A feasibility study of a direct-mapping parallel processing method to solve linear equations in load-flow calculation

With the growing size and complexity of power systems, system analysis—such as transients calculation—takes much time. Hence, fast calculation methods are required. Although parallel processing is a hopeful method, there have been difficulties in the parallel solution of linear equations which appear in power-flow calculations by the Newton-Raphson method. This paper aims at the fast calculation of the power-flow problem by means of parallel processing. In order to improve the suitability to the parallel solution of the differential equation in transients calculation, we assume the use of a direct-mapping parallel processing machine to map directly the network of a power system onto a network of processors. Under this assumption, we propose a new parallel-processing-oriented method in which the linear equation is solved by linear iterations between nodes with Aitken acceleration. We simulate the method on three model power systems and compare this Parallel Iterative Method (PIN) with a Parallel Direct Method (PDM) which uses the banded matrix according to the number of operations required. As a result, we can expect that PIM may solve linear equations faster than PDM with m processors, although the PIM might be inferior to the PDM with m × m processors, where m denotes the half-band width of the banded matrix.     

Effective lightning protection schemes for distribution line

The causes of lightning outage are subdivided into direct lightning strokes and induced lightning strokes, which are identified by the characteristics of the lightning overvoltage. In the past, lightning protection devices were directed mainly toward the latter, and attention has been focused on the installation of lightning protection devices, ground wires, and reinforcement of insulators. However, lightning outages continue to occur. Thus it is extremely important to clarify the fault characteristics of lightning surges and to study the effectiveness of various lightning protection devices by considering both direct lightning stroke and induced lightning stroke in order to prevent lightning outage in the future. In this research, the electromagnetic transients program (EMTP) has been applied to the direct lightning stroke, and the induced lightning outage analysis program for multiple conductor systems has been applied to the induced lightning stroke to study the effectiveness of lightning protection devices provided by combination of various lightning protection devices. The most effective lightning protection schemes are analyzed and evaluated based on verification tests on the full scale models as well as economic considerations.     

Laser scanning path generation considering photopolymer solidification in micro-stereolithography

It is essential to automate the scanning path generation process to effectively implement the micro-stereolithography. However, a scanning path that is generated based only on a 3D CAD model introduces dimensional inaccuracies. In micro-stereolithography, the photopolymer solidification is affected by fabrication conditions, such as the optical properties (laser power, laser scanning speed, laser scanning pitch focusing condition, etc.) and material properties of the photopolymer. Thus, the photopolymer solidification phenomena must be considered when generating a laser scanning path. In this paper, a scanning path generation algorithm that uses 3D CAD data and considers the photopolymer solidification phenomena is proposed to improve the dimensional accuracy in micro-stereolithography. Multi-line photopolymer solidification experiments were performed for various laser scanning conditions to examine the photopolymer solidification phenomena. From these experiments, linear relations between the solidification length (width) and scanning length (width) were acquired and stored in a database. Subsequently, these data were utilized to compensate the scanning path of the laser beam. In addition, experiments for determining the layer thickness in the z-direction were performed and these results were also used in the scanning path generation algorithm.This research was supported by the Highly Advanced National Project (http://www.most.go.kr), which performs some of the National R&D Program, and sponsored by the Korean Ministry of Science and Technology under the contract project code M10214000116-02B1500-02010.     

Volatile organo-halogen trace analysis in beverages by thin-layer headspace enrichment and electron-capture gas-chromatography

Applicability of thin-layer headspace (TLHS) procedure giving an aqueous concentrate and also classical purge and trap (PT) in off-line mode to isolate and enrich volatile organohalogen compounds in common beverages was tested. Both enrichment tech-niques were used in combination with gas chromatography – electron capture detection (GC-ECD). TLHS, combined with direct aqueous injection (DAI)-GC-ECD, proved applicable in the determination of volatile organohalogen compounds in all studied beverages, while the PT in a version with no preliminary sample pre-treatment was of limited applicability. Detection limits of the TLHS-based procedure were in the order of 1 ppt. Content of volatile organohalogen compounds in a number of beverages available on the Polish market including mineral waters, beers, juices, carbonated and non-carbonated soft drinks, etc. was determined by means of TLHS-DAI-GC-ECD.     

TRVs and fault clearing stresses in extra-high-voltage radial networks

To cope with the high rate of increase of power demand in the main industrialized districts in Japan, 550-kV transmission systems covering the districts have been reinforced, with most of the main power plants connected directly to these systems. Through 550-/300-kV substations, the majority of power to the districts is supplied by 300-kV systems. To limit the excess short-circuit capacity in the 300-kV systems, they tend to be reconstructed as so-called radial networks. In radial networks with high short-circuit capacity and relatively small number of transmission lines connected to the substation busbars, the rate of rise of TRV can be far higher than standard value. This paper analyzes the transient recovery voltages (TRV) in such extra-high-voltage radial networks in Japan, together with the relevant stresses to circuit-breakers during fault clearings. Future system conditions have also been introduced. As the typical rate of rise of the TRV values, more than twice that of today's standard ones are probable.     

利用Liapanov直接方法判定差分方程稳定性

研究差分方程稳定性的强有力的方法是Liapanov直接方法,这一方法的核心思想是针对所研究的方程,构造出其相应的Liapanov函数,利用它来判定方程的稳定性．     

普光气田邻井干扰压降研究

根据普光气田现场资料,分析普光气田关井压降恢复时间和稳定生产时间的关系。建立邻井干扰计算模型,评价邻井干扰压降值及邻井干扰,并对邻井干扰规律进行敏感性分析。     

WWW上路径模式发掘的研究

本文从互连网发展的趋势入手,对路径模式发掘进行了研究。先简要介绍数据库发掘的概况及网上数据发掘的特点,后结合关联法和组合概率法,并以算法和实例详细对之进行分析。     

Heuristics for determining a patrol path of an unmanned combat vehicle

We consider a problem of finding a path of an unmanned combat vehicle that patrols a given area by visiting a given set of checkpoints with the objective of minimizing possibility of enemy’s infiltration. In this study, we focus on a situation in which the possibility of enemy’s infiltration at (through) each checkpoint is increased nonlinearly as time passes and the checkpoint may be patrolled multiple times during a planning horizon. We develop two-phase heuristics in which an initial path is constructed in the first phase and then it is improved in the second phase. For evaluation of the performance of the proposed heuristics, computational experiments are performed on randomly generated problem instances, and results show that the heuristics give good solutions in a reasonably short time.     

Combination of non-classical pseudospectral and direct methods for the solution of brachistochrone problem

In this paper, we propose a combination of non-classical pseudospectral and direct methods to find the solution of brachistochrone problem. The method converts the optimal control problem of brachistochrone, into a sequence of quadratic programming problems. To this end, the quasilinearization method is used to replace the nonlinear optimal control problem into a sequence of constrained linear-quadratic optimal control problems; then each of the state variables is approximated by a weighted interpolation function based on the non-classical orthogonal polynomials. The method gives the information of the quadratic programming problems explicitly (the Hessian and the gradient of the cost function). Using this method, the solution of the brachistochrone problem is compared with those in the literature.