Synthesis of thermoresponsive copolymer/silica-coated magnetite nanoparticle composite and its application for heavy metal ion recovery

To enhance chemical stability and suppress of aggregation of magnetite nanoparticles (MNPs), which are used as a support for thermoresponsive copolymer immobilization, silica coating of the MNPs is applied via the electrooxidation method. Although the resulting silica coated-MNPs also formed aggregates, the size distribution of the aggregate shifted to smaller size range. Because of that, the surface area available for copolymer immobilization increased approximately 6.7 times at maximum as compared with that of the uncoated MNPs. It contributed to the increase of the amount of the immobilized copolymer on the silica-coated MNPs, which is approximately four times larger than that on the uncoated MNPs. Fe₃O₄ dissolution test confirmed enhancement of chemical stability of MNPs. The thermoresponsive copolymer immobilized on the silica-coated MNPs shows the ability to recycle Cu(II) ion from Cu(II) containing solution by changing temperature with significantly shorter time than those in other thermoresponsive adsorbents in gel form.     

Operation of superconducting fault current limiter using vacuum interrupter driven by electromagnetic repulsion force for commutating switch

Using conventional high‐temperature superconducting wire, a model superconducting fault current limiter (SFCL) is made and tested. Solenoid coil using Bi2223 silver sheath wire is so made that inductance is as small as possible and a vacuum interrupter is connected in series to it. A conventional reactor coil is connected in parallel. When the fault current flows in this equipment, superconducting wire is quenched and current is transferred into the parallel coil because of voltage drop of superconducting wire. This large current in parallel coil actuates magnetic repulsion mechanism of vacuum interrupter. Due to opening of vacuum interrupter, the current in superconducting wire is broken. By using this equipment, current flow time in superconducting wire can be easily minimized. On the other hand, the fault current is also easily limited by large reactance of parallel coil. © 2008 Wiley Periodicals, Inc. Electr Eng Jpn, 164(1): 52–61, 2008; Published online in Wiley InterScience ( www.interscience.wiley.com ). DOI 10.1002/eej.20315     

Critical heat flux on a flat plate heater located at the middle of a duct in forced flow of pressurized He II

Critical heat fluxes (CHFs) were measured for two types of rectangular ducts containing horizontal flat plate heaters. One has the flat plate heater of 6 mm wide and 20 mm long located on the inner lower wall at 50 mm from the inlet. The other duct has two horizontal flat plates of 6 mm wide and 20 mm long on inner upper and lower walls at 50 mm from the inlet. The equation of CHF for the forced convection containing a new nondimensional-parameter m introduced in order to calculate cross-sectionally averaged liquid temperature at the center of the duct was derived based on two fluid model, ordinary convection theorem and experimental results. It was confirmed that this correlation can describe not only the author's data on the duct but also other worker's data for channels with different shapes and sizes.     

Rapid detection cytomegalovirus pneumonia in recipients of bone marrow transplant: evaluation and comparison of five survey methods for bronchoalveolar lavage fluid

To detect cytomegalovirus-associated interstitial pneumonia (CMV-IP) in recipients of BMT in its earliest stage, five CMV methods were assessed for their usefulness using bronchoalveolar lavage fluid as the test specimen. Of the 43 cases enrolled in the study, PCR was positive in 12 cases, shell vial in eight, culture in eight and cytology in three. There were no positive cases in in situ hybridization. Based on this result, the 43 cases were classified into four groups: Group 1, three cases: positive in PCR, shell vial and cytology; Group 2, five cases: positive in PCR and shell vial; Group 3, four cases: positive only in PCR; and Group 4, 31 cases: negative in all CMV tests. Cases in Group 1 were judged as having the highest risk of overt CMV-IP. They were successfully treated with a combination of ganciclovir and immunoglobulin. Group 2 was diagnosed as having active CMV infection and ganciclovir monotherapy was effective for these patients. Groups 3 and 4 were not given anti-CMV therapy, but they were free from CMV-related manifestations throughout the study. The sensitivity and specificity of each survey method for the detection of Groups 1 and 2 were 1.0 and 0.89 in PCR, 1.0 and 1.0 in shell vial, 0.88 and 1.0 in culture, and 0.38 and 1.0 in cytology. Similarly, the positive and negative predictive values were 0.67 and 1.0 in PCR, 1.0 and 1.0 in shell vial, 1.0 and 0.97 in culture, and 1.0 and 0.88 in cytology. Thus, CMV survey on bronchoalveolar fluid was thought to be useful in detecting post BMT CMV-IP in its earliest stage.     

