光传操纵系统综述

在简要回顾飞机操纵系统的发展历史的基础上,详细介绍了光传操纵系统的发展状况和应用前景。针对航空领域光纤传输的特点,对光传操纵系统中光电器件的选择及关键技术等进行了分析。     

Mathematical modelling of a reverse flow reactor with catalytic surface dynamics

This paper studies a system of partial differential equations modelling the behaviour of a reverse flow reactor. For the parameters appropriate for the oxidation of ammonia on a Pt/Al₂O₃ catalyst in a typical laboratory set-up, the reactor may be split into regions where approximate formulas that determine its behaviour are deduced. Numerical calculations are presented and can be used to compare with the analytical formulas. The physical insight gained from the asymptotic analysis suggests a new switching strategy which is the subject of numerical experiments. The switching strategy is found to be efficient at minimising the ammonia exiting the reactor after reversal.     

A new method of characterization for stratified thermal energy stores

A new method for characterization of stratified thermal energy stores (TES) that integrates both the first law and the second law concerns is presented here. The first law concern is incorporated into a quantity called energy response factor and the second law concern into an entropy generation ratio. A product of these two quantities is at the heart of the TES efficiency definitions. This approach removes the overemphasis of the existing methods either on the first or the second law of thermodynamics which often biases the characterization results. The information about the evolution of the temperature field of the system in time is the prerequisite of the new method. It may be obtained from experiments or from suitable numerical simulations. The current method can be easily integrated into computational fluid dynamic (CFD) simulations and thus facilitate CFD-based design analysis. As an example of such CFD-integrated analysis, a large-scale hot water seasonal heat store is numerically studied to identify the effects of aspect ratio, containment shape, internal structures, and containment size on their efficiency. The results suggest the effectiveness of the new method in deriving useful design insights.     

转向驱动轮轮胎测力仪研究

该测力仪在结构上采用双等速万向节装置，不仅能用于转向轮和非转向轮的测量，并且解决了转向驱动轮的动力测量问题，对于四轮驱动的军用轮式车辆实车测试有着十分重要的意义。测力仪将轮胎动载荷、扭矩、侧向力、回正力矩、驱动力和外倾力矩的测量转化为测力筋拉压力的测量，大大提高了测量精度和抗干扰能力。     

非晶Sm5Fe74.3Nb1.5Si11.7B4.5C2.5Cu0.5合金经预退火后的晶化动力学的DTA研究

研究了非晶Sm5Fe74.3Nb1.5Si11.7B4.5C2.5Cu0.5合金经400℃，保温10min预退火后的晶化动力学。结果表明；该合金的晶化相为α-Fe固溶体和Sm2Fe17Cx金属间化合物，两相的晶化表观激活能分别为557KJ/mol和514KJ/mol，当晶化体积分数为60%时，α-Fe相的晶化激活能达极大值；Sm2Fe17Cx相晶化激活能则随其晶化体积分数的增加而逐渐减小。     

Development of an integrated model for airflow in building spaces

In building energy simulation, an integrated modelling of airflow in the building needed. Therefore, in this paper two approaches are used for building energy simulation: zonal network for modelling of the building segments and Computational Fluid Dynamics (CFD) for modelling of the airflow. It is noted that a synchronize solution process is needed for the building and the CFD equation-sets. For this purpose an iterative procedure is used to corresponding solution of these equations.     

Improvement of oxygen mass transfer estimation from oxygen concentration measurements in bubble column reactors

An original procedure has been established for estimating the overall volumetric mass transfer coefficient using the oxygen concentration curves resulting from the usual gassing-in and gassing-out method. This procedure was applied to experimental data obtained in a small scale bubble column using both tap water and a coalescence-inhibiting liquid mixture that represents the coalescence behavior of biological media. It is based on the analysis of the characteristics times of the system, including those of the hydrodynamics of the two phases, the sensor dynamics and the system inertia when the gas composition is modified. A numerical procedure was developed to estimate the characteristic time of the system inertia t_i, using the assumption that this inertia is nearly independent of superficial gas velocity U_G. The calculations confirmed that the optimized t_i value was nearly independent of U_G and of the coalescence behavior of the liquid phase. Additionally, the resulting K_La_L values for tap water were closer to the correlation of Shah et al. [1982. Design parameters estimations for bubble column reactors. A.I.Ch.E. Journal 28, 353-379] than those of other conventional models. Finally, the original procedure was also reported to reduce significantly the square sum deviation between the predicted and the measured oxygen response curves.     

Analytical solution for the axisymmetric plane strain electroelastic dynamics of a special non-homogeneous piezoelectric hollow cylinder

By virtue of the introduction of a dependent variable and the separation of variables technique, the axisymmetric plane strain electroelastic dynamic problem of a special non-homogeneous piezoelectric hollow cylinder is transformed to a Volterra integral equation of the second kind about a function with respect to time, which can be solved successfully by means of the interpolation method. Then the solutions of displacements, stresses, electric displacements and electric potential are obtained. The present method is suitable for a piezoelectric hollow cylinder with an arbitrary thickness subjected to arbitrary mechanical and electrical loads. Numerical results are finally presented.     

Molecular Dynamics Simulation of Gas Diffusion in B2O3 and SiC

Molecular dynamics simulation using a universal force field has been employed to determine the diffusion coefficients of O2 and Na2SO4 vapor into B2O3 and SiC from 700 K to 1273 K, respectively. Einstein diffusion was observed in a 250～300 ps simulation.     

Simulation of Economic Dynamics under Ecological Balance Conditions

A model of economic dynamics under stable ecological balance conditions is proposed. A methodology of construction of an optimal growth path is constructed for this model.