三相Δ接法同步发电机带整流负载特性的数值仿真

基于同步发电机理论,建立了同步发电机三相定子绕组三角形接法带整流负载系统的数学模型,文中计及高次谐波气隙磁场和整流元件压降的影响,利用一种数值算法,对不同整流负载的特性进行仿真,给出它们的仿真波形,并进行比较。     

大型汽轮发电机组定子端部绕组固有频率的测试方法及应用

文章阐述了大型汽轮发电机定子端部绕组引线固有频率测试的目的和意义,介绍了测试的测试原理及现场测试情况,提出了对其推广应用方面的一些看法。     

发电机定子绕组接头焊接质量检测方法及判断标准

通过对鲁布革电厂发电机定子绕组接头焊接质量检测分析,探讨了接头焊接质量检测方法及判断标准。     

Improvement of inductive power collection in null-flux maglev system

In the superconducting maglev system it is important to develop a non-contact on-board power source without environmental pollution such as noise and exhaust gases; therefore, inductive power collection (IPC), which utilizes a harmonic magnetic field generated by ground coils in EDS, is being studied. However, alteration to a null-flux EDS that has a high drag ratio reduces the power collecting capacity in the IPC system. In addition, power collecting coils are located on the cryostat of the superconducting coil (SC), so eddy currents at the cryostat also reduce the power collecting capacity. Therefore, an exclusive SC type that locates the exclusive SCs and IPC and power collecting coils so as to face the upper and lower coils of ground coils, respectively, is examined; but we aim to improve the conventional type. After analyzing the influence of eddy currents at the cryostat in detail and improving the composition of the power collecting coil and cryostat, we found that the conventional type has the same capacity as the exclusive SC type. In order to prove the above-mentioned result, we measured the induced voltage of the new-type coils in a test run at Miyazaki test track and confirmed the output of this IPC system in a full-scale synthetic bench test with a PWM converter and magnetic field simulator. © 1998 Scripta Technica. Electr Eng Jpn, 122(2): 48–60, 1998     

MgZn铁氧体（偏转）磁性材料的X射线光谱测定与研究

提出了用Ｘ射线光谱仪粉末压片法熔融片法测定ＭｇＺｎ铁氧体各组分浓度的方法,对粉料的制备,均匀性状态颗粒度进行了一系列试验。     

一种检测水冷定子线圈堵塞的试验方法

介绍了一种新的检查水冷定子线圈堵塞的方法。     

考虑发电机约束条件的潮流计算方法

由于当发电机满足励磁电流限制时,并不能保证发电机定子电流不越限,当发电机满足定子电流限制时,也不能保证发电机励磁电流不越限,因此,本文将受发电机定子和转子电流约束下的节点定义为ＰＩ节点,同时,基于凸极式同步发电机定子电流和转了电流约束方程组,采用牛顿法分别推导了极坐标和直角坐标系统下的功率偏并型潮流方程,并给出ＰＩ节点的潮流雅可比矩阵元素修正公式,当考虑了定子电流和转子电流约束条件后,潮流计算的计     

黄河三门峡一花园口“82．8”大暴雨期间水汽输送分析

通过计算１９８２年７月２９日～８月２日黄河中游三门峡一花园口间区域的水汽通量、水汽通量散度和水汽净输送等特征量，分析了这次暴雨过程的水汽源地、水汽输送的物理过程和水汽净输送量与暴雨洪水的关系。结果表明，这次暴雨的水汽主要来自东部洋面上，低空偏东风急流和三花间地区的辐合上升运动共同构成了该地区水汽输送的通道，暴雨区内水汽的缔向福合是形成暴雨水汽福合的主要过程，水汽的经向辐散则是水汽输出的主要原因，而水汽的低层辐合、高层辐散及低层水汽向高层的垂直输送是降雨增强的机制。     

1981年8～9月黄河上游强连阴雨期水汽输送分析

对黄河上游兰州以上区域１９８１年８￣９月强连阴雨期主要降水时段水汽输送的计算和分析表明，这次降雨的水汽来自孟加拉湾，由５００ｈＰａ低槽前的西南气流输送水汽；降雨区内水汽的经向辐合是水汽辐合的主要过程，纬向辐散是水汽输出的主要机制，降雨中高原地形和垂直运动也明显影响了水汽输送和降雨；该区域水汽净输送量约占实测降雨量的９２％。     

Flux pattern and fouling of membranes during ultrafiltration of some dairy products

The flux pattern of milk (whole milk, skimmed milk and buttermilk) showed a distinct contrast to whey (sweet whey and acid casein whey) systems during ultrafiltration (UF) at constant composition. For milk systems, the initial flux was lower than for whey systems, but the flux stabilised within a few minutes of operation. However, for both acid and sweet whey, the flux continued to fall with time for nearly 1 h. The fouling coefficient (FC) for buttermilk was 0.6 after 5 min, rising to 0.68 after 60 min. During this time flux did not decline, suggesting that concentration polarisation (CP), rather than fouling, was controlling the flux rate. In contrast, the FC for whey was 0.5 after 5 min with a progressive rise over the next 55 min, but the flux also fell throughout this period suggesting that flux was controlled by fouling rather than CP. The higher concentration of protein in milk systems appeared to be responsible for CP, rather than fouling, being the controlling mechanism.