用于皮带及链传动的一种恒张力张紧装置

指出了皮带及链传动现有张紧方法的缺点，设计了一种结构简单、工作可靠的用于皮带及链传动的恒张力控制装置，该装置能自动调整压在皮带或链上的力，在很大挠角范围内保持其张力基本恒定。     

First Harmonic (2f) Characterisation of Resonant Frequency and Q-Factor of Micromechanical Transducers

In this paper, the response to the first harmonic component (2f) of the electrostatic force in single terminal driven electrostatic comb-drive and parallel-plate drive was used as a signal to extract device parameters, namely, the Q-factor and resonant frequency instead of the fundamental (1f) resonance response. It is shown that the difficulty in motional measurement due to electrical cross-talk (parasitics) using 1f measurement can be overcome with a higher signal-to-noise ratio of the 2f signal. Both atmospheric (low-Q) and reduced pressure environment were investigated using off-chip electronics and lock-in amplifier. The measurements were done on the electrostatic comb-drive and capacitive parallel plate sensing plates that form the two core modules of a yaw rate sensor (dual-axis resonator). The effects of AC and DC bias voltages on the measured response have been investigated. Experimental amplitude and phase response data have been analysed using the Lorentzian curve-fit, Resonance Curve Area (RCA) method, the half-power bandwidth method (3 dB) and the Nyquist plot for data fitting and determination of the Q-factor and resonance frequency.     

采用注视控制器实现复杂运动的仿真

注视控制器是3DS MAX软件的众多控件之一，它能使多个物体彼此间产生运动约束。通过使用注视控制器功能，笔者成功制作出八足爬壁式仿生机械昆虫的运动场景动画，并使该仿生机械昆虫各足的行走动作符合机械零件作平面复杂运动时所应遵守的正确运动规律。由此证明，3DS MAX软件注视控制器对正确模拟特殊机械装置的复杂运动可产生极大作用。     

交流探尺的控制及其在武钢新3^#高炉上的应用

本文论述了交流探尺的控制原理及到料面信号的检测方法。以其在武钢新３＃高炉上的应用为例，给出系统组态、控制框图及它在无料钟系统中所起的补偿倾动角度的作用。最后对交流、直流探尺系统进行了比较。     

准分子激光器异步感应密封传动技术

一种新型准分子激光器循环系统中的密封传动技术，具有可耐高气压，不失耦，不使用昂贵强磁材料，结构简单等优点，虽有涡流损失过大之不足，但能很好地适用于小功率下运行。     

Dynamic analysis and drilling degrees of freedom

Finite element methods for dynamic analysis employing elements with drilling degrees of freedom are presented. The formulation is based on a variational principle in which displacements and rotations are interpolated independently. The issue of zero masses corresponding to rotational degrees of freedom is addressed and techniques for defining consistent and lumped rotational mass matrices are presented.     

Feedback Specificity, Learning Opportunities, and Learning.

Although increasing feedback specificity is generally beneficial for immediate performance, it can undermine certain aspects of the learning needed for later, more independent performance. The results of the present transfer experiment demonstrate that the effects of increasing feedback specificity on learning depended on what was to be learned, and these effects were partially mediated through the opportunities to learn how to respond to different task conditions during practice. More specific feedback was beneficial for learning how to respond to good performance and detrimental for learning how to respond to poor performance. The former relationship was partially mediated by feedback specificity's effect on learning opportunities during practice. The results have implications for designing feedback interventions and training to maximize the learning of various aspects of a task. (PsycINFO Database Record (c) 2010 APA, all rights reserved)     

修井机多桥间转向传动机构的设计

对于大型修井机采用的重型底盘,多桥转向系统是底盘开发中的关键技术之一。在分析目前修井机采用的转向传动结构(方案1)存在问题的基础上,参照军用车底盘的应用案例又提出了2种方案,经对比分析,确定了最佳的传动机构新方案,并根据多桥转向理论和四连杆机构的几何关系对该机构进行了参数确定。通过实际应用,证明该转向传动布置方案具有传动误差小、不产生附加转向、现场调节安装方便、易于组织生产等特点。     

汽车摩擦片厚度测量装置驱动电路的研究

本文通过对摩擦片厚度在线测量装置系统构成的全面分析，对其驱动电路子系统进行了理论探索和技术研究，完成了相应的电路设计、误差分析及器件选择等工作，并进行了具体的实验验证，证明该驱动电路具有良好的性能，可圆满实现摩擦片厚度在线检测和实时分析的工作任务。     

Numerical simulation of slider dynamics during slider–disk contact

In this paper, the dynamic behavior of pico slider in contact with the disk was calculated. The analysis model consists of a simplified suspension model, an air bearing model, and a slider–disk contact model. The contact model consists of two elements. One is surface roughness model measured by Atomic Force Microscope (AFM) and the other is micro-waviness model. The dynamic behaviors of the tri-pad slider are calculated at several rotation speeds to investigate slider vibration modes during slider–disk contact. The slider oscillation frequency depends on the rotation speed and it saturates about twice as much as eigen frequency of air bearing pitch mode.