火炮身管内表面激光硬化处理的实验研究

提高身管寿命是火炮行业亟待解决的关键技术问题，激光表面改性技术是解决这一问题的有效方法之一。本文在分析激光表面相变硬化性能的基础上，对身管内表面进行了激光硬化处理实验研究，检测了其内表面阳线和阴线的硬化层硬度和深度，对比分析了离焦量和焦深对其内表面硬化层硬度的影响，并对激光相变硬化层金相组织进行了分析。经激光硬化处理后，身管的内表面硬度有明显提高，硬化层较深，且为很细的条状马氏体组织。     

Expanding the analytical potential of channel locational probability maps using cellular statistics

The planimetric shifts in channel location of large alluvial rivers are a critical component in the creation of diverse structures and functions in riverine habitats. Engineered management schemes must also compensate for this type of channel change to protect resources and maintain navigation channels. The stability of the Lower Mississippi River channel was assessed through an analysis of historical records of channel position produced and archived by the United States Army Corps of Engineers. Channel location was recorded for the years 1765, 1820, 1881, 1915, 1930, 1937, 1960 and 1970. Channel stability was measured by two introduced metrics on a cell‐by‐cell basis: (1) the standard deviation of Euclidean distance to a channel cell for the entire period of record, and (2) the rate of Euclidean distance change between years in the period of record. At a coarse spatial scale, channel instability increased in the downstream direction. The variability of channel stability also increased in the downstream direction. Analysis of this variability identified alternating areas of high and low stability occurring with greater frequency as distance downstream increased. These findings are validated by past studies of channel stability along the Lower Mississippi River. As a result, the proposed metrics provide a consistent, quantitative, efficient and cost‐effective means of identifying areas of channel instability at several spatial scales. Copyright © 2006 John Wiley & Sons, Ltd.     

A closed loop exponential feeding law: Invariance and global stability analysis

This article addresses the computation of invariant control laws [A. Fradkov, I. Miroshnik, V. Nikiforov, Nonlinear and Adaptive Control of Complex Systems, Kluwer, 1999] for fed-batch fermenters represented by two standard models. It will be shown how to derive partial state feedbacks that, assuming ideal conditions and perfect model, keep the specific growth rate μ constant provided the initial conditions are adequate. The invariant control law is the closed loop version of the exponential feeding already suggested in several references as shown later. The paper presents an analysis of invariance and a study of global stability within the framework of partial stability. That is, stability with respect to some of the state variables. This enables us to treat the case with Haldane-like or non-monotonous kinetics.     

微桥法镍膜的弹性模量和残余应力测量

利用MEMS技术制作了不同尺寸的镍(Ni)膜微桥结构样品。采用纳米压痕仪XP系统测量了微桥载荷与位移的关系,并结合微桥力学理论模型得到了两种不同尺寸的Ni膜的弹性模量和残余应力。结果表明,两种不同尺寸的Ni膜的弹性模量结果一致,为190 GPa左右,但是残余应力变化较大。与采用纳米压痕仪直接测得的带有硅(Si)基底的Ni膜弹性模量186.8 7.5 GPa相比较,两者符合较好。     

Towards implementation of a nickel silicide process for CMOS technologies

In this paper, we review some of the advantages and disadvantages of nickel silicide as a material for the electrical contacts to the source, drain and gate of current and future CMOS devices. We first present some of the limitations imposed on the current cobalt silicide process because of the constant scaling, of the introduction of new substrate geometries (i.e. thin silicon on insulator) and of the modifications to the substrate material (i.e. SiGe). We then discuss the advantages of NiSi and for each of the CoSi₂ limitations, we point out why Ni is believed to be superior from the point of view of material properties, miscibility of phases and formation mechanisms. Discussion follows on the expected limitations of NiSi and some of the possible solutions to palliate these limitations.     

牛头山水电站混凝土双曲拱坝设计和水库提前蓄水研究

牛头山水电站大坝为抛物线形混凝土双曲拱坝,最大坝高108.0 m,采用坝顶5孔开敞式溢洪道泄洪,挑流消能。为提前发挥水电站效益,在拱坝尚未完全封拱的情况下,通过计算分析,得出了水库可以下闸蓄水的结论。     

低密度微泡沫压井液的研究与应用

吐哈油田部分区块地层压力系数小于0.9,常规水基压井液对储层伤害大,若使用油基压井液成本高,环境污染严重。通过实验优选出了一种低密度水基微泡沫压井液。该压井液具有密度低、泡沫强度高、稳定性好、携砂能力强等优点。现场应用表明,低密度微泡沫压井液稳定时间大于48 h,密度在0.70~0.99 g/cm3之间可调,抗油污染能力强,抗油大于8%,抗温在100℃以上,岩心污染后渗透率恢复值大于80%;并且施工方便,成本低,具有储层保护能力,使用微泡沫压井液的井表皮系数在0.20~2.34之间。     

流域泥沙的资源化及其实现途径

本文以自然资源的概念和属性为基础，研究了流域泥沙的离散性、吸附性、可搬运性等属性，以及水沙不可分性、水沙不协调性、水沙时空分布不均匀性、水沙产生异源等特征。认为流域泥沙具有自然资源的有效性、可控性和稀缺性等属性，指出流域泥沙具有资源性，是一种特殊的自然资源。当流域泥沙在满足技术和社会等一定条件下，是可以资源化的。提出了实现流域泥沙资源化的目标和途径，其途径主要包括填海造陆、改良土壤和引洪淤灌、淤临淤背和作为建筑材料等。     

WuM1-1羽状分支水平井充气钻井液技术

WuM1-1井由1口多分支水平井和1口采气的直井组成。该井斜井段短,井斜率在30°/100 m以上,主井眼和10个分支井段总进尺6182 m,98%以上在煤层中钻进,煤层脆、压实性较好,更易发生掉块。为满足钻井对井壁稳定性、润滑性、井眼净化以及煤层保护等的要求,采用钾铵基聚合物防塌钻井液进行充气欠平衡钻井,在钻进中保持钻井液有合适的粘度、切力,选用合适的注气压力和注气量以及当量钻井液密度;每钻完一个立柱坚持循环几分钟,上下划眼一次,并泵入CMC高粘钻井液,配合有效使用固控设备,尽量使井眼干净;复配使用粉末状固体润滑剂和液体润滑剂。该钻井液性能稳定,易于维护,悬浮携岩能力强,润滑性好,井眼畅通,保证了WuM1-1井安全、快速、优质施工。该井在煤层钻进中无阻卡现象,井壁稳定,没有出现井壁掉块或井垮现象,水平连通一次成功,10口分支井悬空侧钻一次成功,只用57 d即顺利完井,比该地区常规钻井快49倍。     

Heavy Metals Bioremediation from Polluted Water by Glass-Ceramic Materials

The objective of this research was to study the removal of cadmium and lead from an aqueous solution through a biological treatment. For this purpose a glass-ceramic material was manufactured from industrial and urban wastes. Biofilms of microorganisms found in wastewater were developed on its surface, and continuous tests were conducted in the presence and absence of the biofilm to analyze the glass-ceramic's ability to remove the heavy metals from an aqueous environment. The results suggest that this bioremediation process, developed on an industrial scale, could represent an alternative to the chemical processes currently used.