Reward optimization of a repairable system

This paper analyzes a system subject to repairable and non-repairable failures. Non-repairable failures lead to replacement of the system. Repairable failures, first lead to repair but they lead to replacement after a fixed number of repairs. Operating and repair times follow phase type distributions (PH-distributions) and the pattern of the operating times is modelled by a geometric process. In this context, the problem is to find the optimal number of repairs, which maximizes the long-run average reward per unit time. To this end, the optimal number is determined and it is obtained by efficient numerical procedures.     

粒界缓冲型展宽效应对PTC材料温度系数的影响

本文利用相变扩张理论分析了粒界缓冲型展宽效应对BaTiO_3系PTC陶瓷的介电系数及温度系数a_r的影响,指出了晶粒尺寸和温度系数的关系。     

一种新颖的跳频振荡器

摘要本文综合考虑到频率合成技术及单端口体波谐振器HBAR的特点提出了一种基于一阶非线性PLL的锁相频率合成方案。文中对这种跳频方案的原理、性能特点作了详细论述、并通过实验、从不同角度对本方案进行了说明、同时对整机的各项指标作了详尽测试:在HBAR无载Q_N值为4000的情况下,该多模跳频振荡源的捷变范围为770MHz—840MHz、捷变时间小于20μS。杂散分量低于—60dB、二次谐波分量低于—34dB。离散捷变频率点为16点,构成闭环跳频系统后,对开环VCO的短稳改善了三个量级:从1.3×10~(-5)/ms到1.6×10~(-8)/ms及9.56×~(-7)/s到1.69×!0~(-9)/s,尤为重要的是该多模跳频振荡源达到此性能所需的硬件量很小,因此在对体积要求苛刻的场合、此种跳频方案具有极强的竞争力。     

InGaAsP／InP PFBH激光器

采用Ｎ－ＩｎＰ衬底研制ＩｎＧａＡｓＰ／ＩｎＰ激光器和ＤＦＢ激光器在国内已报导过多次，本文介绍用Ｐ－ＩｎＰ衬底研制ＩｎＧａＡｓＰ／ＩｎＰ平面埋层异质结构激光器和ＤＦＢ－ＰＦＢＨ激光器，同时利用晶体生长和晶向的依赖关系，改进埋区的结构，使器件最高激射温度大于１００℃。     

Equilibrium distribution of water in the two-phase system supercritical carbon dioxide–textile

When natural fibres are dyed in supercritical carbon dioxide, the addition of a small amount of water increases coloration. For a process design it is important to know how much water has to be added to obtain a desired humidity of both textile and carbon dioxide. In this work a thermodynamic model is proposed to calculate the distribution of water over the textile phase and the supercritical phase as a function of pressure and temperature. The phase equilibrium is described with Raoult's law for non-ideal fluids. The absorbed water in the textile is a condensed phase and is modelled here as a non-ideal liquid, using the NRTL-equation. The non-ideality of the supercritical phase is described by a solubility enhancement factor, a new equation derived from statistical thermodynamics. Although the model is applied to cotton, viscose, silk and wool, it can be used for all water absorbing textiles.     

电流控制LPE生长In_（1－x）Ga_xAs_yP_（1－Y）

用电流控制液相外延（ＣＣＬＰＥ）方法首次在（１００）ＩｎＰ衬底上成功地生长出Ｉｎ１－ｘＧａｘＡｓｙＰ１－ｙ（０．３０＜ｘ＜０．４７，０．７０＜ｙ＜０．９６）外延层，并对外延层特性进行了详细研究，提出在ＩｎＰ衬底上生长电外延层的机理，推导出生长动力学的理论模型，该模型与上述实验结果十分吻合。     

TiO_2对ZrO_2－NiCr金属陶瓷烧结特性和相稳定性的影响

本文研究了ＴｉＯ２掺入对ＣａＯ稳定ＺｒＯ２（简称ＣａＳＺ－ＮｉＣｒ）金属陶瓷烧结特性的影响，测定了ＣａＳＺ－ＮｉＣｒ－ＴｉＯ２金属陶瓷烧结样品的密度和显微硬度，结果表明，ＴｉＯ２的掺入能提高ＣａＳＺ－ＮＩＣｒ金属陶瓷的烧结密度和显微硬度，对ＣａＳＺ－ＮｉＣｒ金属陶瓷有助烧结作用．金相观察表明，ＴｉＯ３的掺入改变了ＮｉＣｒ相在金属陶瓷中的形貌，说明了ＮｉＣｒ与ＣａＳＺ的浸润性有一定的改善．ＸＲＤ和ＥＰＭＡ分析结果显示，ＴｉＯ２偏聚在ＮｉＣｒ金属相中，不影响ＣａＳＺ的稳定性．     

低空大气对连续波干涉仪系统相位稳定性的影响

针对三站连续波干涉仪系统，根据实时测得的系统场区大气折射率漂移数据，应用几何光学方法，从理论上估计了连续波干波仪系统两条微波基线传输的相位稳定性。     

Experimental investigation and thermodynamic modeling of the Mg–Sn–Sr ternary system

The isothermal sections of the Mg–Sn–Sr ternary system in the Mg-rich region at 415 and 350 °C have been determined using the scanning electron microscopy (SEM) equipped with energy dispersive X-Ray spectrometry (EDS). The existence of the MgSnSr ternary compound was confirmed in these two isothermal sections. Two new compounds, named Mg₅Sn₃Sr and Mg₂₅Sn₂₄Sr_14, were found in the present work based on the SEM/EDS results. Thermodynamic optimization of the Sn–Sr binary and Mg–Sn–Sr ternary systems were carried out using the CALPHAD (CALculation of PHAse Diagrams) technique. The Modified quasi-chemical model (MQM) was used for the liquid solution which exhibits a high degree of short-range ordering behavior. The solid phases were described with the Compound energy formalism (CEF). Finally, a self-consistent thermodynamic databases for the Mg–Sn–Sr ternary system has been constructed in the present work, which can be an efficient and convenient guidance to investigate and develop the Mg-based alloys.