三自由度模型覆冰输电导线舞动的数值仿真分析

基于考虑输电导线垂直、水平和扭转振动耦合的3自由度模型,利用数值方法,针对系统参数和环境参数对临界风速的影响以及可能的复杂舞动模式进行了分析.给出了覆冰厚度、初始覆冰角度、来流密度、导线初始张力、单位长度质量和横向阻尼比对临界风速的影响曲线.在讨论舞动可能出现的复杂运动时,发现随风速的变化,由于周期运动的分岔可导致概周期运动和混沌等复杂运动形式.     

挠性转子磁力轴承系统LQ最优控制研究

在高温气冷堆氦气透平发电系统（HTR—IOGT）的相似性模拟实验装置AMB—PⅡ上,开展针对磁力轴承支承下挠性转子系统的优化控制研究。采用离散质量的集总参数法建立了相应转子动力学模型,通过适当模态截断简化获得了转子系统的状态方程。研究了LQ最优控制方法,分析了权重参数的选择对控制器的影响。仿真实验表明,输出反馈LQ结合相位补偿的控制器,具有物理意义清晰、系统结构简单和参数易于调节等优点。在AMB—PⅡ实验台架上不仅实现了转子的稳定悬浮,而且能够有效地抑制转子的高阶挠性模态振动,使转子顺利通过了二阶挠性临界转速,最高达到450Hz。该方法的研究为今后高温气冷堆氦气透平工程的磁力轴承实际应用提供了良好的设计参考。     

关于AOE网中关键路径求解算法的研究

介绍AOE网中关键路径的相关概念,通过算法描述和实例,探讨基于拓扑排序求解、P矩阵的求解和广度优先搜索遍历（BFS）方法三种算法,求解AOE网中关键路径的实现过程,并进一步从算法的时间复杂度、数据结构形式及实现的容易程度等几方面分析三种求关键路径算法的优劣。     

震后裂缝危岩体诊断技术研究

震后山体结构破碎,崩塌频发,严重的制约着灾后重建工作。为此,从震后岩体实际结构状况出发,在分析诱发岩体崩塌的破坏性外力类型的基础上,借助断裂力学理论,通过合理建模,阐明了震后岩体崩塌的机理,给出了崩塌发生的条件,为震区可预知余震强度区的危岩体诊断和排查提供了技术支持。最后通过算例及分析表明：余震、降雨及其相互耦合作用是震后崩塌的根本动力;在特定外力下区内岩体裂缝发生扩展存在最小临界深度;外力耦合条件下裂缝失稳临界深度最小     

土与混凝土接触面反向单剪本构模型

土与混凝土接触面的反向剪切性质是土木工程中一个重要的课题。根据接触面反向单剪试验结果,定量分析了正向剪切历史对不同含水率接触面反向抗剪强度、摩擦角、黏聚力等因素的影响,给出了相关的经验公式。提出了接触面临界正向剪切比的概念。根据改进的应力应变方程,建立了接触面正反向剪切模量公式,其包含了10个土体参数,均可通过接触面试验求得。确定了该公式中各参数的取值方法,推荐了初步的取值范围。进行了不同正向剪切比情况下的接触面剪切应力应变模拟,得到良好的模拟效果。研究成果可供相关的工程设计参考。     

Interfacial tension of demixed polymer solutions near the critical temperature: polystyrene + methylcyclohexane

Interfacial tension between demixed solutions of polystyrene + methylcyclohexane has been measured near the critical temperature as a function of temperature using polystyrenes with molecular weights 9000 ～ 1.26 × 10⁶. The critical exponent for the interfacial tension was determined to be about 1.30 for the lower molecular weight systems. However, for higher molecular weights the exponent could not be obtained because the system departed from critical behaviour. Magnitudes of the interfacial tension were proportional to about N^?0.44, where N is the polymerization index. Experimental results were compared with the recently-proposed theories and found to be in qualitative agreement. The tricritical theory of polymer solutions was also compared with the experimental results.     

