Formation of steady state size distribution of precipitates in alloys under cascade-producing irradiation

The effect of coherency loss on the development of precipitate size distribution under cascade-producing irradiation is considered. The nucleation of coherent precipitates, their growth followed by coherency loss and cascade-induced dissolution of large incoherent precipitates can occur simultaneously resulting in formation of a quasi-stationary size distribution of semicoherent precipitates. To describe this process we consider co-evolution of a mixed population of coherent, semicoherent and incoherent precipitates. Mathematically, the problem is formulated as a set of discrete rate equations of nucleation kinetics (the Master equation approach) which is also used for later stages of evolution. To solve the corresponding large set of equations (typically, more than 10⁵ equations) an efficient numerical method is developed. The simulation results obtained for material parameters and irradiation conditions typical for nuclear reactors show that the coherency loss affects considerably evolution of the precipitate population. Under certain irradiation conditions, both in solution-annealed alloys and in aged ones, the mean precipitate size and the number density during prolonged irradiation tend to steady state values, whereas the size distribution function of large precipitates narrows. The width of the quasi-stationary size distribution is controlled by cascade parameters. It was found that the asymptotic quasi-stationary state of the precipitate population may depend on initial state of the alloy.     

坨五站中间乳化层快速增长原因及治理方案

胜利采油厂坨五站高含水(95％)原油化学预脱水中，二级沉降罐内油水相之间的中间乳化层增长迅速，引起了一系列问题。现场调查和大量室内测试结果表明，产生这一现象的原因有：油溶性破乳剂WD-1加入点不合理。有2／3的含水原油在通过油水分离器之后才与破乳剂混合；二级沉降罐进油口伸入油相内，油流的冲击达不到中间层；WD-1对坨五站混合原油中的稠油破乳脱水性能欠佳，不能适应坨五站混合原油组成和含水的变化。针对上述各种原因筛选出了性能更好的一种破乳剂1916。根据确定的几种原因采取了相应的措施：将破乳剂加入点改在3个并联油水分离器之前；将二级沉降罐的进油口移到水相内；改用筛选出的破乳剂1916，结果使中间乳化层的增长受到了抑制。图2表4参2。     

L波段窄脉宽500W固态功放组件的设计

介绍了作者研制的应用于固态雷达发射机上的L波段500W固态功放组件的工作原理、用途及其主要技术指标。描述了功放组件的设计过程和测试结果。该功放组件在窄脉宽条件下实现了快速上升沿,性能优良,工作稳定可靠。     

Equilibrium Moisture Characteristics of High Oleic Sunflower Seeds and Kernels

The equilibrium moisture content (EMC) characteristics of high oleic sunflower seeds and kernels between 10 and 55°C were determined by equilibrating the samples to known relative humidities (RH) above saturated salt solutions. EMC of the kernels was lower than that of seeds in the range of 11 to 96% ERH and at 25 and 40°C. Hysteresis effect was found for the EMC properties of seeds and kernels at 25°C. Four EMC-ERH models (modified Henderson, Chung-Pfost, Halsey, and Guggenheim-Anderson-de Boer) and their estimated parameters were evaluated for goodness of fit. GAB and Halsey equations showed the best fitting of experimental data although GAB equation adjusted for temperature described the EMC data the best. Components of the seed as oil content or hull/kernel ratio did not explain the slight differences in EMC found between the varieties.     

Formation of ordered microporous films with water as templates from poly(D,L‐lactic‐co‐glycolic acid) solution

Recently a method that uses water droplets at the air–solution interface as an ordered template was reported for the preparation of ordered micrometer‐size honeycomb structures. Here we show that the method can also be used for formation of honeycomb‐like porous films from random copolymers with certain hydrophilicity, besides those polymers with defined structures such as block copolymers, starlike homopolymers, amd amphiphilic polymers. This demonstrates that the stabilization of water droplets is the key factor for the regular structure. Also we indicate that size and structure of the films can be regulated by such variables as concentration and atmospheric humidity. © 2003 Wiley Periodicals, Inc. J Appl Polym Sci 90: 1846–1850, 2003     

Thermal expansion characteristics of a titanium modified austenitic stainless steel: measurement by high-temperature X-ray diffraction and modelling using Grüneisen formalism

The thermal expansion of a titanium modified, swelling resistant austenitic stainless steel designated as D9 is studied by measuring the lattice parameter as a function of temperature in the range 300-1300 K by high-temperature X-ray diffraction technique. The thermal expansion data thus obtained is in reasonable agreement with the typical thermal expansion values reported for similar nuclear grade austenitic stainless steels. However, at temperatures exceeding 900 K, the measured thermal expansivity exhibits a pronounced non-linear increase due partly to the precipitation of complex carbide and intermetallic phases. The high-temperature thermal expansion data obtained in the present study are augmented by modelling the low-temperature thermal expansion behaviour by Grüneisen formalism.     

水稻花后衰退珠心和胚乳发育初期Ca2+的超微细胞化学定位

应用焦锑酸盐沉淀技术对水稻花后衰退珠心和胚乳发育初期进行了Ca^2 的超微细胞化学定位。结果显示在初始衰退的珠心细胞中Ca^2 主要分布于液泡膜上和核内；在衰退中期的珠心细胞中，Ca^ 主要分布在核膜、液泡膜及质膜上；在严重衰退的珠心细胞，Ca^2 仅存在于液泡中。珠心降解的Ca^2 跨过胚囊壁，通过质外体向胚乳内运输；发育初期的胚乳细胞，Ca^2 主要位于胞间隙，线粒体和液泡中也有少量分布。讨论了Ca^2 与珠心PCD的关系。     

我国石油开采与油井管生产概述

概略介绍了我国石油开采及其专用管材的需求情况以及油井管的生产规划和要求,对发展国内油井管特别是焊接油井管生产提出了建议。     

涤棉府绸染色条花疵病的产生和控制

本文分析了T/C府绸集色条花产生的原因。通过工艺条件和操作方法,染色条花疵病得到明显改善。     

三辊穿孔和轧管所产生的钢管壁厚极差和波浪形内螺纹

定量描述了实际生产过程中三辊斜轧穿孔所产生的钢管壁厚极差和波浪形内螺纹，初步探讨了三辊轧管机对钢管壁厚极差和波浪形内螺纹的影响。