Breakdown characteristics of oil and paper insulation for a very fast transient voltage

This paper describes the dielectric breakdown characteristics of oil and oil‐impregnated paper for very fast transient (VFT) voltages. Blumlein circuits generate VFT voltages of 60 and 300 ns in a pulse width that simulates disconnecting switching surges in gas‐insulated switch gears. We measured the breakdown voltages of needle‐to‐plane, plane‐to‐plane oil gaps and several pieces of paper between plane electrodes for VFT and lightning impulse voltages. The measured data were formulated in V‐t characteristics and Weibull probability distributions. The inclination n of V‐t characteristics of insulating paper is 150, which is less than n = 13.7 of the plane‐to‐plane oil gap in the VFT time range. The shape parameters of Weibull distribution obtained in this study show that the scattering of breakdown voltages of paper is much less than that of oil. © 2002 Wiley Periodicals, Inc. Electr Eng Jpn, 141(4): 16–24, 2002; Published online in Wiley InterScience ( www.interscience.wiley.com ). DOI 10.1002/eej.10043     

An on-chip active decoupling circuit to suppress crosstalk in deep-submicron CMOS mixed-signal SoCs

A decoupling circuit using an operational amplifier is proposed to suppress substrate crosstalk in mixed-signal system-on-chip (SoC) devices. It overcomes the parasitic inductance problem of on-chip capacitor decoupling. The effect of the proposed decoupling circuit is not limited by parasitic fine impedance. A 0.13-/spl mu/m CMOS test chip showed that substrate noise at frequencies from 40 MHz to 1 GHz was incrementally suppressed by sequentially activating three of the proposed circuits in parallel. The power dissipation of each circuit was 3.3 mW at a 1.0-V power supply. The test chip measurement showed that the proposed decoupling reduced crosstalk by 31% at 200 MHz, whereas it was reduced by 4.4% with capacitor decoupling. This 7:1 ratio, or 17 dB, corresponds to the gain of the opamp. Design of the opamp and its feedback loop for active decoupling is simple, making the opamp useful for SoC applications.     

Measurements of distribution of self-bias potential on an RF-plane electrode in plasma etching devices

The self-bias potential (V_dc) induced on an RF-powdered electrode (153 mm Ø) in a plasma is measured using electrical probes which are buried in, de-insulated from, and RF-connected to the electrode. The configuration of the probes allows to study the distribution of V_dc discretely on the electrode. The potential is homogeneous in the absence of external magnetic field. In the presence of a homogeneous magnetic field parallel to the electrode, it is reduced and a monotonous gradient takes place in its distribution due to the plasma shift induced by E × B drift. When the magnetic field is rotated along the axis of the RF-electrode at a frequency less than 50 Hz, the distribution, which is almost identical to the one in a static field, rotates with the magnetic field. On the coordinate system rotating with the magnetic field, the probes are regarded to be rotating. The potential distribution is obtained as a continuous function of the azimuthal angle. Thus the rotation of the field provides information for the experimental interpolation.     

A Fuzzy Expert System for Damage Assessment Using Genetic Algorithms and Neural Networks

Abstract: An efficient knowledge-acquisition support method is required for improvement and maintenance of the knowledge base in durability evaluation of an RC bridge deck. Such a method is proposed in this paper to automatically acquire fuzzy production rules. This method makes joint use of genetic algorithms and a neural network. Using a neural network as a subsystem, the evaluation function of genetic algorithms can be provided with the weights of the neural network. Introducing a neural network into genetic algorithms, it is possible to acquire new knowledge so that the method is useful when it is difficult to acquire knowledge in the field.     

Accumulation of amplified target DNAs using thiol/biotin labeling, S1 nuclease, and ferrocene-streptavidin-magnetic system and a direct detection of specific DNA signals with screen printed gold electrode

