全文获取类型
收费全文 | 84830篇 |
免费 | 11507篇 |
国内免费 | 8381篇 |
专业分类
电工技术 | 8245篇 |
技术理论 | 3篇 |
综合类 | 12901篇 |
化学工业 | 5946篇 |
金属工艺 | 2763篇 |
机械仪表 | 7407篇 |
建筑科学 | 8168篇 |
矿业工程 | 2645篇 |
能源动力 | 2306篇 |
轻工业 | 3529篇 |
水利工程 | 2956篇 |
石油天然气 | 2420篇 |
武器工业 | 1487篇 |
无线电 | 9040篇 |
一般工业技术 | 9075篇 |
冶金工业 | 2127篇 |
原子能技术 | 783篇 |
自动化技术 | 22917篇 |
出版年
2024年 | 476篇 |
2023年 | 1317篇 |
2022年 | 2337篇 |
2021年 | 2547篇 |
2020年 | 2752篇 |
2019年 | 2368篇 |
2018年 | 2453篇 |
2017年 | 2963篇 |
2016年 | 3390篇 |
2015年 | 3542篇 |
2014年 | 5068篇 |
2013年 | 5298篇 |
2012年 | 6516篇 |
2011年 | 6595篇 |
2010年 | 5226篇 |
2009年 | 5416篇 |
2008年 | 5408篇 |
2007年 | 6383篇 |
2006年 | 5593篇 |
2005年 | 4793篇 |
2004年 | 3941篇 |
2003年 | 3313篇 |
2002年 | 2740篇 |
2001年 | 2371篇 |
2000年 | 2127篇 |
1999年 | 1710篇 |
1998年 | 1380篇 |
1997年 | 1192篇 |
1996年 | 1015篇 |
1995年 | 900篇 |
1994年 | 775篇 |
1993年 | 550篇 |
1992年 | 464篇 |
1991年 | 380篇 |
1990年 | 331篇 |
1989年 | 312篇 |
1988年 | 202篇 |
1987年 | 119篇 |
1986年 | 61篇 |
1985年 | 61篇 |
1984年 | 65篇 |
1983年 | 57篇 |
1982年 | 46篇 |
1981年 | 23篇 |
1980年 | 36篇 |
1979年 | 26篇 |
1978年 | 10篇 |
1977年 | 10篇 |
1959年 | 8篇 |
1955年 | 7篇 |
排序方式: 共有10000条查询结果,搜索用时 15 毫秒
911.
Effects of deformation on microstructures and properties of submicron crystalline Cu-5%Cr alloy 总被引:1,自引:0,他引:1
Warm extrusion of submicron crystalline Cu-5%Cr from 100 ℃ to 600 ℃ was investigated. The effects of different extrusion ratios and different extrusion temperatures on microstructures and properties of submicron crystalline Cu-5%Cr were studied. The microstructures of the extruded Cu-5%Cr were characterized by backscattered electron irnages(BSE) and transmission electron microscopy(TEM). The mechanical properties of the extruded Cu-5%Cr were measured by means of microhardness and tension test. The results show that, the deformation, dynamic recovery and dynamic recrystallization of the extruded Cu-5%Cr are mainly produced in Cu matrix. The higher extrusion ratio leads to more uniform microstructure and finer Cu grains. When being extruded in the range of 100-600 ℃, dynamic recovery of Cu is the dominant process, and dynamic recrystallization of Cu occurred above 300 ℃ is far from end. The most part of microstructure of as-extruded Cu-5%Cr is subcrystaUines produced by dynamic recovery, only a few recrystallines exist, and the average size of these grains is not larger than 400 nm. With extrusion temperature rising, the tensile strength and microhardness of Cu-5%Cr decrease, and elongation increases gradually. 相似文献
912.
奥氏体预变形温度对提高Fe-Mn-Si合金记忆效应的影响 总被引:1,自引:0,他引:1
本文研究了573─1073K温度范围内3%奥氏体预变形对Fe-29.9%Mn-6.0%Si合金记忆效应的影响.结果表明,固溶态的样品经奥氏体预变形后,在室温变形时,记忆应变(ε(tr))、应变回复率(η)及记忆应变达到饱和所对应的应变值都得到了明显的提高:随预变形温度升高,室温经约2.5%变形后应变回复率增加,并在合金动态再结晶开始温度973K预变形后具有最大值98%;经973K预变形,合金的最大记忆应变由固溶态的1.7%提高至3.8%,完全记忆应变达2.2%;奥氏体预变形的作用在于降低了室温诱发ε马氏体的临界应力. 相似文献
913.
