Very Long SiC‐Based Coaxial Nanocables with Tunable Chemical Composition

We present a simple process for the fabrication of very long SiC‐based coaxial nanocables (NCs). The versatility of this technique is confirmed by the ability to change the chemical composition of the NC outer layers from silica to carbon and boron nitride. The NCs consist of a SiC core approximately 30 nm in diameter with lengths up to several hundred of nanometers. The thickness of the coating is in the range 2–10 nm. The morphology and structural characterization of the NCs is investigated by scanning electron microscopy (SEM) and high‐resolution transmission electron microscopy (HRTEM), respectively, and their chemical composition is probed by electron energy loss spectroscopy (EELS). A vapor–solid growth mechanism is proposed to explain the growth of SiC‐based NCs of various chemical compositions, depending on the chemical nature of the vapor phase. Because of the large quantity of very long and interlaced NCs produced during the synthesis, the macroscopic aspect of the as‐grown material is like a self‐supported felt.     

Computer aided kinetic modeling with KMT and KME

The complexity of many chemical and refining reaction systems and the thus-derived tedious and time-consuming process of building the associated kinetic models have been major obstacles in the use of fundamental kinetics in the solution of chemical engineering problems. This review summarizes work aimed at removing theses obstacles. Our recent work that has led to the enhancement of the Kinetic Modeler's Toolbox (KMT) and the development of the Kinetic Model Editor (KME) presents an end-to-end solution to the kinetic modeling process, including automated feedstock modeling, reaction network construction, kinetic rate estimation, model programming, process system configurations, model customizations, compilations, model execution and results analysis.     

固体超强酸S_2O_8~(2-)/SnO_2-SiO_2催化合成环己酮1,2-丙二醇缩酮

采用沉淀-浸渍法制备了固体超强酸S2O28-/SnO2-SiO2,以它为催化剂催化环己酮和1,2-丙二醇合成了环己酮1,2-丙二醇缩酮;考察了带水剂种类及用量、酮醇摩尔比、催化剂用量、反应时间对产品收率的影响,并用正交实验对反应条件进行了优化。实验结果表明,适宜的反应条件为:n(环己酮)∶n(1,2-丙二醇)=1∶1.6、催化剂用量为反应物料总质量的2.0%、带水剂环己烷用量5.0mL、反应时间50min。在此条件下,环己酮1,2-丙二醇缩酮收率达到91.47%;催化剂的稳定性良好,在重复使用5次后环己酮1,2-丙二醇缩酮收率为82.20%,活性下降的主要原因为催化剂表面积碳和吸附了有机物;经傅里叶变换红外光谱和气相色谱质谱分析表明,产物为环己酮1,2-丙二醇缩酮,纯度为100%。     

用热分析法研究硝化棉的熔化过程

用ＭＤＳＣ，显微镜温台熔点测定仪和固体原位反应池／快速扫描傅立叶变换红外光谱联用装置考察了硝化棉的熔化过程。ＭＤＳＣ曲线表明吸热过程是可逆的，它系由ＮＣ和部分分解凝聚相产物的混合物的固液相变所引起。由ＮＣ的ＭＤＳＣ曲线得到的熔点，熔化含，熔化熵，分解含和分解反应热温熵分别为４７６．８４Ｋ，２０５．６Ｊ．ｇ＾－１，０．４３１２Ｊ．ｇ＾－１．Ｋ＾－１，－２４７５．０Ｊ．ｇ＾－１，－５．２４２Ｊ．ｇ＾－     

Adaptation of the microscopic properties of redox catalysts to the type of gas-solid reactor

Catalysts of selective oxidation usually work in a simultaneous redox mode in reactant/air cofed reactors. The solid must provide selective lattice oxygen according to a kinetic mechanism depending on operating conditions that differ from one reactor to another. Better catalytic performance can be obtained in a recirculating solids reactor because it allows separate optimization of the reduction and oxidation steps. Among the microscopic properties of the catalyst, the crystal morphology is to be taken into account because it influences its reactivity on stream. These considerations lead to a new approach of the catalyst-reaction-reactor trio.     

