过氧化甲乙酮合成研究

论述了过氧化甲乙酮的合成方法，用阳离子交换树脂催化剂代替传统的无机酸催化剂。考察了离子交换树脂用量、反应温度对反应产率、活性氧含量的影响及溶剂对产品稳定性的影响。     

Passivity‐based sliding mode control for nonlinear systems

Passivity with sliding mode control for a class of nonlinear systems with and without unknown parameters is considered in this paper. In fact, a method for deriving a nonlinear system with external disturbances to a passive system is considered. Then a passive sliding mode control is designed corresponding to a given storage function. The passivity property guarantees the system stability while sliding mode control techniques assures the robustness of the proposed controller. When the system includes unknown parameters, an appropriate updated law is obtained so that the new transformed system is passive. The passivation property of linear systems with sliding mode is also analysed. The linear and nonlinear theories are applied to a simple pendulum model and the gravity‐flow/pipeline system, respectively. Copyright © 2008 John Wiley & Sons, Ltd.     

抽水蓄能机组PSS参数设计与现场试验

围绕广东电网的暂态稳定问题进行了广东电网主要运行方式下的动稳定分析计算,得出抽水蓄能机组的机电振荡频率及其阻尼情况。根据广东电网和南方电网的振荡频率落在0．3～2．0 Hz的低频段上的特点,并结合蓄能电厂机组的参数与特性,经BPA潮流、稳定计算程序和小扰动动态稳定分析程序计算分析比较,对蓄能机组的PSS参数进行了初步设计。通过现场试验对抽水蓄能机组的PSS参数进行优化整定,检验PSS的性能以及在工况调整和转换过程中的适应能力。     

Decentralized adaptive coordinated control of multiple robot arms without using a force sensor

This paper presents a distributed adaptive coordinated control method for multiple robot arms grasping a common object. The cases of rigid contact and rolling contact are analyzed. In the proposed controller, the dynamic parameters of both object and robot arms are estimated adaptively. The desired motions of the robot arms are generated by an estimated object reference model. The control method requires only the measurements of the positions and velocities of the object and robot arms, but not the measurements of forces and moments at contact points. The asymptotic convergence of trajectory is proven by the Lyapunov-like Lemma. Experiments involving two robot arms handling a common object are shown.     

加氢处理润滑油基础油各组分对光安定性的影响

将经紫外光照前后的加氢处理润滑油基础油分离为饱和烃、轻质芳烃、中质芳烃、重质芳烃和极性组分，分别采用薄层色谱、质谱和紫外吸收光谱分析了各组分的烃组成、硫和氮含量的变化，并通过将从原料油中分离出的各组分反加到光安定性好的饱和烃中，试验验证了加氢处理润滑油基础油中的重质芳烃和极性组分是光不安定组分，其中含有硫、氮的芳香杂环化合物光安定性差。     

Adaptive switching supervisory control of nonlinear systems with no prior knowledge of noise bounds

The problem of controlling nonlinear noisy systems affected by parametric uncertainties is approached via the introduction of a supervisor which, whenever needed, switches on, in feedback to the plant, a controller selected from a finite set of predesigned controllers. A Lyapunov-based falsification criterion allows one to ensure robust stability in the presence of uncertain constant parameters and exogenous bounded disturbances. Simulations are discussed in order to illustrate the merits of the proposed algorithms.     

常压渣油热反应过程中胶体的稳定性

利用质量分数电导率方法研究了中东和克拉玛依常压渣油在热反应过程中胶体的稳定性。结果表明，随着反应时间的增长，在热反应生焦诱导期内，渣油的胶体稳定性迅速下降；开始生焦后，胶体稳定性缓慢下降。从中东常压渣油的SARA四组分的数均相对分子质量、碳氢元素组成、平均芳碳率等方面探讨了中东常压渣油在热反应过程中胶体稳定性下降的原因。结果表明，在热反应中，由于裂解和缩聚反应的共同作用，使渣油的沥青质和饱和分含量上升，芳香分含量下降，胶质含量变化不大；随着热反应的进行，四组分的数均相对分子质量均呈下降趋势，导致了渣油胶体稳定性的下降并发生生焦反应。     

Experimental Research on Erbium-doped Superfluorescent Fiber Source

The effects of the variations in fiber length, fiber mirror reflectance on efficiency and output power are experimentally investigated for erbium-doped double pass backward superfluorescent fiber sources (SFSs). The influence of fiber length on mean wavelength stability (MWS) has also been demonstrated. By incorporating a short section of un-pumped erbium-doped fiber (EDF) at the output port, the pump power dependent on MWS becomes independent of pumped EDF length. This is a novel phenomenon that hasn‘t been reported up to now,and should be helpful to SFS fabrication and theory analysis. By using a fiber Michelson interferometer as spectrum slicing component,a multi-wavelength fiber source (MWFS) with ～20 channels (from 1542nm to 1559nm) is got. The MWFS has a channel spacing of ～0. 8 nm which satisfies ITUstandard. The intensity fluctuation among channels is less than 0.5dB,and the extinction ratio of all channels is above 14dB. This kind of MWFS should be useful to wavelength division multiplexing systems.     

Updated semi‐discretization method for periodic delay‐differential equations with discrete delay

An updated version of the semi‐discretization method is presented for periodic systems with a single discrete time delay. The delayed term is approximated as a weighted sum of two neighbouring discrete delayed state values and the transition matrix over a single period is determined. Stability charts are constructed for the damped and delayed Mathieu equation for different time‐period/time‐delay ratios. The convergence of the method is investigated by examples. Stability charts are constructed for 1 and 2 degree of freedom milling models. The codes of the algorithm are also attached in the appendix. Copyright © 2004 John Wiley & Sons, Ltd.     

Reduced modified quadratures for quadratic membrane finite elements

Reduced integration is frequently used in evaluating the element stiffness matrix of quadratically interpolated finite elements. Typical examples are the serendipity (Q8) and Lagrangian (Q9) membrane finite elements, for which a reduced 2 × 2 Gauss–Legendre integration rule is frequently used, as opposed to full 3 × 3 Gauss–Legendre integration. This ‘softens’ these element, thereby increasing accuracy, albeit at the introduction of spurious zero energy modes on the element level. This is in general not considered problematic for the ‘hourglass’ mode common to Q8 and Q9 elements, since this spurious mode is non‐communicable. The remaining two zero energy modes occurring in the Q9 element are indeed communicable. However, in topology optimization for instance, conditions may arise where the non‐communicable spurious mode associated with the elements becomes activated. To effectively suppress these modes altogether in elements employing quadratic interpolation fields, two modified quadratures are employed herein. For the Q8 and Q9 membrane elements, the respective rules are a five and an eight point rule. As compared to fully integrated elements, the new rules enhance element accuracy due to the introduction of soft, higher‐order deformation modes. A number of standard test problems reveal that element accuracy remains comparable to that of the under‐integrated counterparts. Copyright © 2004 John Wiley & Sons, Ltd.