使用光纤放大器的频分复用光纤传输系统

报道了一个使用光纤放大器的两路非相干频分复用光纤传输实验系统。系统采用国产ＤＦＢ激光器作光源，用意大利生产的光纤放大器作在线放大器，用自制的光学谐振腔作光学滤波器和解复用器，采用ＦＳＫ调制制式，将１４０Ｍｂ／ｓ非归零伪随机码传输了５０公里，得到了很好的眼图。在频道间距为１０ＧＨｚ情况下，未观测到邻道干扰和光纤放大器的非线性现象。     

A NEW ALGORITHM FOR ADAPTIVE LATTICE FILTERAND ITS APPLICATION IN THE SPEECH LINEARPREDICTIVE SYNTHESIS

In this paper, an adaptive line spectral pair filter is derived from an adaptive lattice filter. A least-mean-square(LMS) type adaptive algorithm used to calculate directly the line spectral pair(LSP) coefficients on a stage-by-stage basis is presented. Experimental results show that the algorithm has higher convergence rate and lower misadjustment as compared with the other algorithms. The LSP coefficients calculated by the algorithm have been used to carry out speech linear predictive synthesis, resulting in better results than PARCOR coefficients.     

高阻带抑制有源声表面波滤波组件

介绍有源声表面波滤波组件的设计思路。报道最新研制的高性能滤波组件，其中心频率４０ＭＨｚ，３ｄＢ相对带宽０．８％，阻带抑制优于１００ｄＢ，矩形系数（Δｆ１００ｄＢ／Δｆ３ｄＢ）小于３，输入输出端口电压驻波比接近１。组件体积８５ｍｍ×３５ｍｍ×２４ｍｍ，重量小于１１５ｇ     

一种自制硬件诊断磁带的方法

牛哲成．一种自制硬件诊断磁带的方法．测并技术，１９９４，１８（２）：１４９～１５４硬件诊断磁带是由用于对计算机硬件系统各组成部分进行功能检查、状态测试和故障检测的诊断测试程序集构成的一种专用工具磁带。本文提出了一种用户在ＰＥ３２００系列计算机裸机环境下自己制作硬件诊断磁带的方法，井涉及到具体的程序实现。用该方法制作的硬件诊断磁带操作简单。对进一步搞好ＰＥ３２００系列计算机的维护，开发完善ＰＥ３２００系列计算机硬件诊断系统具有实际意义。     

Direct preparation of particles from liquid suspension for ESEM or SEM analysis

A simplified method for the preparation of particles from liquid suspensions has been developed. Particles are deposited directly on carbon planchets for rapid analysis by environmental scanning electron microscopy or by conventional scanning electron microscopy after an additional drying step. This is accomplished by filtering the liquid through thin carbon planchets. Three different grades of graphite were investigated for their suitability as the source material for these planchets. The high quality isomolded graphite is recommended for the filtration and direct observation of particles by electron microscopy. This technique is demonstrated for particles in hydraulic fluid and aquatic suspended particulate material from a natural water source.     

An attempt to compare the performance of bioscrubbers and biotrickling filters for degradation of ethyl acetate in gas streams

This study presents a comparison of the efficiency of a bioscrubber and a biotrickling filter (BTF) for the removal of ethyl acetate (EA) vapour from a waste gas stream, under the same operating conditions. The maximum EA elimination capacity achieved in the bioscrubber was 550 g m^?3 h^?1 with removal efficiency higher than 96%. For higher EA loadings the bioscrubber was oxygen limited, which caused incomplete EA biodegradation. When pure oxygen was fed to the bioscrubber at a rate of 0.02 L min^?1, the bioscrubber recovered and could treat higher EA loadings without any oxygen limitation. The BTF achieved EA elimination capacity of 600 g m^?3 h^?1 with removal efficiency higher than 97% and the dissolved oxygen concentration remained substantially higher than in the bioscrubber. However, severe channelling and blockage of the spray nozzle occurred due to the excessive biomass growth. Overall, the bioscrubber system was easier to operate and control than the BTF, while an enhancement of the oxygen mass transfer in the bioscrubber could potentially increase its performance by up to three times. Copyright © 2005 Society of Chemical Industry     

对水厂一期滤池技术改造后的经济评价

本文主要从经济角度分析净水厂实际生产情况及经济技术指标等方面的数据。阐述福州西区水厂一期滤池由原先双阀滤池改造成V型滤池的经济性。     

A New Algorithm for the Elimination of Common Subexpressions in Hardware Implementation of Digital Filters by Using Genetic Programming

A new algorithm based on Genetic Programming (GP) for the problem of optimization of Multiple constant Multiplication (MCM) by Common Subexpression Elimination(CSE) is developed. This method is used for hardware optimization for DSP systems. A solution based on Genetic Programming is shown in this paper. The performance of the technique is demonstrated in one- and multi-dimensional digital filters with constant coefficients.     

指状椭圆函数滤波器的研究与设计

阐述了指状椭圆函数滤波器的特点、适用范围，基本理论以及设计方法。用本文导出的公式进行设计有工程应用价值，介绍了一个L波段滤波器的例子。     

一种适用于有限长度混合相位未知脉冲的最小平方反褶积新方法

普通的最小平方反褶积只有在子波为最小相位脉冲和反射序列为白噪声的假设下才是成立的,而对于混合相位未知脉冲来说,这种最小平方反褶积就不再适用了。本文提出一种适合于有限长度混合相位未知脉冲的最小平方反褶积方法。运用此法只需预先估计一个混合相位子波的长度。合成数据的试验结果表明,该方法有较好的效果,且对预先估计出的子波长度不敏感。文中还证明混合相位未知脉冲最小平方反褶积等效于一种有间隙的平滑误差滤波器的作用,而这种有间隙的平滑误差滤波又可分解为一个前向多步预测误差滤波与一个后向多步预测误差滤波之和。可以预计这种新的反滤积方法将在地震数据处理中得到有效的应用。