Matrix influence on the piezoelectric properties of piezoelectric ceramic/polymer composite exhibiting particle alignment

This study was addressed to the influence of an electric field strength applied at fabrication process and matrix properties, such as the dielectric constant and the Young's modulus, on “pseudo‐1‐3 piezoelectric ceramic/polymer composite” in order to further enhance the piezoelectricity of that. The pseudo‐1‐3 piezoelectric ceramic/polymer composite consists of linearly ordered piezoelectric ceramic particles in polymer material. Silicone gel, silicone rubber, urethane rubber, and poly‐methyl‐methacrylate, which exhibit different dielectric constants and Young's modulus, were used as matrices to evaluate the matrix influence. The piezoelectricity of the pseudo‐1‐3 piezoelectric ceramic/polymer composite was evaluated using the piezoelectric strain constant d₃₃. The d₃₃ is one of the indices of the piezoelectric properties for piezoelectric materials. As a result, it was confirmed that d₃₃ of the pseudo‐1‐3 piezoelectric ceramic/polymer composite increased with the increase of the electric filed strength applied at fabrication process, though, it reached a constant value at a certain strength value. Further it was confirmed that dielectric constant of the matrix had a small influence on d₃₃ of the pseudo‐1‐3 piezoelectric ceramic/polymer composite, however, in case of matrix of lower Young's modulus, d₃₃ was increase. © 2014 Wiley Periodicals, Inc. J. Appl. Polym. Sci. 2015 , 132, 41817.     

Unperturbed dimension of poly(4-acetoxystyrene) measured in good and theta solvents

In order to obtain the additional data concerning the unperturbed dimension of poly-4-substituted styrene, light scattering measurements are performed on the twenty-two fractions with molecular weight of (0.91–352)·10⁴ of poly(4-acetoxystyrene) in dioxan at 25°C, from which the molecular weight obtained was found easily to be evaluated with the gel permeation chromatography using THF. Phase separation experiments for this polymer indicate that the theta state is attained in isopropyl acetate at 19.7°C and butyl acetate at 26.8°C. By making viscosity measurements at that state, the value of K_Θ is directly evaluated as 5.4·10^?4 dl g^?1. The limiting viscosity number is also obtained in good solvents, THF and dioxan, at 25°C and constants of the Mark-Houwink-Sakurada equation in each solvent are determined. Further, approximately the same K_Θ as above is obtained from these data with the Stockmayer-Fixman plot. The calculated value of steric factor, 2.37, on this polymer may be plausible, compared with those of polyvinylaromatic derivatives.     

Extensions of polyacrylic acid ammonium salts in the adsorption layer to fluidize alumina slurries

An average shell volume occupied in the adsorption layer on alumina by a polyacrylic acid ammonium salts molecule (PAA) defined as the average area occupied by an adsorbed PAA on alumina multiplied by the average thickness of the water layer at the limit of thickening, has been calculated from the adsorbed amount of PAA and from the flow points of alumina in the presence of PAA of different molecular weights. A steric effect of the PAA dispersant on the dispersion of alumina resulted in a flow with no yield stress. This was due to the change of the extension of PAA in the adsorption shell from a sphere to an ellipsoid with a long axis which exceeded the effective distance that the van der Waals attraction force reaches at a molecular weight for the PAA of between 10 000–20 000.     

Preparation of poly(p-phenylene terephthalamide)/poly(vinyl chloride) molecular composite and its thermal and mechanical properties

Poly(p-phenylene terephthalamide) (PPTA) was blended with poly(vinyl chloride) (PVC) by solution-blending method. PPTA was metalated for dissolving in dimethyl sulfoxide. Dimethyl sulfoxide was used as a common solvent. In PPTA/PVC composite, PPTA accelerated the thermal degradation of PVC. PPTA molecules are aggregated as microfibrillar form in PVC matrix. Such microfibrils are dispersed homogeneously in PVC matrix, according to polarizing microscopic observation. The average diameter of the microfibrils becomes smaller in the composite with lower content of PPTA. In the surface region of PPTA microfibrils the intermolecular hydrogen bonds between C? Cl of PVC and N? H of PPTA are formed. Young's modulus and the yield stress at room temperature were higher in the composites than those in PVC. The modulus of the composites was higher, especially at the high temperatures above their glass transition temperatures, than that in PVC. The temperature dependence of modulus can be calculated by using the mechanical model equivalent to the quasi-3-dimensional microfibrillar model which will be approximately applied to the composite structure. It becomes apparent that the modulus of the PPTA microfibrils evaluated by using the mechanical model is higher in the higher molecular weight PPTA.     

