Zero aliasing ROM BIST

Signature analyzers are very efficient output response compactors for BIST design. The only limitation of signature analysis is the fault coverage reduction (aliasing) due to the information loss inherent to any data compaction. In this article, in order to increase the effectiveness of ROM BIST, we take advantage from the simplicity of the error patterns generated by ROMs and we show that aliasing free signature analysis can be achieved in ROM BIST.This work was performed when the author was on leave from Minsk Radio Engineering Institute, Computer Department, Belorus.     

受干扰波相位测量的一种新方法

为了测量受噪声和谐波干扰的两个信号间的相位差，基于自适应带通滤波器（ABF）和测量信道交换技术，提出了一种新的测量方法。ABF采用可编程开关电容滤波器（PSCF）和锁相环，明显地抑制了噪声和谐波干扰，频率跟踪范围超过四个倍频程（0．5Hz-6kHz）。用微处理器控制4个开关来交换测量信道，可以基本上消除测量通道引入的附加相位移。两种方法结合提高了相位差的测量精度。实验说明了该测量方法的有效性，该方法也适合于被测信号为慢时变情况。     

采用信息融合技术的IR／MMW复合导引头的目标跟踪

从误差测量环节入手，基于IR／MMW双模结构，采用信息融合处理技术提高其估计跟踪精度，最终达到降低制导误差，提高武器性能的目的，仿真结果验证了该方法的有效性。     

Influence of Coherent Flow Structures on the Dynamics of Suspended Sediment Transport in Open-Channel Flow

The influence of suspended sediments on coherent flow structures has been studied by simultaneously measuring the longitudinal and vertical components of the instantaneous velocity vector and the instantaneous suspended particle concentration with an acoustic particle flux profiler. The measurements were carried out in clear water and in particle-laden open-channel flows. In both cases, they clearly show the predominance of ejection and sweep phases that are part of a burst cycle. The analysis further demonstrates the importance of the ejection and sweep phases in sediment resuspension and transport. Ejections pick up the sediment at the bed and carry it up through the water column close to the surface. It is shown that ejections and sweeps are in near equality in the near-bottom layer, whereas ejections clearly dominate in the remaining water column. The implications of these results for sediment transport dynamics are discussed.     

非AWGN环境下调制类型自动识别

在非AWGN环境下，针对CW，AM，FM，OOK，PSK，QPSK，16QAM，FSK，MSK，SSB十种混合调制信号，对调制类型特征提取方法和自动识别算法进行了分析、综合、设计和计算机仿真。提出了梯层电平分析方法、频率瞬时信号分析、剔除载波的归一化能量分析、平方后信号的频谱分析、四次方后的信号频谱分析等方法。当SNR=10dB时，计算机仿真结果是正确识别率不低于95％，自动识别的平均处理时间为不超过10s。     

基于移动端多天线系统的无线衰落信道模型

根据当前无线移动通信对多天线移动接收端性能仿真的要求，讨论并建立了适于空时信号处理的移动端矢量信道模型。通过分析无线移动信道特点。研究了影响接收信号幅度相位的诸多因素，建立了相应的数学模型。并对随机参数选取进行了探讨。其中考虑到移动端接收信号到达角扩散的特点，采用GBSB椭圆模型产生了适于移动端接收信号仿真的随机角度，改进了一种瑞利衰落生成算法。最后信道的数值仿真结果符合理论和经验。同时，通过TD-SCDMA系统链路级仿真，也证明了该信道模型的有效性。     

ECAP细化晶粒法的仿真与分析

ECAP(Equal Channel Angular Extrusion)方法，是实现材料纯剪切变形的有效方法。本文采用有限元（FEA）分析软件ANSYS对Al的挤压过程进行仿真与分析。分析结果表明：外切角Φ、圆角半径、试样与凹模之间的摩擦系数、凹模本身的特性（如弹性模量、泊松比等）等等，对材料的变形量都有不同程度的影响。     

An adaptive non‐conforming finite‐element method for Reissner–Mindlin plates

Adaptive algorithms are important tools for efficient finite‐element mesh design. In this paper, an error controlled adaptive mesh‐refining algorithm is proposed for a non‐conforming low‐order finite‐element method for the Reissner–Mindlin plate model. The algorithm is controlled by a reliable and efficient residual‐based a posteriori error estimate, which is robust with respect to the plate's thickness. Numerical evidence for this and the efficiency of the new algorithm is provided in the sense that non‐optimal convergence rates are optimally improved in our numerical experiments. Copyright © 2003 John Wiley & Sons, Ltd.     

A Novel Channel Predictor Based on Constrained Hidden Markov Model

1　Introduction　Linkadaptationtechniqueisnowwidelyrecognizedasakeysolutiontoincreasethespectralefficiencyofwire lesssystems[1～ 3] .GPRS ,EDGE ,cdma2 0 0 0andWCDMAallincludelinkadaptationasameanstopro videhigherdatarates[4～ 5] .Torealizethepotentialoflinkadaptation ,reliablechannel predictionisneces sary[6 ] .　Therearemanydifferentchannelpredictionmethodsavailablenow ,suchasLongRangePrediction(LRP) [6 ] ,predictionbasedonsubspacesignalprocess ingalgorithms[7] ,predictionbasedonFinit…     

分布系统中多米诺效应的分析与消除

分布系统中发生故障后,错误信息在进程间的传播,以及由此引起的系统恢复过程中的多米诺效应是分布系统容错恢复技术所面临的最重要与最困难的问题.目前各种研究工作偏重于具体的系统动态恢复技术.本文的研究重点在于首次揭示多米诺效应本身固有的数量特征及其与分布系统技术参数间的联系,给出多米诺效应动态消除技术,引入系统额外开销的下限,并针对动态技术的缺点,探讨多米诺效应的静态消除技术,为解决困难开辟新途径.