Hepatitis GB virus C genome in the serum of aplastic anaemia patients receiving frequent blood transfusions

GB virus C (GBV-C) RNA was detected in five of 18 patients with aplastic anaemia who had received blood transfusions, whereas it was not detected in eight patients who had not received any transfusions. Antibody against hepatitis C virus (anti-HCV) was detected in nine patients in the transfusion group, compared with one of eight who had not received any transfusions. Therefore, the route of transmission of both GBV-C and HCV in these patients appeared to have been multiple blood transfusion. Since all of the GBV-C RNA-positive patients harboured anti-HCV, GBV-C seems to frequently superinfect with HCV. Neither GBV-C nor HCV is likely to have been a causative agent of the anaemia in the cases examined.     

A Fuzzy Expert System for Damage Assessment Using Genetic Algorithms and Neural Networks

Abstract: An efficient knowledge-acquisition support method is required for improvement and maintenance of the knowledge base in durability evaluation of an RC bridge deck. Such a method is proposed in this paper to automatically acquire fuzzy production rules. This method makes joint use of genetic algorithms and a neural network. Using a neural network as a subsystem, the evaluation function of genetic algorithms can be provided with the weights of the neural network. Introducing a neural network into genetic algorithms, it is possible to acquire new knowledge so that the method is useful when it is difficult to acquire knowledge in the field.     

Diffusion-controlled size-selective chloride ion sensing in the presence of bromide ion using a thin, nanoporous, plasma-polymerized coating on an Ag/AgCl electrode

We have developed a diffusion-controlled size-selective method for sensing chloride ion in the presence of bromide ion, based on a thin, nanoporous, plasma-polymerized coating of hexamethyldisiloxane on an Ag/AgCl electrode. Sub-nanometer-sized pores responsible for a highly cross-linked polymer network in the plasma-polymerized coating allowed diffusion-controlled permeation of chloride ion while blocking the larger bromide ion. An electrode coating of thickness greater than 70 nm enabled chloride detection in the concentration range 1-10 mM in the presence of 0.63 mM bromide ion. Advantages of this approach are: (1) simple design compared with ionophore-based strategies and (2) compatibility with microfabrication and mass production processes.     

Monte Carlo simulation of hydrogen absorption in palladium and palladium–silver alloys

A modified Monte Carlo (MC) simulation was performed to investigate the hydrogen absorption behavior in Pd and Pd–Ag alloys of the composition Pd_xAg_1−x (x=0.7–0.8) under H₂ pressure (0.1 MPa) at different temperatures. The present method employed can consider the dissociative adsorption of hydrogen molecule and the subsequent absorption of hydrogen atom by formalizing the relationship between the pressure of hydrogen molecule and hydrogen atom. The potential parameters were determined to reproduce the solution enthalpy of hydrogen in pure metals. The results are in good agreement with experimental findings as well as previous theoretical studies. We confirmed that our method is useful to simulate the absorption of hydrogen in metals and alloys.     

Westernized food habits and concentrations of serum lipids in the Japanese

It has recently been reported that there exists a new 'RING-finger' protein family among the zinc-finger (Zf) proteins. Previously, we had isolated the mouse Mel-18 cDNA (mMel-18) encoding the nuclear RING-finger protein that exhibits an ability to bind to a nonspecific DNA column. Here, we have isolated and characterized the human Mel-18 cDNA (hMel-18) using the mMel-18 cDNA as a probe. The deduced hMel-18 protein contains 344 amino acids (38 kDa) with a RING-finger motif, a helix-loop-helix (HLH)-like structure and a Pro/Ser-rich region. The hMel-18 gene is conserved among vertebrates. Its mRNA is highly expressed in placenta, lung and kidney, but the level is low in liver, pancreas and skeletal muscle. Using in situ hybridization, we mapped hMel-18 to band q22 of chromosome 12. It is possible that the Mel-18/bmi-1 gene family represents a mammalian homologue of the Drosophila polycomb gene group.