Taste recognition threshold concentrations of styrene in oil-in-water emulsions and yoghurts

Taste recognition threshold concentrations (TRTC) of styrene were determined in samples of oil-in-water emulsions (30–300 g kg^?1 oil) and yoghurts (1–30 g kg^?1 fat), spiked with styrene. The observed TRTC increased linearly with increasing fat content and ranged from 0–3 to 2–1 mg kg^?1 for the emulsions and from 36 to 171 g kg^?1 for the yoghurts. Styrene equilibrium partition coefficients between emulsions and their respective vapour phases were determined. The concentrations of styrene in the continuous aqueous phase of the emulsions and yoghurts were calculated at the TRTC. The styrene concentrations in the continuous phase had constant values of about 15 g kg^?1 indicating that perception of styrene for oil-in–water emulsions is determined by the aqueous phase of the emulsion. The concentrations of styrene in the vapor phases above the emulsions and yoghurts were also calculated and were found to be constant at the TRTC. This relationship probably resulted from the equilibrium of distribution of styrene between the respective phases. Commercial yoghurt packed in polystyrene beakers contained styrene levels in the range 2–11 g kg^?1, much lower then the TRTC reported.     

对象模型及其模型化方法——一种深知识的表示模型

本文介绍了对象模型和深知识等概念,在这些概念的基础上还讨论了基于框架知识表示形式的复杂系统的模型化方法.文中给出的模型化方法是通过 ISA 关系和 PART-OF 关系的相结合而形成的.这种模型化方法可用于基于深知识的设计型、分析型以及控制型等类型的专家系统.     

无端点检测汉语识别算法的实现及改进——动态时间规整和隐马尔可夫统一模型的应用

语音识别算法中，动态时间规整（ＤＴＷ）和隐马尔可夫模型（ＨＭＭ）是最有效的识别算法，并且两者之间有着本质的联系和内在的统一［１］，据此前期工作中，已经建立了ＤＴＷ和ＨＭＭ的统一模型（ＤＨＵＭ）［２、３］。本文对ＤＨＵＭ进行了改进，在ＤＨＵＭ中引进寂静段自环，并根据汉语语音的特点，提出了一种无端点检测的语音识别算法。在识别过程中，该算法无需确定语音信号起止点位置，而是从寂静段开始，直接按帧提取特征（帧长２０ｍｓ，帧间重叠５０％），特征向量由１５阶倒谱系数和帧平均能量组成。实验中，用ＤＨＵＭ实现了该算法，对９９个相似汉语单字的识别测试结果表明：无端点检测的识别正识率为９４．９５％，正识率下降很少，但不作端点检测却降低了算法的复杂程度。为进一步改善识别性能，特征向量采用一种听觉模型特征，识别器具有更好的鲁棒性，识别率会略有提高。     

Adaptive control in a heating vessel: A comparative study

This paper presents experimental results obtained in temperature adaptive control of a heating vessel. A non-linear model of the process showed that the feed flow rate causes severe variations in time constant and process gain. An extended horizon self-tuning controller and two different model reference adaptive controllers were tested. The influence of design parameters on control performance for each algorithm was assessed. The control system was disturbed with load and setpoint changes.     

人口系统迁移过程的参数辨识及其仿真

本文以系统辨识为工具，提出了迁移过程定量研究的一种方法，即运用随机牛顿法于时变系统中以辨识模型迁移表参量，同时结合卡尔曼滤波技术辨识迁移过程中另一参数－总和迁移率，将这两者融为一体，形成了辨识迁移模型参量的递推算法。本文又借助微分方程的稳定性理论讨论了净迁移情形下的辨识算法的收敛性，给出算法收敛的一个充分条件。     

双机械臂协调：以运动学为基础的模型分析与动态补偿控制方法

本文建立了双机械臂协调系统的主从式控制的非结构模型，并针对两臂具有相同特性和不同特性这两种情形作了稳定性分析，提出特性校正的方法，本文还利用内模原理设计出动态补偿器来克服标定约束的不确定性对系统控制品质的影响，最后给出了实验结果。     

Formation Kinetics of Unsaturated (Ti, W)C Solid Solution

ＦｏｒｍａｔｉｏｎＫｉｎｅｔｉｃｓｏｆＵｎｓａｔｕｒａｔｅｄ（Ｔｉ，Ｗ）ＣＳｏｌｉｄＳｏｌｕｔｉｏｎＬｉｎＣｈｅｎ’ｇｕａｎｇ，ＤｅｎｇＦｅｎｇｘｉａｎｇ，ＨｅＣｏｎｇｘｕｎａｎｄＧａｏＺｈａｏｚｕ（林晨光）（邓凤翔）（贺从训）（高兆祖）（Ｇｅｎｅｒ...     

我国金矿床氧化带的地质地球化学特征

根据氧化矿石的主要化学成分，应用ＦＡＳ图解进行氧化矿石的化学成分分类；通过对氧化带分带及发育型式的研究，建立了我国金矿氧化带形成的地质地球化学模式；对影响氧化带发育的因素进行了初步探讨。     

Adhesion Mechanisms of Polyurethanes to Glass Surfaces. III. Investigation of Possible Physico-Chemical Interactions at the Interphase

Surface free energies of polyurethanes made from toluene diisocyanate and 1, 4 butanediol-based hard segments and caprolactone polyol-based soft segments were calculated using additive functions. Good agreement was found between the calculated values based on additive functions and the calculated values based on contact angle measurements. The phase-separated polyurethanes were found to have a higher polar surface free energy component (γ^P). This was linked to the preferential segregation of butanediol/butanediol-derived moieties to the polyurethane surfaces due to phase separation. The adhesion values of these polyurethanes to soda-lime glass were correlated with their respective γ^P values and a linear relationship was found. It was also shown that the adhesion values of the low γ^P polyurethanes improved substantially when the glass surfaces were coated with a thin layer of butanediol prior to the bonding. The modulus of the interphase region rich in butanediol was evaluated. Although a modulus increase was found at the interface, this increase was found to play a secondary role in the adhesion. The chemical interactions at the polyurethane/glass interphase were investigated by pre-treating the glass surfaces with methyl-trimethoxysilane and trimethylchlorosilane prior to adhesion testing. The adhesion data showed no significant difference between the uncoated and the silane-treated glass substrates. Based on this experimental evidence, the possibility of any covalent or ionic bonding at the polyurethane/glass interphase was assumed negligible. It was determined that the mechanism of adhesion between the polyurethanes and the glass surface could be through the formation of an interphase region in which hydrogen bonding between the butanediol-rich interphase region and the hydroxylated glass surface plays a key role.     

饮用水氯化中氯仿形成的动力学模式

以黄腐酸（ＦＡ）为卤仿前驱物质，分别测定不同投氯量、ＴＯＣ水平、温度以及ｐＨ值对ＣＨＣｌ３形成速率的影响，确定出ＣＨＣｌ３形成的动力学模式。该模式可用于预测投氯后的管网水中ＣＨＣｌ３的形成量，以便采取必要措施保证饮用水符合国家规定ＣＨＣｌ３〈６０μｇ／Ｌ的标准。