高压电动机定子线圈匝间绝缘问题的探讨

在实践经验的基础上，分析了我国匝间绝缘短路的主要原因，提出在匝间绝缘的设计，制造工艺及耐压试验等工序采取合理措施，以提高匝间绝缘的可靠性。     

An investigation of induced voltages to an underground gas pipeline from an overhead transmission line

This paper investigates induced voltage characteristics from an overhead transmission line by applying a method of modeling of induced voltages proposed by the authors. EMTP simulation results obtained by the modeling method agree with analytical results obtained from a well‐known formula. The induced voltages are significantly dependent on the configuration of the overhead line. A horizontal line induces the largest voltage in a gas pipeline, and the voltage induced by a vertical twin‐circuit line is about 20% smaller than that induced by a vertical single‐circuit line. The method is applied to a real pipeline system and the simulation results show reasonable agreement with field test results. © 2008 Wiley Periodicals, Inc. Electr Eng Jpn, 164(1): 43–51, 2008; Published online in Wiley InterScience ( www.interscience.wiley.com ). DOI 10.1002/eej.20465     

变频调速器在桥式抓斗吊车中的应用

论文主要介绍了电机的调速方法、变频器的工作原理以及日本FRNIC500G7型变频器在桥式抓斗吊车上的应用，并分析了使用绕线式电机调速与鼠笼式电机变频调速之间的优缺点。     

PFC控制技术的一种改进方案

文章首先指出了目前ＰＦＣ所用控制技术的缺陷，然后提出了一各改进方案，并从理论分析和仿真验证的角度证明了改进方案的可行性和先进性。     

Series resonant ZCS‐PFM DC‐DC power converter with high‐frequency high‐voltage transformer link for high‐power magnetron drive

This paper presents a single lossless inductive snubber‐assisted ZCS‐PFM series resonant DC‐DC power converter with a high‐frequency high‐voltage transformer link for industrial‐use high‐power magnetron drive. The current flowing through the active power switches rises gradually at a turned‐on transient state with the aid of a single lossless snubber inductor, and ZCS turn‐on commutation based on overlapping current can be achieved via the wide range pulse frequency modulation control scheme. The high‐frequency high‐voltage transformer primary side resonant current always becomes continuous operation mode, by electromagnetic loose coupling design of the high‐frequency high‐voltage transformer and the magnetizing inductance of the high‐frequency high‐voltage transformer. As a result, this high‐voltage power converter circuit for the magnetron can achieve a complete zero current soft switching under the condition of broad width gate voltage signals. Furthermore, this high‐voltage DC‐DC power converter circuit can regulate the output power from zero to full over audible frequency range via the two resonant frequency circuit design. Its operating performances are evaluated and discussed on the basis of the power loss analysis simulation and the experimental results from a practical point of view. © 2005 Wiley Periodicals, Inc. Electr Eng Jpn, 153(3): 79–87, 2005; Published online in Wiley InterScience ( www.interscience.wiley.com ). DOI 10.1002/eej.20126     

10kV供电系统在煤矿生产中的应用

从多方面论证了井下超高压供电的可行性,并对矿井实际供电的应用情况进行了分 析,对6 kV、10 kV 2种供电系统的优缺点进行了对比,对大型矿井特别是超大型矿井供电提出了自 己的观点,对现代化大型矿井供电配置具有指导意义。     

Cyclic X-Y mechanical tests: A new method to perform in situ reversed-deformation experiments in the high-voltage electron microscope

There has been, in the past, only limited success with in situ cyclic or reversed plastic deformation tests in the transmission electron microscope (TEM). This is probably partly due to problems associated with buckling of the foil when an applied tensile or shear stress is reversed. Mechanical analysis shows that dislocation movement can be reversed by tensile stressing in alternating perpendicular directions (i.e., 90° rotations of a tensile stress); thus buckling of the foil can be avoided. A design for performing such X-Y in situ TEM tests is presented, with observations that demonstrate its feasibility.     

Characteristics and classification of high-current fault arcs on distribution systems

When a fault occurs on transmission or distribution systems due to lightning or overvoltage, often an arc discharge occurs at the fault point. The arc discharge, which is caused by a fault current, has a high current, high temperature, strong light emission, etc., thus it sometimes causes heavy damages to electric power equipment. The arc discharge is influenced by the conditions around the arcs, i.e., gas, insulation materials, gap length, weather, etc. Also, the arc voltage along the arc column indicates the characteristics of the arc. If the voltage waveforms of the arcs caused by the fault on transmission or distribution systems are classified, it is possible to find the location and the equipment where the fault occurred. In this paper, the arc voltage data in 6-kV class XLPE cables and 6-kV class overhead lines are analyzed and an artificial neural network method is applied to classify the arc voltage waveforms. The results obtained from the six artificial neural networks developed show that the artificial neural network method is effective for classification of arc voltage waveforms if adequate input parameters are selected.     

基于TMS320F2801 DSP新型电压监测仪的设计

针对目前普遍使用的电压监测仪在运行中存在的问题,从硬件及电气回路分析不足之处,提出基于TMS320F2801 DSP的改进型电压监测仪。     

孟加拉HATHAZARI 132kV电缆回流线取舍探讨

针对孟加拉Hathazari 100MW重油发电机组EPC工程132kV电缆现场实际设计、采购和敷设情况,通过理论计算探讨回流线取舍问题。