Interactions oftrans-cinnamic acid,its related phenolic allelochemicals,and abscisic acid in seedling growth and seed germination of lettuce

Phenolic compounds have been identified as the most common allelochemicals produced by higher plants. Inhibitions of cinnamic acid, its related phenolic derivatives, and abscisic acid (ABA) on seedling growth and seed germination of lettuce were studied.trans-Cinnamic acid, ando-,m-, andp-coumaric acids inhibited the growth of etiolated seedlings of lettuce at concentrations higher than 10^–4 M and seed germination above 10^–3 M. Coumarin inhibited seedling growth and seed germination at 10^–5 M or above. Chlorogenic acid inhibited seedling growth above 10^–4 M, but did not inhibit seed germination at 10^–5–5×10^–3 M. Low concentrations (below 10^–3 M) of caffeic and ferulic acids promoted the elongation of hypocotyls, but higher concentrations (over 10^–3 M) inhibited seedling growth and seed germination. These phenolic compounds and abscisic acid had additive inhibitory effects both on seedling growth and seed germination. The inhibition on lettuce was reversed by caffeic and ferulic acids at concentrations lower than 10^–3 M except for the inhibition of germination by coumarin. These results suggest that in naturetrans-cinnamic acid,o-, m-, p-coumaric acids, coumarin, and chlorogenic acid inhibit plant growth regardless of their concentration. However, caffeic and ferulic acids can either promote or inhibit plant growth according to their concentration.     

Lamellar thickening behaviour of nylon-6,6 crystal by annealing

Nylon-6,6 — a typical polyamide — was annealed in the swollen state in glycerol to promote the partial melting of the polymer crystal. The recrystallization or lamellar thickening of nylon-6,6 crystal following partial melting was easily induced by this annealing, and the lamellar thickness of the crystal increased stepwise by $\text{1}\text{2}$ monomer unit length with increasing annealing temperature or annealing time. In addition, another distinct layer-thickening mechanism was observed which led to approximately doubling (and frequently quadrupling) the straight stem length of the lamellar crystal for all samples annealed under adequate conditions. New melting endotherms corresponding to these layer thicknesses (range of long spacings 140–180Å) were obtained by differential scanning calorimetry (d.s.c.) at temperatures ranging from 270° to 282°C. The mechanism of lamellar thickening is discussed with reference to the experimental results.     

Repeatedly foldable AMOLED display

In this study, a 5.9‐inch foldable active‐matrix organic light emitting diode (AMOLED) display was developed. A folding test was performed repeatedly. The display survived the folding test (100,000 folds) with a curvature radius of 2 mm. To protect an organic light emitting diode (OLED) against moisture, inorganic passivation layers are provided on the upper and lower sides of the flexible display. Using our transfer technology, high density passivation layers can be obtained. The measured water vapor transmission rate of the layer is 7 × 10^?6 g/m²?day or less, which improves OLED reliability. With these techniques, we have developed a book‐type display, which is repeatedly foldable like a book, and a tri‐fold display including a display area, which is foldable in three.     

Basic study about cooperative movement between a human and an agent with entrainment

The use of an agent in the environment, as in medical treatment, welfare, the construction field, and the home, is examined. It is necessary for the agent to be able to work cooperatively with a human, and that may be a problem. Therefore, this study pays attention to the phenomenon that is called entrainment. This is the phenomenon where the rhythm of a certain person and the partner in the communication is synchronized. The purpose of this study is to perform a basic examination into applying an entrainment in order to realize cooperation in operations between a human and an agent. Since many human rhythms are expressed by a nonlinear oscillator, we simulated limited cycle oscillators, which are one of two nonlinear oscillators that cause interactions between agents, as the basic examination for this achievement. Consequently, entrainment of limited cycle oscillators with rhythms which differ has been checked in certain conditions. As a result, the possibility that cooperative movement could be gained was suggested.     

Role of electron-phonon interaction in lattice dynamics and superconductivity of oxide spinel LiTi2O4

The lattice dynamics of an oxide spinel LiTi₂O₄ is studied by taking account of the electron-phonon (EP) interaction derived on the basis of the realistic tight-binding bands fitted to the first-principles bands. Due to the characteristic dependences of the EP interaction on wavevectors and vibrational modes, a remarkable frequency renormalization of the O vibrational modes, which hybridize with the Ti vibrational modes, is obtained over a wide region of the Brillouin zone. The overall features of the calculated phonon density of states are in agreement with those observed by the inelastic neutron scattering measurements. By using the EP interaction and the renormalized phonon frequencies we have calculated the EP spectral function ² F(). The superconducting transition temperature, gap function, and tunneling spectra are calculated by solving the Éliashberg equation. The results agree well with the observations.