Solutions to a combined problem of excessive hydrogen sulfide in biogas and struvite scaling.

The Woodman Point Wastewater Treatment Plant (WWTP) in Western Australia has experienced two separate problems causing avoidable maintenance costs: the build-up of massive struvite (MgNH4PO4. 6H2O) scaling downstream of the anaerobic digester and the formation of hydrogen sulfide (H2S) levels in the digester gas to levels that compromised gas engine operation and caused high operating costs on the gas scrubber. As both problems hang together with a chemical imbalance in the anaerobic digester, we decided to investigate whether both problems could be (feasibly and economically) addressed by a common solution (such as dosing of iron solutions to precipitate both sulfide and phosphate), or by using separate approaches. Laboratory results showed that, the hydrogen sulfide emission in digesters could be effectively and economically controlled by the addition of iron dosing. Slightly higher than the theoretical value of 1.5 mol of FeCl3 was required to precipitate 1 mol of dissolved sulfide inside the digester. Due to the high concentration of PO4(3-) in the digested sludge liquor, significantly higher iron is required for struvite precipitation. Iron dosing did not appear an economic solution for struvite control via iron phosphate formation. By taking advantage of the natural tendency of struvite formation in the digester liquid, it is possible to reduce the risk of struvite precipitation in and around the sludge-dewatering centrifuge by increasing the pH to precipitate struvite out before passing through the centrifuge. However, as the Mg2+/PO4(3-) molar ratio in digested sludge was low, by increasing the pH alone (using NaOH) the precipitation of PO4(3-) was limited by the amount of cations (Ca2+ and Mg2+) available in the sludge. Although this would reduce struvite precipitation in the centrifuge, it could not significantly reduce PO4(3-) recycling back to the plant. For long-term operation, maximum PO4(3-) reduction should be the ultimate aim to minimise PO4(3-) accumulation in the plant. Magnesium hydroxide liquid (MHL) was found to be the most cost-effective chemical to achieve this goal. It enhanced struvite precipitation from both, digested sludge and centrate to the point where more than 95% PO4(3-) reduction in the digested sludge was achieved.     

A comparison of leaf-spring with aircushion trailer suspensions in the transport environment

Packaging engineers need to be able to accurately determine the forces present in the shipping environment in order to protect packaged goods. The purpose of this study was to determine the vertical vibration levels measured in three separate truck-trailer suspension systems; conventional leaf-spring, conventional air-ride and damaged air-ride. The main conclusion reached in this study is that the air-ride suspension when maintained gives lower power density (PD) levels on all road surfaces studied. A damaged air-ride suspension and leaf-spring suspension are very similar in response frequencies, although the damaged air-ride produces higher vibration levels at lower frequencies.     

Thirty years later: Attitudes toward the employment of older workers.

Replicated W. K. Kirchner and M. D. Dunnette's (see record 1955-03161-001) study on attitudes toward older workers with 71 male and 5 female hourly employees (aged 18–61 yrs) and 22 male supervisors (aged 27–63 yrs) of a nonunion manufacturing plant. Ss completed a questionnaire that was nearly identical to the one administered in the Kirchner and Dunnette study. Results are similar to those obtained in the earlier study: Hourly workers held more positive attitudes toward older employees than did supervisors, and attitude score correlated strongly with the age of hourly workers but not with the age of supervisors. (9 ref) (PsycINFO Database Record (c) 2010 APA, all rights reserved)     

Numerical methods for colorimetric calculations: Sampling density requirements

This article quantifies errors arising from various integration methods and from sampling density in the numerical estimation of colorimetric integrals, e.g., tristimulus values. Both data sampling density and various numerical integration method errors will be distinguished. A test is presented to quantify sampling interval requirements for accurate colorimetric calculations for various illuminants. © 1992 John Wiley & Sons, Inc.     

Application of infrared reflectance spectroscopy to the analysis of milk and dairy products

A method for the rapid, simultaneous determination of protein, fat, carbohydrate, non-protein nitrogen and total solids in milk and liquid dairy products by infrared reflectance spectroscopy is presented. The method is calibrated against known standards obtained by conventional, time-consuming wet chemical methods but, once calibrated, can be operated routinely by non-skilled personnel. The method is sensitive and accurate down to 0·5% w/v and can be applied to most liquid samples without any need for prior preparation.     

No Science without Semantics

Computer science often faces the criticism that it isn't actual science. Doing science means using the scientific method, which includes reporting results so that others can repeat and verify them. The problem with the computer science community is the lack of shared terms with precise semantics. When a researcher reports phenomenal results that can't be replicated, the author might be viewed as a brilliant alchemist, but such works undermine claims of being "science."     

Analysis of a homologous series of non-reducing oligosaccharides from Arnica montana L. Roots

The oligosaccharide component compositions of a series of non-reducing oligosaccharides extracted from the roots of Arnica montana L. has been determined by gel permeation chromatography (g.p.c.). The range of oligosaccharides present was found to extend beyond the octasaccharide previously reported. with 16% to 19% of the oligosaccharides having a degree of polymerisation of between 11 and 19 and almost 3% having a degree of polymerisation greater than 20. The chromatographic behaviour of this series of oligosaccharides is compared with that observed for series of D-gluco-oligosaccharides.