Combinations of PCR-based amplification platform using 5′ thiolated and biotinylated specific primers, S1 nuclease-PCR products treatment, ferrocene-streptavidin (Fc-Stv)-magnetic binding for DNA accumulation, and screen printed gold electrode for the DNA allocation, were applied to Hoechst 33258-induced DNA aggregation and signals induction system for direct signals detection and DNA quantification in food samples. Thiolated and biotinylated at each 5′ terminus enabled DNA purification through S1 nuclease treatment for primers and non-specific DNA elimination and enabled DNA trapping with a ferrocene-streptavidin-magnetic system. This facilitated the accumulation of target DNAs at higher concentration, resulting in enhanced signals. After allocation of DNA on the surface of gold electrode via thiol binding, intensity of DNA signals through these treatments could be measured directly after being induced by Hoechst 33258. Wider amplitude changes in anodic current peaks between negative and positive samples (increasing from 3.70 to 10.10 μA) compared with those applied with no treatment combinations (decreasing from 3.92 to 1.23 μA) were observed. This enhancement of the signals allowed a greater efficiency of DNA quantification. When this combination was used for GMOs content estimation in reference samples, results revealed an improved accuracy from 66% to 96%. The combined biosensor system, although more costly than the standard Hoechst 33258/carbon electrode system, provided an alternative choice for DNA quantification, offering labor-free immobilization of probe onto electrode surface, easy test administration, and efficient semi-quantitative test without expensive instruments.     

Yttria Doping and Sintering of Submicrometer-Grained α-Alumina

The sintering behavior of α-alumina powders doped with magnesia (500 or 1500 ppm) and yttria (0, 500, or 1500 ppm) was investigated using constant-heating-rate dilato-metric experiments. The apparent activation energies for the intermediate stage of sintering were 740, 800, and 870 kJ/mol for 0, 500, and 1500 ppm yttria doping levels, respectively; these were independent of magnesia doping. Yttria-doped powder compacts exhibited systematic anomalous second peaks in the densification rate curves at certain grain sizes which were determined only by yttria doping levels. Before the anomalous peak, with lower yttrium contents at grain boundaries, yttrium in an atomic state delays densification and raises the apparent activation energy. Beyond the peak, with higher yttrium contents at grain boundaries, yttria-rich precipitation delays the densification. Within the peak, yttrium segregation near the saturation level enhances densification.     

Functional activation of cerebral blood flow abolished by scopolamine is reversed by cognitive enhancers associated with cholinesterase inhibition: a positron emission tomography study in unanesthetized monkeys

The effects of somatosensory stimulation on the regional cerebral blood flow (rCBF) response were studied in unanesthetized monkeys before and after treatment with scopolamine and three cognitive enhancers (physostigmine, E2020 and tacrine) that inhibit cholinesterase, using 15O-labeled water and high-resolution positron emission tomography. Under control conditions, somatosensory stimulation induced a significant increase in the rCBF response in the contralateral somatosensory cortex of monkey brain. Intravenous administration of scopolamine (50 microg/kg) resulted in abolishment of the rCBF response to stimulation. The rCBF response abolished by pretreatment with scopolamine was recovered by administration of physostigmine (1 or 10 microg/kg), E2020 (10 or 100 microg/kg) or tacrine (100 or 1000 microg/kg), in a dose-dependent manner. The effect of E2020 (100 microg/kg) on the rCBF response lasted for >4 hr, whereas the effects of physostigmine and tacrine were of shorter duration. These findings suggest that these compounds reversed the scopolamine-abolished rCBF response to somatosensory stimulation via enhancement of cholinergic neurotransmission, which was mainly induced by cholinesterase inhibition.     

High-speed and large noise margin tolerance E/D logic gates withLDD structure DMTs fabricated using selective RIE technology

The authors describe a novel design concept for enhancement (E) and depletion (D) mode FET formation using i-AlGaAs/n-GaAs doped-channel hetero-MISFET (DMT) and a novel self-aligned gate process technology for submicrometer-gate DMT-LSIs based on E/D logic gates. 0.5-μm gate E-DMTs (D-DMTs) with a lightly doped drain (LDD) structure show an average V_t of 0.18 (-0.46) V, a V_t standard deviation of 22.6 (24.9) mV, and a maximum transconductance of 450 (300) mS/mm. The V_t shift is less than 50 mV with a decrease in gate length down to 0.5 μm. The gate forward turn-on voltage V_f is more than 0.9 V, i.e. about 1.6 times that for MESFETs. This superiority in V _f, preserved in the high-temperature range, leads to an improvement in noise margin tolerance by a factor of three. In addition, 31-stage ring oscillators operate with a power consumption of 20 (1.0) mW/gate and a propagation delay of 4.8 (14.5) ps/gate. Circuit simulation based on the experimental data predicts 140 ps/gate and 1 mW/gate for DMT direct-coupled FET logic circuits under standard loading conditions. DMTs and the technology developed here are very attractive for realizing low-power and/or high speed LSIs