A novel way to treat refractory waste: Sonication followed by wet oxidation (SONIWO)

The effectiveness of the hybrid system sonication followed by wet oxidation (SONIWO) to treat otherwise refractory waste has been demonstrated. In such a hybrid system homogeneous CuSO₄ catalyst was found to be very efficient.     

Breakdown characteristics of oil and paper insulation for a very fast transient voltage

This paper describes the dielectric breakdown characteristics of oil and oil‐impregnated paper for very fast transient (VFT) voltages. Blumlein circuits generate VFT voltages of 60 and 300 ns in a pulse width that simulates disconnecting switching surges in gas‐insulated switch gears. We measured the breakdown voltages of needle‐to‐plane, plane‐to‐plane oil gaps and several pieces of paper between plane electrodes for VFT and lightning impulse voltages. The measured data were formulated in V‐t characteristics and Weibull probability distributions. The inclination n of V‐t characteristics of insulating paper is 150, which is less than n = 13.7 of the plane‐to‐plane oil gap in the VFT time range. The shape parameters of Weibull distribution obtained in this study show that the scattering of breakdown voltages of paper is much less than that of oil. © 2002 Wiley Periodicals, Inc. Electr Eng Jpn, 141(4): 16–24, 2002; Published online in Wiley InterScience ( www.interscience.wiley.com ). DOI 10.1002/eej.10043     

Formation of C4 species in the deactivation of a Pd/SiO2 catalyst during the selective hydrogenation of acetylene

The deactivation characteristics of Pd/SiO₂ in the selective hydrogenation of acetylene were correlated with changes in the amount of the C4 species produced. The amounts of butenes produced changed in parallel with the catalyst activity, indicating that the rate limiting step for butene production was the same as that for acetylene hydrogenation. On the other hand, the amount of 1,3-butadiene produced changed, showing a maximum with catalyst deactivation because 1,3-butadiene is an intermediate in the sequential reaction process which involves both the production and consumption of 1,3-butadiene. This was verified by a simultaneous TG/reaction experiment showing that 1,3-butadiene was a precursor of green oil. The catalyst showed a self-regenerative behavior in its activity and the amounts of C4 species produced during the early stage of deactivation because two opposite factors, which contributed to either the lowering or the promotion of activity, were involved in the process. A specific type of polymer species, produced during the initial period of deactivation, is proposed to be responsible for the promotion of catalyst activity.     

Municipal solid waste conversion to energy

In recent years it has been recognised by an increasing number of nations that there is considerable energy potential within MSW. As a result many countries have established R,D& D programmes to examine methods of exploiting this potential. The IEA's MSW Conversion Activity was set up in 1986 to provide an infrastructure for sharing information and co-ordinating work in this area internationally. This Activity was extended in 1989 and currently a total of 9 nations participate in it.

To cope with the wide scope of the area (encompassing both biological and thermal processing of MSW) the Activity was divided into three subgroups or Expert Working Groups (EWGs). Each of these dealt with a distinct area of expertise:

1. •Downstream effects of source separation and screening of MSW

2. •Sampling and analytical protocols

3. •Landfill gas

In addition to these groups a central secretariat based at Harwell (UK) has provided guidance, established and administered databases of contacts and produced a series of national reports.

This paper describes the achievements of the Activity and discusses work proposed for the future.     

Temperature and pressure effects on supercritical CO2 extraction of tomato seed oil

Tomato seed oil was extracted with supercritical carbon dioxide in a semibatch-flow extractor within the temperature range 313–343 K and the pressure range 10.8–24.5MPa. The extraction rates increased with pressure, but decreased with temperature increase because of the variation in solvent density and resultant differences in oil solubility. The fatty acid composition of the extracted oil was similar to that of soybean oil.     

Spontaneous emulsification aspect of enhanced oil recovery

Recent studies have suggested the possibility of spontaneous emulsification as a mechanism for enhanced oil recovery (EOR). The discussions have, however, remained essentially qualitative. A study was therefore undertaken to estimate quantitatively the contribution of spontaneous emulsification as an EOR mechanism. The tests were conducted on several bulk liquid/liquid systems as well as by displacement experiments in unconsolidated synthetic sand packs. Spontaneous emulsification was found to be a mechanism for EOR: the estimated extra contribution to EOR due to this mechanism was found to be significant in laboratory scale displacement experiments. Tertiary recovery was always greater when spontaneous emulsification was evident than otherwise. Results of tests on bulk liquid/liquid systems indicate that the occurrence or absence of spontaneous emulsification can be correlated with the values of ‘partition parameter’. It may be concluded that higher oil recoveries may be achieved in chemical EOR processes where interface mass transfer (and the accompanying spontaneous emulsification) occurs. The evaluation of efficiency of residual oil mobilisation through the capillary number theory (with and without spontaneous emulsification) is also discussed. Displacement tests with spontaneously emulsifying systems showed that residual oil left behind a conventional waterflood was mobilised in a range of capillary numbers much less than that which applies to low-tension waterfloods.     

Surface tension as a limiting factor for aerobic n-alkane biodegradation

A new mathematical model for n-alkane biodegradation in crude oil, heavy oil and paraffinic mixtures is described. The pattern of n-alkane degradation as a function of the inverse of hydrocarbon chain length reported in this paper can be considered as general behaviour for many aerobic n-alkane biodegradation processes. A new interpretation of n-alkane biodegradation as a function of surface tension, is given. A mathematical expression was obtained starting from the degradation values of n-alkane and relative surface tension, which is a parameter independent of fermentation conditions. An interesting parameter, b, was identified which represented the accelerating conversion factor for n-alkane biodegradation. The findings suggested that the n-alkane biodegradation. The findings suggested that he n-alkane biodegradation rate may be affected by the fermentation condition (agitation, aeration, etc.) and by the strain of microorganism, while the behaviour pattern of n-alkane degradation was essentially linked to the substrate characteristics (molecular structure, molecular weight and density).     

Determination of heavy metals and volatile aromatic compounds in used engine oils and sludges

Assessment of contaminant releases during utilization of used oils is essential for the determination of environmental acceptability. These paper reports the results of the study examining a toxic metal leachability from used engine oil and sludge samples employing leaching test (TCLP). The leaching test indicated that lead in oil samples exceeded 5-ppm concentration level what qualified them as a toxic waste. The samples of contaminated sludge were found to contain high concentration of total lead, barium and chromium, but the leaching test showed concentration below regulatory limit. The total content of benzene, ethylbenzene, toluene, and xylenes (BETX), and naphthalene in used oil and sludge samples was also determined and was found not to be a significant factor to contamination.     

Effect of mixing leaves with olives on organoleptic quality of oil obtained by centrifugation

Variable quantities of leaves were added to ripe olives prior to extraction to determine their effect on the quality of the resulting olive oil. The addition of 1–3% w/w leaves improved the organoleptic quality. An increase intrans-2-hexenal aldehyde content occurred, giving the pleasant flavor of “freshly cut grass.” This compound was produced by the enzymatic breakdown of 13-L-hydroperoxide of linolenic acid in leaf homogenates.