Voltage sag compensation with minimum energy injection by use of a micro‐SMES

This paper presents a method to compensate voltage sags with minimum energy injection for a series‐connected voltage restorer using a micro‐SMES. A circuit for extracting the fundamental symmetrical components from sag voltages and a minimum energy injection algorithm is described. Simulations of voltage sag compensation have been carried out using PSCAD/EMTDC for various faults. The simulation results confirm the validity of the proposed method and show the possibility of reducing the size of energy storage devices. © 2002 Wiley Periodicals, Inc. Electr Eng Jpn, 141(3): 70–80, 2002; Published online in Wiley InterScience ( www.interscience.wiley.com ). DOI 10.1002/eej.10047     

Highly efficient wideband continuum generation in a single-mode optical fiber by powerful broadband laser pumping

By pumping a single-mode optical fiber with a powerful broadband nonselective dye laser, we obtain a high-efficiency wideband continuum (530-930 nm) with nonlinear conversion efficiency exceeding 90%. Experimental conditions for a coherent regime of broadband stimulated Raman scattering are created, which in combination with the broadband self-phase modulation and the four-photon parametric processes leads to a spectral broadening and to the continuum formation. The influence of the pump laser spectral linewidth on the nonlinear conversion efficiency is analyzed and investigated by comparative experiments at narrow-band and broadband laser excitations.     

Degradation of organophosphorus pesticides in aqueous extracts of young green barley leaves (Hordeum vulgare L)

The degradation of the organophosphorus pesticides malathion, chlorpyrifos, guthion, diazinon, methidathion and parathion in an aqueous extract of young green barley leaves (Hordeum vulgare L) was monitored by gas chromatography. Aqueous solutions of various amounts of freeze‐dried young barley leaves containing 5.75 mg l⁻¹ of malathion were incubated at 37 °C and pH 7.4 over prolonged time periods. Over 95% of the malathion degraded in 4 h in a 3% (30 g l⁻¹) solution of young green barley leaves. When the barley solution was autoclaved at 120 °C for 25 min prior to the addition of malathion, no degradation of malathion was observed. When 10 mg l⁻¹ each of the above six pesticides was incubated in a 15% (150 g l⁻¹) solution of young green barley leaves for 3 h at 37 °C and pH 7.4, malathion and chlorpyrifos degraded 100%, whereas parathion (75%), diazinon (54%), guthion (41%) and methidathion (23%) showed lesser degrees of degradation. © 1999 Society of Chemical Industry     

Combination of cytomegalovirus enhancer with human cellular promoters for gene-induced chondrogenesis of human bone marrow mesenchymal stem cells

High-expression plasmid vectors for human mesenchymal stem cells (MSCs) were constructed by combination of cytomegalovirus immediate-early enhancer with cellular promoters. MSCs transfected with the vector showed higher transgene production of a cytokine, which increased the differentiation level to chondrocytes.     

Material design using genetic algorithms and preparation of innovative UV-reflecting composite

The neck is a sun-exposed area. It seems to show the symptoms of photo-ageing as well as facial skin in the elderly. However, the physiological study of neck skin has hardly been reported. We examined the change of skin physiological properties at a neck site with ageing for 61 women (18—69 years old) compared with a cheek site. Water content in stratum corneum (SC) was higher, transepidermal water loss (TEWL) was lower and the turnover rate of SC judged from corneocyte area was slower at the neck site compared with the cheek site. Skin thickness was thinner, skin extensibility and elasticity were higher, skin grooves were deeper, and anisotropy of skin furrows was lower at the neck site than those at the cheek site. It was shown that the neck was also affected by sunlight but not so much as the cheek from the result of gelatinase activity detected in the tape stripped SC. Skin elasticity decreased with ageing at the neck site as well as the cheek site. Fine wrinkles were remarkably increased in the direction of Langer's line with ageing at the neck. Most skin physiological parameters at the neck showed the value between the cheek (heavily sun-exposed area) and back (not sun-exposed area). From these results, it was considered that not only intrinsic ageing but also photo-ageing affected the neck skin. We developed the prototype of cosmetics corresponding to neck skin physiology based on these results, and evaluated the effectiveness of the prototype product by a consumer test including skin measurement for 4 weeks. After treatment, water content increased, and it gave satisfaction in the skin colour brightness, skin elasticity and skin texture improvements for almost all volunteers. It was concluded that the prototype product was useful in neck skin treatment.     

A new method for preparing high impact polypropylene and polyethylene

Summary The impact strength of polypropylene was improved by adding propylene-vinylsilane copolymer (PVS) in the presence of tris(triphenylphosphine)rhodium chloride(TPR). The impact strength of polyethylene at low temperature was also improved by adding TPR and PVS which is brittle at low temperature. These phenomena were not observed when polymers were mixed without TPR.     

Gas absorption accompanied by an instantaneous irreversible reaction in laminar falling films of pseudoplastic liquids

Gas absorption accompanied by an instantaneous irreversible chemical reaction into laminar falling films of power-law liquids was studied theoretically. The convective-diffusion equations for a solute gas and a liquid-phase reactant were solved numerically and the numerical solution for the reaction factor was obtained as a function of the Graetz number, the concentration ratio, the diffusivity ratio and the power-law index of the liquid.     

Anodic characteristics of amorphorous palladium-base alloys in sodium chloride solutions

The anodic characteristics of a variety of amorphous palladium-base alloys were examined with a view to their use for the production of sodium hypochlorite by electrolysis of dilute sodium chloride solutions at ambient temperature. The corrosion resistance of palladium-metalloid alloys was obtained by alloying with platinum group metals and/or valve metals. Among these alloys, rhodium-containing alloys showed high electrocatalytic activities for chlorine evolution. Surface activation treatment was, however, necessary to obtain sufficiently high activities for chlorine evolution at low overpotentials. Surface-activated amorphous alloys possessed considerably higher current efficiency for chlorine evolution in comparison with currently used anodes.