A monolithic hybrid fuel cell (MHFC) with a novel configuration was proposed in an effort to improve the fuel cell performance during instantaneous power changes. A modified direct methanol fuel cell (DMFC) with a layer of hydrous ruthenium dioxide (RuO2·xH2O) sandwiched between the anode catalyst layer and membrane was used to demonstrate the principle of the MHFC. Experimental results indicate that the RuO2·xH2O layer is equivalent to a resistor-capacitor transmission line and functions similar to a capacitor in parallel with the anode electrode. The improvement in dynamic response of the MHFC was experimentally confirmed under step current change and square current pulse operating. The ionic conductivity of the RuO2·xH2O layer was also obtained. 相似文献
914.
LY12铝合金摩擦焊接过程的电场效应 总被引:1,自引:0,他引:1
定量研究了外加强电场对LY12铝合金摩擦焊接头热影响区(HFZ)中动态再结晶区宽度与晶粒尺寸的影响,并初步探讨了其影响机制。实验结果表明,外加强电场使动态再结晶区晶粒细化、等轴性提高,超细等轴晶区亦加宽。此外,采用较高焊接压力时,电场的引入使焊接接头的动态再结晶区宽度增大10%-30%;采用中等摩擦压力施焊时,电场的作用不但使焊接接头动态再结晶区宽度明显增加,而且还影响其沿径向的分布形态,使近轴心线处的动态再结晶区宽度趋于均匀,可以推断,外加强电场可使摩擦焊接头更易发生动态再结晶,而且强电场使焊合区组织的细化与均匀化,有利于提高焊接接头性能。 相似文献
915.
轴承沟道磨床砂轮的动平衡对保证零件加工精度的至关重要,文章介绍了一种轴承沟道砂轮的自动平衡系统,将虚拟仪器技术,数字信号处理技术与动平衡技术结合起来,以图形化编程软件LabVIEW为平台组建开发了虚拟仪器动平衡测试系统,采用廉价的数据采集芯片制作数据采集卡,通过广泛使用的串口方式进行上下位机通讯,具有价格低廉、易于普及、使用方便快捷等优点,为虚拟仪器技术的普及,达到实用阶段提供了思路和方向。 相似文献
916.
隔直电容在弧焊逆变器中抗偏磁能力的分析 总被引:1,自引:0,他引:1
本文采用状态平均法建立了隔直电容在知式焊接逆变器中抗偏磁的动态模型,并进行了动态分析,为焊接逆变器的设计提供了理论依据。 相似文献
917.
基于动态相变的细晶双相低碳钢组织控制 总被引:5,自引:0,他引:5
利用Gleeble1500热模拟单向压缩实验机,通过观察不同原奥氏体晶粒的过冷奥氏体在动态相变过程中的组织演变,分析了动态相变过程中马氏体岛形貌以及分布的演变特征,并考察了原奥氏体晶粒大小、形变温度和形变速率等参数对组织转变动力学的影响,探讨了基于动态相变的细晶双相低碳钢的组织控制规律、结果表明,通过调整原始奥氏体晶粒尺寸并控制过冷奥氏体动态相变进程,可以获得在均匀细小的铁素体(2~3μm)基体上弥散分布着不同体积分数、颗粒状细小马氏体岛的双相钢。 相似文献
918.
919.
杨立功 《水利水运工程学报》2015,(5):96-102
三维情况下,桶体稳定性是一个复杂的空间结构与土相互作用的问题。结合工程实例,建立了三维新型桶式基础防波堤有限元模型,对其稳定性进行分析。从而,动力作用下桶体结构位移与目前静力计算的结果相差较大,针对这个问题,分析提出等效拟静力法,通过与动力作用后相等的孔压等效成与之对应的静荷载,然后计算桶体位移。该方法的关键是找出桶体前端底部土体孔压与静荷载之间的关系,同时找出此处土体孔压与动荷载之间的关系,从而建立静荷载与动荷载之间的关系。经数值模拟与试验对比,结果证明所提的等效拟静力法比较合理。在模拟与分析原型桶体基础上,进一步分析了不同尺度及不同荷载作用点高度时,桶体前端底部土体孔压与静荷载之间的近似直线关系。 相似文献
920.
由于水环境系统中存在诸多不确定因素,建立在物理简化基础上的确定性水质模型并不能反映水质变化过程的不确定性。为了弥补确定性水质模型的局限性,本文根据随机微分方程理论,假设水质模型中的耗氧系数、沉降系数、复氧系数服从双侧截尾正态分布,建立了考虑随机效应的水质模型。将模型应用于COD超标风险分析,分别计算了不同水文、水质条件下COD浓度的概率分布。结果表明:当三道营来水COD浓度为16、17、18 mg/L时,超标概率为分别在0.3、0.6、0.8左右。 相似文献