Effect of film thickness on hydrogen content in a-Si : H

The hydrogen content, its depth distribution, and its bonding configuration have been studied in hydrogenated amorphous silicon prepared by plasma-enhanced chemical vapor deposition with hydrogen-diluted silane. Nuclear reaction analysis and infrared spectroscopy were used to determine the total amount of hydrogen and its bonded component, respectively. It has been established that the total concentration of hydrogen does not depend on the film thickness, and has a uniform depth profile. The concentration of bonded hydrogen changes with the film thickness within the measurement accuracy. The data obtained suggest the presence of molecular (non-bonded) hydrogen, uniformly distributed in concentration across the film thickness.     

Continuous measurement of cardiac output by the Fick principle in infants and children: comparison with the thermodilution method

OBJECTIVE: To compare a system that continuously monitors cardiac output by the Fick principle with measurements by the thermodilution technique in pediatric patients. DESIGN: Prospective direct comparison of the above two techniques. SETTING: Pediatric intensive care unit of a university hospital. PATIENTS: 25 infants and children, aged 1 week to 17 years (median 10 months), who had undergone open heart surgery were studied. Only patients without an endotracheal tube leak and without a residual shunt were included. METHODS: The system based on the Fick principle uses measurements of oxygen consumption taken by a metabolic monitor and of arterial and mixed venous oxygen saturation taken by pulse- and fiberoptic oximetry to calculate cardiac output every 20s. INTERVENTIONS: In every patient one pair of measurements was taken. Continuous Fick and thermodilution cardiac output measurements were performed simultaneously, with the examiners remaining ignorant of the results of the other method. RESULTS: Cardiac output measurements ranged from 0.21 to 4.55 l/min. A good correlation coefficient was found: r2 = 0.98; P < 0.001; SEE = 0.41 l/min. The bias is absolute values and in percent of average cardiac output was - 0.05 l/min or - 4.4% with a precision of 0.32 l/min or 21.3% at 2 SD, respectively. The difference was most marked in a neonate with low cardiac output. CONCLUSION: Continuous measurement of cardiac output by the Fick principle offers a convenient method for the hemodynamic monitoring of unstable infants and children.     

„Patriot“

Ohne Zusammenfassung     

OC-48、OC-192芯片和系统设计师面临挑战

当今，从事OC-48、OC-192技术的设计师在设计基于因特网协议(IP协议)的下一代系统时，因系统含有诸如ASIC、网络处理器(NP)、高速跟踪器等元件，以及分组SONET物理层(PoS-PHY)接口规范等的演变，而一直面临挑战。抖动和扭斜失真等现象的存在给诸如系统分组接口第4层(SPI-4)和通用交换接口(CSIX)等总线结构本已拥挤的时序容限，以及四元数据率静态RAM传送表访问时间带来极大混乱。再加上诸如低压差分信号(LVDS)、高速收发逻辑和短线串行终端逻辑等超低电压峰-峰信号技术的引入，使数据出错的可能性变得异常之高。而利用仿真技…     

Meßtechnik zur Charakterisierung von Gas/Flüssigkeits-Reaktoren

Measuring techniques for characterizing gas/liquid reactors . The article considers measuring techniques for the characterization of the phases in gas/liquid reactors. These include the velocity profile and turbulence in the continuous phase as well as holdup, size, and velocity of the dispersed phase. Also, methods for the determination of the specific interfacial area and the volumetric mass transfer coefficients are discussed. Measuring methods have made enormous advances in recent years. In spite of this, there is a lack of reliable methods, especially for use during reactions without disturbing the state of the reactor. It is suspected that probe technique will gradually fall into disuse and more and more attention will be focussed on contractless methods. This calls for further development of ultrasonic methods and methods relying on emission of light.     

Thermal decoloration kinetics of spirooxazines in Ormocer coatings prepared via sol-gel processing

Two free and one silylated (silane-substituted) photochromic spirooxazines are doped into organically modified ceramics (Ormocer) coatings by sol-gel processing and the thermal decoloration kinetics of these coatings are investigated and compared with the corresponding ethanol solutions and PMMA coatings. The decoloration behaviour of the two free dyes (SO-1 and SO-2) in the Ormocer coatings is similar to that in ethanol solutions, obeying a first-order mechanism and possessing almost the same decoloration rates as in ethanol. This suggests that the dye molecules encapsulated within the pores of the solid matrix are as free as those in ethanol solutions. The silylated dye (SO-3) in the Ormocer coatings, however, exhibits a considerably lower decoloration rate than the corresponding free dye (SO-1) and evident deviation from the first-order mechanism. This indicates apparently that the degree of freedom of the dye molecules is reduced by the silylation. These results are discussed on the basis of solvent polarity, porous structure of the Ormocer coating, and the dye-to-matrix connectivity.