坐标测量机激光非接触式测头的研制

本文介绍适用子精密大型测试仪器──坐标测量机的激光非接触式测头的研制。该测头采用ＰＳＤ作为敏感元件并采用单片机技术完成对测量数据的处理。     

高温超导红外探测器的电极工艺探讨

介绍了高温超导红外探测器电极材料的选择和制备。选用先蒸、后蒸金，再合金化的电极工艺。芯片装配成器件后，器件性能稳定，膜层牢固，接触电阻小。     

A low power and small area all digital delay-locked loop based on ring oscillator architecture

A 133-500 MHz,5.2 mW @500 MHz,0.021 mm2 all digital delay-locked loop(ADDLL)is presented.The power and area reduction of the proposed ADDLL are achieved by implementing a high frequency ring oscillator(ROSC)to count the reference clocks such that the one-clock cycle delay chain and the phase detector in a conventional Master block are no longer needed.The proposed ADDLL has better immunity to PVT(process,voltage,and temperature)than most conventional DLLs,which do not update the control word signals after the locking process,since the control signals for slave delay line are updated in every 256 reference cycles.Fabricated in 0.13 um CMOS process,the measured RMS jitter is 10.83 ps at 500 MHz while the RMS jitter of the input signal is 9.97 ps.     

Terahertz detectors based on superconducting hot electron bolometers

Low noise terahertz(THz)heterodyne detectors based on superconducting niobium nitride(NbN) hot electron bolometers(HEBs)have been studied.The HEB consists of a planar antenna and an NbN bridge connecting across the antenna’s inner terminals on a high-resistivity Si substrate.The double sideband noise temperatures at 4.2 K without corrections have been characterized from 0.65 to 3.1 THz.The excess quantum noise factor β of about 4 has been obtained,which agrees well with the calculated value.Allan variance of the HEB has been measured,and Allan time up to 20 s is obtained using a microwave feedback method.Also,the intermediate frequency gain bandwidth(GBW)was measured using two dierent methods,resulting in same GBW value of about 3.5 GHz.     

Blind estimation of the PN sequence in lower SNR DS-SS signals with residual carrier

This paper presents a method of singular value decomposition (SVD) plus digital phase lock loop (DPLL) to solve the difficult problem of blind pseudo-noise (PN) sequence estimation in low signal to noise ratios (SNR) direct sequence spread spectrum (DS-SS, DS) signals with residual carrier. Of course, the method needs to know the parameters of DS signal, such as the period and code rate of PN sequence. Firstly, the received signal is sampled and divided into non-overlapping signal vectors according to a temporal window, whose duration is two periods of PN sequence. Then, an autocorrelation matrix is computed and accumulated by the signal vectors one by one. The PN sequence with residual carrier can be estimated by the principal eigenvector of this autocorrelation matrix. Furthermore, a DPLL is used to deal with the estimated PN sequence with residual carrier, it estimates and tracks the residual carrier, removes the residual carrier in the end. Theory analysis and computer simulation results show that this method can effectively realize the PN sequence estimation from the input DS signals with residual carrier in lower SNR.     

基于环探头测量含运动导体的瞬态电流波形

电流除了用罗果夫斯基线圈进行测量外,还可通过环探头测量电流产生的磁场来计算得到。直线电机除了位置固定的母线导体外,还有沿母线运动的电枢;母线回路注入脉冲电流后,电枢会被加速而运动。简化母线和电枢为线电流模型,在长线模型基础上,通过环探头测量得到的磁场计算出近似电流波形。因为探头所测磁场主要由其附近电流所贡献,所以合理配置电枢起始位置与探头位置后,电枢运动对电流测量的影响很小。在瞬态电流上升沿、平台区和下降沿的不同阶段,利用实验折算的系数,可得到时域瞬态电流波形,其测量结果与用罗果夫斯基线圈测量波形一致。     

基于FPGA和ARM的GPS基带处理平台设计

本文研究了基于FPGA和ARM的GPS基带处理平台,详细介绍了C/A码跟踪环路及载波跟踪环路的设计和实现方法。采用Maxim公司的Max2769、Atmel公司的AT91SAM7SE25和Altera公司的EP3C25搭建硬件系统。Max2769完成下变频、采样并输出中频数据;ARM实现控制功能;FPGA完成解调、相关累加功能。实验结果表明基带处理平台可以稳定跟踪GPS信号,16通道情况下,冷启动时间为80秒,系统水平定位误差优于40米。     

证券市场中庄家与散户间的确定性微分博弈

基于确定性微分博弈理论,建立了一种庄家与散户间的连续时间的博弈模型.首先将所有散户作为一个整体与庄家进行博弈,以博弈双方持股率的动态关系作为动态系统方程,并以此构建了一个确定性微分博弈模型; 然后运用开环纳什均衡和反馈纳什均衡分别求解出满足共态函数的常微分方程组和满足价值函数的Issacs - Bellman偏微分方程,以此得到庄家与散户博弈的开环纳什均衡策略和反馈纳什均衡策略.该结果可为金融监管部门监管证券市场和证券市场投资者买卖股票提供参考.     

CuZnAl形状记忆合金热机械循环滞回曲线与振动衰减特性研究

运用电子万能拉伸试验机、动态数据采集分析仪,测试了CuZnAl形状记忆合金的力-变形滞回曲线和安装有CuZnAl形状记忆合金耗能器框架结构的减振性能.借助透射电镜、X射线衍射仪,分析了CuZnAl形状记忆合金热机械循环过程中显微组织的变化.比较了不同热处理方式、不同相变点的CuZnAl形状记忆合金热机械循环后的滞回曲线面积及减振性能.试验结果表明:CuZnAl形状记忆合金用于框架结构的被动振动控制具有较好的减振性能,同时明显降低框架结构的振动频率.马氏体CuZnAl形状记忆合金耗能器具有较大的耗能能力,热机械循环数十次以后滞回面积亦大幅度减小,但相变点高的CuZnAl形状记忆合金的滞回面积减小幅度较小.