Estimation of the critical properties of compounds using volume-based thermodynamics

The importance, yet scarcity of the critical constants of thermally unstable fluids warrants the development of reliable methods for the estimation of these essential thermodynamic properties. A thorough investigation undertaken in this study on 1,589 compounds belonging to 83 chemical classes, indicated that the ratio of critical temperature to critical pressure of both low and high molecular weight compounds could be well expressed in terms of their volumetric properties. In addition, two new methodologies are presented for estimating V_c, as well as an indirect approach for prediction of T_c from surface tension data, altogether allowing the calculation of Z_c. Moreover, comparative studies are made with five group contribution methods. It is also demonstrated that by employing the Peng-Robinson EOS, and without prior knowledge of the critical properties, it is possible to calculate various thermophysical properties including P^sat., T_b, , ∆H^vap. , C_p, and even the T_c and P_c themselves.     

Relationship of structure to properties of surfactants. 16. Linear decyldiphenylether sulfonates

The properties of some well-characterized sodium linear decyldiphenylether (C₁₀DPE)sulfonates have been studied. Among the properties investigated are dynamic and equilibrium surface tension, critical micelle concentration (CMC), area per molecule at the aqueous solution/air interface, wetting time by the Draves technique, foaming by the Ross-Miles method, solubilization, and hydrotropy. The decyldiphenylether moiety appears to be equivalent to a terminally substituted straight alkyl chain of 16 carbon atoms. The trialkyl- and dialkyl-mono-sulfonates have solubilities of < 0.01 g/dm³ in water, but are readily soluble in hexane. The didecyldiphenyl ether disulfonate (DADS) has a very low CMC value (1.0 × 10⁻⁵ mol dm⁻³) in aqueous 0.1 N Na⁺ solution (NaCl), characteristic of surfactants with two hydrophilic and two hydrophobic groups. It also has a much larger area per molecule at the aqueous solution/air interface than the monodecyldiphenyl-ether monosulfonate (MAMS) and a much higher surface tension at the CMC. MAMS has a much lower surface tension at a surface age of 1 second (γ_1s) than either DADS or the monodecyldiphenylether disulfonate (MADS). In agreement with γ_1s and γ_eq values, wetting times increase in the order: MAMS < DADS < MADS and initial foam heights decrease in the order: MAMS > DADS > MADS. Solubilization for three water-insoluble surfactants decreases in the order: DADS > MAMS > MADS, while hydrotropy is most pronounced with the disulfonates.     

Investigations of fluid dynamics in mechanically stirred aerated slurry reactors

The fluid dynamics of stirred aerated slurry reactors with A-310® propeller, 4-blade 45° pitch turbine and 6-blade Rushton disc turbine were studied over a wide range of gas flow rates. With respect to power consumption, gas hold-up, and fluid dynamically limiting cases, viz., suspension and flooding, the Rushton disc turbine was found to be the best in stirred aerated slurry reactors. The influence of particle density, shape and mass fraction and of liquid properties on gassed critical stirrer speed, N_jsg, and of gassed power input per unit volume, P_jsg, on particle suspension and gas dispersion, were investigated. Empircal correlations in combination with that of Zwietering were established for scale-up design in three-phase slurry reactors.     

飞机水平盘旋下弹性支承转子的特性研究

为研究转子系统在一定的外激励下的特性,使得研究与实际状况更加吻合,采用Jeffcott转子弹性支承模型,建立飞机处于水平盘旋状态下弹性支承转子系统的运动微分方程.运用Runge-Kutta数值法研究了飞机水平盘旋下处于一定角速度的刚性和弹性不同支承情况下的瞬态响应,并对仿真结果进行对比分析.结果表明,由于弹性支承使其转轴刚度降低,其临界转速随之降低;处于同一角速度下的弹性支承比刚性支承进入稳定振动的时间长,比刚性支承振动幅度大;弹性支承和刚性支承在同样的情况下转动都会产生稳定的周期解;因此可以通过对转子系统支承刚度的适当调节,可以达到优化系统性能的目的.