanism concerning the synergistic effects is discussed to explain the improvement of the photocatalytic activities.     

Sex pheromone communication in the nematode,Rhabditis pellio

Both males and females ofRhabditis pellio release pheromones that attract the opposite sex prior to copulation. A quantitative bioassay for the female-produced pheromone was designed, based on male movement toward a pheromone source placed at one end of a 10-mm strip of bacterial material maintained on nutrient agar in a petri plate. Females produced pheromone from the age at which they attained the adult stage (3 days following hatching from the egg) and maintained a relatively constant production level until at least the ninth day of life. Similarly, males became responsive to the female pheromone by the third day and remained responsive through the ninth day, although the time required for the males to migrate toward a female pheromone source increased with increasing age. No daily rhythm of pheromone responsiveness by males or pheromone production by females was observed when the nematodes were conditioned to a 1212 h light-dark cycle.     

温度影响下压实红粘土持水特性研究

通过渗析法和水汽平衡法研究不同温度控制下干密度1.7 g/cm~3压实红粘土持水特性(SWRC:soil water retention characteristics)。试验结果表明:20℃下干密度1.7 g/cm~3压实红粘土进气值约为110 k Pa;试样控制的温度越高,压实红粘土样持水能力越低,土样进气值随着温度升高而减小,且呈线性关系;Van Genuchten(1980年)土水特征模型能很好的描述干密度1.7 g/cm~3压实红粘土持水特性曲线。