混合结构楼房爆破拆除倒塌范围的确定

通过对混合结构楼房爆破倾倒过程特点的分析,提出了楼房在倾倒过程中的运动计算模型,并应用体积平衡原理,得到这类楼房爆破爆堆参数计算公式,用该公式计算的结果与实例中爆堆实测数据相比较,相对误差不超过11%.     

羰基铁类随机混合吸波材料等效电磁参数的计算

本文为计及多重散射偶极子间的相互作用，引入参量εｈ和μｈ，导得一组公式。它不仅能计算铁氧体类也能计算羰基铁类的随机混合吸波材料的等效电磁参数，均与实验结果吻合良好。     

均匀设计在遗传算法中的应用研究

通过分析均匀设计和遗传算法的内在关系，指出从某个角度上可以把均匀设计看作是遗传算法的一种特例，并针对遗传算法初始参数众多、难配置的问题，提出了利用均匀设计优化配置选择参数的方法，在一定程度上可以避免遗传算法参数配置的盲目性．仿真试验结果证明了该方法是合理、可行的。     

宣汉——达县地区飞仙关组储层预测方法研究

在宣汉-达县地区,以往仅依据地震属性来预测飞仙关组储层分布,钻探结果与实际情况不符,为此本文提出量化分析预测结合主参数分析的新方法和新思路。在量化分析中首先对飞仙关组储层进行高分辨率反演,获得储能系数图;然后结合主振幅剖面和主频率剖面分析,对储层进行预测。在研究区,本方法的预测结果与实钻情况相吻合。     

对数正态概率纸的自动生成和分布参数的自动提取

采用对数正态概率纸可以直观地判断一组数据是否服从对数正态分布，而且还可以得到对数正态分布参数，即对数均值和对数标准差。介绍对数正态概率纸自动生成和分布参数自动提取的方法以及据此开发的软件。与手工使用概率纸的常规方法相比，采用所开发的软件不但使用简单、方便，而且能提高计算结果的精度。     

Color characteristics of Cu-Zn-Al alloys

ＣＯＬＯＲＣＨＡＲＡＣＴＥＲＩＳＴＩＣＳＯＦＣｕ－Ｚｎ－ＡｌＡＬＬＯＹＳ￣①Ｌｉ，Ｂａｏｍｉａｎ；Ｚｈａｎｇ，Ｘｉｕｈｕａ（ＳｈｅｎｙａｎｇＩｎｓｔｉｔｕｔｅｏｆＧｏｌｄＴｅｃｈｎｏｌｏｇｙ，Ｓｈｅｎｙａｎｇ１１００１５）ＣＯＬＯＲＣＨＡＲＡＣＴＥＲ...     

Structural and electrical properties of brush plated ZnTe films

Zinc telluride thin films were deposited by the brush plating technique at a potential of −0.90 V (SCE) on conducting glass and titanium substrates at different temperatures in the range 30–90 °C. The films were polycrystalline in nature with peaks corresponding to the cubic phase. Direct band gap of 2.30 eV was observed. XPS studiers indicated the formation of ZnTe. Depth profiling studies indicated a uniform distribution of Zn and Te throughout the entire thickness. EDAX measurements were made on the films and it was found that there was a slight excess of Te. The carrier concentration was found to vary from 10¹⁴–10¹⁵ cm⁻³ with increase of substrate temperature. The mobility was found to vary from 5 to 60 cm² V⁻¹ s⁻¹.     

混凝土大坝导温系数反演及其随时间变化的规律

随着时间的推移,混凝土的导温系数将发生变化,为了了解参数随时间的变化规律,利用原型观测资料对导温系数进行分段反演,从而拟合出大坝混凝土导温系数随时间的变化规律.     

Testing of electrochromic materials using symmetrical devices

“Symmetric materials” devices, where both electrodes are made of the same electrochromic materials, allow the in situ study of side reactions. Each transferred charge that is not used for the expected electrochromic reaction will cause a colour change in the whole symmetric device. Two electrochromic materials, WO₃ and IrO₂, are successively used to show how to obtain information about side reactions such as faradaic efficiency, reversibility and potential limits from the symmetric experiment. This in situ approach with a polymer electrolyte shows significant differences compared to results obtained with studies in aqueous electrolytes.     

Polyaniline-multiwalled carbon nanotube composites: Characterization by WAXS and TGA

Polyaniline/carboxylated multi-walled carbon nanotube (PAni/c-MWNT) nanocomposites have been synthesized by micellar aided emulsion polymerization with various c-MWNTs compositions, viz., 0.5, 1, 5, and 10 wt %. The microcrystalline parameters such as the nanocrystal size (〈N〉), lattice strain (g), interplanar distance (d_hkl), width of the crystallite size distribution, surface weighted crystal size (D_s), and volume of the ordered regions were calculated from the X-ray data by using two mathematical models, namely the Exponential distribution and Reinhold distribution methods. The effects of heat ageing on the microcrystalline parameters of the PAni/c-MWNT nanocomposites were also studied and the results are correlated. The thermal stability and electrical resistivity of the PAni/c-MWNT nanocomposites were examined with thermogravimetric analysis (TGA) and a conventional two-probe method. The TGA data indicate that the thermal stability of the nanocomposites improved after the incorporation of c-MWNTs. The influence of temperature on the resistivity of the nanocomposites was also measured. © 2008 Wiley Periodicals, Inc. J Appl Polym Sci 2008