液相对流对固液界面稳定性的影响

以模型合金丁二腈－乙醇的强制性晶体生长为基础，利用自行研制的液相对流驱动装置，详细考查了液相自然对流及强迫对流作用下，模型合金平界面失稳的动态生长过程，证实了液相的流动加快了液相温度与浓度分布的均匀化，从而增强了液／固界面的稳定性。并且随流动速度的增加，界面稳定性提高。     

聚氧乙烯 - 聚氧丙烯 - 聚苯乙烯多嵌段聚合物的力学和导电性能研究

研究了聚苯乙烯含量对聚氧乙烯－聚氧丙烯－聚苯乙烯多嵌段聚合物的力学性能及其与ＬｉＣｌＯ４络合物的离子导电性能的影响；并以电导率较高的络合物为电解质，Ｎａ１＋ｘＶ３Ｏ８复合物和Ｌｉ片分别为正、负极组装了薄型锂电池并测定其放电性能。     

Oxidation of methane over platinum in a solid proton-conducting electrolyte cell

Studies of the complete oxidation of methane on a Pt electrode-catalyst in the cell with a solid proton-conducting electrolyte (CH₄ + O₂, Pt ¦ SrCe_0.92Dy_0.08O₃ ¦ Pt, H₂O + N₂) were carried out. The non-Faradaic effect of electrochemical hydrogen pumping on the rate of methane oxidation has been demonstrated. The induced change in the reaction rate at anodic polarization of a Pt electrode-catalyst was over two orders of magnitude higher than the rate of hydrogen pumping from the reaction zone through the electrolyte.     

Electrophilic chlorination of methane over superacidic sulfated zirconia

Catalytic chlorination of methane was studied over SO ₄ ^2– /ZrO₂, Pt/SO ₄ ^2– /ZrO₂, and Fe/Mn/SO ₄ ^2– /ZrO₂ solid superacid catalysts. The reactions were carried out in a continuous flow reactor under atmospheric pressure, at temperatures below 240°C, with a gaseous hourly space velocity of 1000 ml/g h and a methane to chlorine ratio of 4 to 1. At 200°C with 30% chlorine converted the selectivity in methyl chloride exceeds 90%. At more elevated temperatures, the selectivity decreases but stays above 80% in methyl chloride at 225°C using the sulfated zirconia catalysts. The selectivity can be enhanced by adding platinum to sulfated zirconia catalysts. An iron and manganese-doped catalyst exhibited excellent selectivities at somewhat lower conversions. Methyl chloride is obtained at 235°C in selectivities greater than 85%. No chloroform or carbon tetrachloride is formed. The electrophilic insertion involves electron-deficient metal-coordinated chlorine into the methane C-H bond.Catalysis by solid superacids, 29. For part 28 see ref. [14].     

Effect of harvesting time and fruit size on titratable acidity, soluble solid and distribution of limonin in Thai tangerine juice

The effect of fruit size and harvesting of Thai tangerine fruit ( Citrus reticulata , Blanco) at different growth stages, 8–12 months after fruit set, on the distribution of limonin in whole fruit as well as in the individual fruit parts and extracted juice was investigated. The highest limonin concentration was observed in seed, followed by albedo, flavedo, segment membrane and juice sacs in decreasing order. The limonin concentration in juice as well as in whole fruit was decreased when fruit was harvested 8–12 months of fruit set. Increasing harvesting time from 8 to 12 months showed corresponding decreases in the amount of limonin in flavedo, albedo and seed. There was a decrease in titrable acidity and increase in total soluble solid and total soluble solid/titrable acidity ratio of juice with a later than normal harvesting time. However, fruit size showed no effect on limonin content and other properties of juice extracted from tangerine.