OFA-II型定量荧光仪在油气勘探中的应用

定量荧光仪在现场应用中受到各种因素的影响:如岩屑样品浸泡时的干、湿;图谱是否出现了淬灭;环境温度的影响等等。文章通过具体事例给出解决这些问题的办法。     

暖通空调工程设计常见问题

通过对施工图审查工作进行总结，指出了暖通空调和防火防排烟设计中存在的问题及防火规范本身的一些不足。     

油罐清洗作业防火安全措施

目前大型原油储罐逐步应用自动机械清洗系统进行清罐作业,而对于容量小、沉积物较少的油罐国内仍采用人工清洗方式进行。分析了油罐人工清洗作业过程时容易引发火灾的原因,并提出相应的预防火灾措施。     

阳离子化多元醇防塌剂的研制

室内研究和现场应用表明,聚乙烯醇类防塌剂表现出较明显的增粘负效应,可引起钻井液粘度的急剧增加,严重影响其推广应用.通过金属盐催化降解和阳离子化反应,研制出了抑制性好且增粘负效应低的阳离子化改性多元醇防塌剂.考察了阳离子化试剂、反应温度、反应时间对取代度、反应效率和产品主要性能的影响,得出了阳离子化多元醇防塌剂最佳制备条件,即：PVA与阳离子化试剂物质的量比为1：1,反应温度为50℃,反应时间为4 h,阳离子度可达0.435.     

川中丘陵区一种新型小流域径流输沙模型的建立与应用

径流输沙模型对定量评价水沙的输出响应具有重要的意义。本研究在已有研究成果的基础上，通过对四川盐亭县林山西沟小流域的径流、泥沙进行现场观测与分析，提出含沙量单位线的定义及其确定方法，建立了适应该小流域的径流输沙模型。并应用实测资料进行比较，表明模型的模拟结果可靠，模拟过程确定性系数达0．8以上，为川中丘陵区小流域径流输沙过程的预测预报提供了一个新方法。     

一种有机硫类絮凝剂DTC的合成及性能评价

讨论了由有机伯胺或仲胺和CS2合成二硫代氨基甲酸盐DTC的反应及副反应,简介了合成工艺。根据红外光谱确认了由三乙烯四胺合成的二硫代氨基甲酸盐（以下简称DTC）的结构。以含原油350 mg/L、含悬浮固体55.1 mg/L,含Fe^2＋10.0 mg/L的模拟污水为实验水样,考察了该DTC的絮凝性能,在40℃、pH=6-7、沉降时间30分钟条件下DTC的适宜加量为20 mg/L,此时污水含油量为9.0 mg/L;使用DTC的适宜pH范围在4-8,pH=6为最佳值,适宜温度范围为10-45℃,温度高于45℃时DTC可发生热分解;DTC的除油效果随污水中Fe^2＋浓度增大而改善。在含油89.1 mg/L、含悬浮固体55.1 mg/L、含Fe^2＋13.2 mg/L的油田污水中,DTC的除油率最高,远高于常用絮凝剂PFS,PAC,CPAM,HPAM和PAM。当污水中不含Fe^2＋时,DTC无絮凝除油效果。讨论了DTC在Fe^2＋参与下的絮凝过程。图5表1参8。     

Effect of specimen size and loading conditions on spalling of concrete

Different qualities of concrete have been fire tested using different geometries of the specimens as well as different load levels and load configurations. The main objective with the study was to examine a test methodology consisting of a full‐scale test and different small scale‐tests for determining the probability of spalling and the amount of spalling of fire exposed concrete structures. A reference specimen was defined as a one‐sided fire exposed slab with the dimensions 1800 × 1200 mm² giving an exposed area of 1500 × 1200 mm². A number of concrete qualities with different probabilities for spalling, were tested using the reference specimen. These tests showed that the reference specimens worked well giving the expected test results. Small specimens were manufactured in different shapes with the same concrete as the one used in the reference tests. These small specimens were tested either at the same time as the reference specimens in the large furnace or afterwards on a small‐scale furnace where the fire exposed surface was 450 × 360 mm². The test results clearly show the increased probability and the increased amount of spalling by using external compressive loading. The results also show that by using pre‐stress through bars or wires the load can be lost due to heating of the bars/wires which results in a decreased amount of spalling. The boundary of the specimen also affects the amount of spalling. The spalling around the edges was in all tests less than the spalling on the central parts of the exposed area. It could also be noted that the spalling did not pass completely through any of the specimens. The reason for this is probably that the water/vapour could migrate out from the unexposed surface of the specimen. Copyright © 2006 John Wiley & Sons, Ltd.     

火灾自动报警与PLC自动控制相结合在油库消防系统中的应用

为了加强对油库消防监控,更好地保护油库的消防安全,宁波镇海国家储备油库的消防监控系统尝试了火灾自动报警与PLC自动控制相结合的监控模式,并取得了良好效果,使系统监控的智能化程度大为提高,其报警及灭火控制功能更为先进。文章主要阐述了该系统的特点、结构及功能,并结合实际工程应用介绍了该系统的工作流程,为该技术在其他类似工程的应用提供了有益的借鉴。     

Internal-corrosion inhibitors for pipelines in heat-supply systems carrying water with a high oxygen content

The reliability of heat-supply systems is determined primarily by internal corrosion of the pipelines. The concentration of oxygen in the water exerts a major influence on the corrosion. In systems with a standard oxygen content, OéDF-Zn is a highly effective corrosion inhibitor. However, there are systems in which the quality of deaeration of the make-up water of the heat-supply system is low (or deaeration is nonexistent), and the concentration of oxygen is considerably above the standard value. Classed among these systems, for example, are the HWS systems, which are incorporated into closed heat-supply systems. The oxygen concentration in these systems is analyzed to assess the situation. __________ Translated from élektricheskie Stantsii, No. 6, June 2007, pp. 35–39.