Feasibility analysis of membrane reactors – discovery of reactive arheotropes

A feasibility analysis methodology adopted from reactive distillation is applied to membrane reactors. A model is formulated to depict the reactive liquid phase composition on the retentate side of a continuous type membrane reactor. The effects of both the chemical reaction kinetics and the membrane mass transfer kinetics on the feasible products are elucidated by means of retentate phase diagrams and bifurcation analysis. The proposed method can be applied to various membrane processes, independent of the specific structure of the membrane. Two quaternary reaction systems are considered to illustrate the methodology. In the first hypothetical system, it is shown how selective membranes can influence the sequence of effective volatilities which in turn affects the feasible products of the system. In the second example of practical importance, i.e. the heterogeneously catalysed synthesis of propyl acetate coupled with permeation through a porous polycarbonate membrane, the dusty gas model is applied to describe the component fluxes through the membrane. For the latter reaction system, the existence of reactive arheotrope is demonstrated. Arheotropes represent mass transfer controlled feasible products of membrane separation process.     

New balance ground relay for parallel four-circuit transmission lines

A 66-kV network generally is grounded through a neutral grounding resistor. In this network a single-phase ground-fault current is limited to as small as 100 to 400 A. There are parallel four-circuit transmission lines mounted on the same tower in the 66-kV network. In such transmission lines, the load and the fault currents could induce circulating current that flows through the lines. Since the circulating current has zero-phase-sequence and negative-phase-sequence components, it could cause unwanted operation of a balance ground relay using zero-phase-sequence current. However, it is difficult to compensate for the circulating current by the conventional vector compensation scheme. This paper presents a new balance ground relay to deal with the circulating current. In the relay from the ground-fault inception until first tripping, the difference current Δ3I_2d of negative-phase-sequence current 3I_2d of the differential current between two protected lines is used as an input current. The Δ3I_2d is the difference current of 3I_2d between, before and during faults. After the first tripping, the difference current of positive-phase-sequence load current and zero-phase-sequence current of the forementioned differential current are used as an input current. Consequently, a higher sensitivity of the ground-fault protection for these lines has been achieved. The correct operation of the new balance ground relay was confirmed when a single-phase-ground-fault occurred in the parallel four-circuit transmission lines, to which the relay is applied.     

超薄SiO2层的热生长

隧道小孔中超薄ＳｉＯ２的生长是ＥＥＰＲＯＭ电路制造的关键工艺之一。采用ＳＵＰＲＥＭ－Ⅲ工艺模拟程序对超薄ＳｉＯ２的热生长进行了工艺模拟，经过大量的工艺实验及优化，确定了超薄ＳｉＯ２的最佳生长条件，生长出的ＳｉＯ２性能良好，完全可满足ＥＥＰＲＯＭ研制的要求。     

Accurate estimation of environment parameters from ultrasonic data

This paper describes a robust and accurate ultrasonic sensing system for a mobile robot. The system continuously updates a local map of the environment in which obstacles are represented by straight lines or points in a robot centered coordinate frame. The presented algorithms use a Kalman filter for the reduction of the noise in the ultrasonic data and use a systematical error correction (‘bundle correction’) to reduce the uncertainty in obstacle direction. Experiments are carried out in simulation and with a real mobile robot system. Results show that the accuracy with which line parameters can be estimated is in the order of 1 degree for the orientation and about 2 cm for the position. The effect of the bundle correction is significant and maximal when the robot approaches walls under a small angle.     

淀积条件对GDa—SiNx薄膜电学特性的影响

本文讨论了用辉光放电法制备氮化硅薄膜时衬底温度、射频功率和气体流量比对薄膜的电导率、介电常数和击穿强度的影响。通过优化生长条件，制备了优质非晶氮化硅薄膜，其介电常数为７．５、击穿强度为５．５ＭＶ／ｃｍ、电导率为１０－１３（Ωｃｍ）－１。     

Neue Entwicklungen beim Hohlkatoden‐Gasflusssputtern. New Developments in Hollow Cathode Gas Flow Sputtering

The gas flow sputter technique was invented a few years ago particularly for the inexpensive fabrication of sophisticated ceramic layers. Meanwhile, it has matured and become increasingly powerful. Today it is on the verge of being applied in industrial fabrication processes. The present article gives an overview over the method, its characteristics and the numerous applications.     

Rückgewinnung von Vinylchloridmonomer

The production of the polymer polyvinylchloride (PVC) emits a high amount of waste gas. The recovery of the evaporated base product vinylchoridemonomer (VC) is an important aspect for the economics of the whole process. Membrane and vacuum technology improve the efficiency and the economics of the recovery process considerably.     

提高E^2PROM中NMOS管源漏穿通电压的实验研究

为了提高Ｅ＾２ＰＲＯＭ中Ｎ管源漏穿通电压，用实验的方法对制造工艺进行了研究。结果表明，高能量注入是提高ＶＰＴ的有效手段，但受到ｐｎ结击穿的限制，只适用于低区短沟Ｎ管；ＤＤＤ工艺大幅度高ＶＰＴ，但ｐｎ结击穿电压低于２０Ｖ，不能应用于高压ＭＯＳ管；采用适量的防穿通注入和适当增大沟道长度为最理想的工艺途径。     

稻壳基碳量子点对废水中Pb(Ⅱ)的检测

为了进一步实现生物质废弃资源的综合利用,以及对废水中污染物的检测,以稻壳粉为原料,在600℃和N2氛围下煅烧完成后使用一步水热法制备了钝化剂修饰的碳量子点,得到荧光为蓝绿光的二酸铵(ACA-CQDs)改性稻壳基碳量子点.采用SEM/EDS、HRTEM、FTIR等现代分析技术对碳量子点进行了理化特性表征,发现二酸铵(ACA-CQDs)量子点可以成功检测水中的Pb(Ⅱ).建立了一种有效的检测水体中Pb(Ⅱ)简便快速高效的方法.