实现CDMA最佳多用户检测的神经网络方法

提出并讨论了两种实现码分多址系统中最佳多用户检测的神经网络方法。一种基于离散Ｈｏｐｆｉｅｌｄ神经网络，另一种基于采用反向传播算法的多层感知器神经网络。理论分析和计算机模拟都证实了这两种神经网络方法的可行性，优越性和实用性。前者适用“固定”用户情况；后者既可用于“固定”用户吼适用于移动用户的情况，因而在未来的ＣＤＭＡ个人通信网中有较好的应用前景。     

螺杆泵的检测方法及检测标准制定

螺杆泵检测是避免不合格螺杆泵下井、螺杆泵早期失效和提高螺杆泵使用寿命与采油效益的重要技术手段。重点介绍了模拟不同工况的螺杆泵工作特性检测系统及检测定子通径为10－60mm的定子衬套偏心度检测仪的组成及其检测方法和原理。针对大庆油田的实际情况，在进行大量室内和现场试验的基础上，制定了GLB120－27、GLB40－42和GLB500－14型螺杆泵的检测标准。检测技术及其标准实施以来见到了明显效果。     

SECANT-FUZZY LINEAR REGRESSION METHOD FOR HARMONIC COMPONENTS ESTIMATION IN A POWER SYSTEM

In order to avoid unnecessary damage of electrical equipments and installations,high quality power should be delivered to the end user and strict control on frequency should be made, Therefore, it is important to estimate the power system's harmonic components with higher accuracy. This paper presents a new approach for estimating harmonic component in a power system using secant - fuzzy linear regression method. In this approach the non - sinusoidal voltage or current waveform is written as I linear function. The coefficient of this function is assumed to be fuzzy number with a membership function that has center and spread value. The time dependent quantity is written as Taylor series with two different time dependent quantities. The objective is to use the sample obtained from the transmission line to find the power system harmonic components and frequencies. We used an experimental voltage signal from a sub power station as a numerical test.     

First Harmonic (2f) Characterisation of Resonant Frequency and Q-Factor of Micromechanical Transducers

In this paper, the response to the first harmonic component (2f) of the electrostatic force in single terminal driven electrostatic comb-drive and parallel-plate drive was used as a signal to extract device parameters, namely, the Q-factor and resonant frequency instead of the fundamental (1f) resonance response. It is shown that the difficulty in motional measurement due to electrical cross-talk (parasitics) using 1f measurement can be overcome with a higher signal-to-noise ratio of the 2f signal. Both atmospheric (low-Q) and reduced pressure environment were investigated using off-chip electronics and lock-in amplifier. The measurements were done on the electrostatic comb-drive and capacitive parallel plate sensing plates that form the two core modules of a yaw rate sensor (dual-axis resonator). The effects of AC and DC bias voltages on the measured response have been investigated. Experimental amplitude and phase response data have been analysed using the Lorentzian curve-fit, Resonance Curve Area (RCA) method, the half-power bandwidth method (3 dB) and the Nyquist plot for data fitting and determination of the Q-factor and resonance frequency.     

Analysis and Optimization of Noise in Bipolar RF Harmonic Mixers

A noise analysis of bipolar harmonic mixers (BHM) used for direct-conversion receivers is presented in this paper. Analytical and simulated results for the transfer function of the mixer are presented. Simple analytical expressions describing noise contribution from all sources are derived. Estimation of flicker noise quite agrees with harmonic-balance simulation results. Based on the derived expressions, total time average noise power spectral density (PSD) at the output is compared with simulation results. For the recommended regions of operation, error is less than 20%. The overall BHM noise figure (NF) is calculated and optimized based on a simple extracted formula. Errors introduced by analysis remain within a 1.5-dB margin with respect to simulation results. The validity of analysis for high frequencies is justified. The effect of flicker noise coefficient on the overall mixer NF is compared for different available processes.     

基于面像识别技术的公安网上追逃系统

研究了公安网上追逃系统的体系结构和系统的程序流程，阐述了ASP COM 后台比对服务的3层B／S模式面像网上比对的实现方法，最后给出系统的性能指标和特点。     

PWM开关变换器统一建模法与谐波分析法的应用

介绍了PWM开关功率变换器电路的统一建模方法，并将谐波分析方法应用于电路分析中，理论和实例表明，这种方法容易得到电路变量的基波解和各次谐波解，以及电路的传递函数，具有容易理解和准确度较高的优点。     

The costs and benefits of tonal centers for chord processing.

Harmonic priming studies have shown that a musical context, with its established tonal center, influences target chord processing. This study investigated costs and benefits of priming tonal centers for target processing by adding a baseline condition (sequences without a specific tonal center). Results confirmed harmonic priming, with faster processing for related than for unrelated and less related targets (tonic chord, out-of-key chord, subdominant chord). Comparing targets in baseline contexts with targets in sequences with well-established tonal centers revealed a benefit of processing for related targets but a cost of processing for unrelated and less related targets. Findings are discussed in terms of tonal knowledge activation and suggest that an activated tonal center gives rise to strong expectations for the tonic. (PsycINFO Database Record (c) 2010 APA, all rights reserved)     

纵向零序电压保护新方案及其应用

由于结构设计的原因，综合性能较好的一些保护方案如横差保护和不完全纵差保护等将不能应用于大型超临界汽轮发电机。文中重点讨论了纵向零序电压保护方案的改进及其在应用中的问题。研究表明，发电机发生匝间短路故障时3次谐波电势减小，而机组外部故障时发电机3次谐波电势增大。因此，为了提高纵向零序电压保护方案的性能，可以根据故障时3次谐波电压增量的特性作为选取制动量的依据，从而提高保护性能。亦即:当3次谐波电压表现为负增量时，制动量取为0或接近0;而当3次谐波电压表现为正增量时，以该增量值作为制动量。此外，对匝间保护纵向零序电压元件增加一个小延时是可行的，它可以提高保护躲暂态3次谐波影响的能力。仿真计算表明，比例制动式纵向零序电压保护能可靠区分内外部故障，符合大型超临界汽轮发电机的保护要求。     

电站并联运行的不对称非线性振荡

本文给出一个结构不完全对称并联电网的等价定理,它把双输入双输出非线性耦合的微分方程组等价为单输入单输出的非线性微分方程,然后用渐近方法和谐波线性化方法求其一次近似解,得到一些新的物理性质,有助于合理选择电网结构,以提高其结构稳定性.